Detector (radio)

Detector (radio)
Passband modulation v · d · e
Analog modulation
AM · SSB · QAM · FM · PM · SM
Digital modulation
Spread spectrum
See also: Demodulation, modem,
line coding, PAM, PWM, PCM

A detector is a device that recovers information of interest contained in a modulated wave. The term dates from the early days of radio when all transmissions were in Morse code, and it was only necessary to detect the presence (or absence) of a radio wave using a device such as a coherer without necessarily making it audible. A more up-to-date term is demodulator, but "detector" has a history of many decades of use, even if it is a misnomer.

A coherer detector, useful only for Morse code signals.


Amplitude modulation detectors

Envelope detector

A simple envelope detector

One major technique is known as envelope detection. The simplest form of envelope detector is the diode detector that consists of a diode connected between the input and output of the circuit, with a resistor and capacitor in parallel from the output of the circuit to the ground. If the resistor and capacitor are correctly chosen, the output of this circuit will approximate a voltage-shifted version of the original signal.

An early form of envelope detector was the cat's whisker, which was used in the crystal set radio receiver.

Product detector

A product detector is a type of demodulator used for AM and SSB signals. Rather than converting the envelope of the signal into the decoded waveform like an envelope detector, the product detector takes the product of the modulated signal and a local oscillator, hence the name. At least partially, it multiplies the signal by the output of the local oscillator. This can be accomplished by heterodyning. The received signal is mixed, in some type of nonlinear device, with a signal from the local oscillator, to produce an intermediate frequency, referred to as the beat frequency, from which the modulating signal is detected and recovered.

Frequency and phase modulation detectors

AM detectors cannot demodulate FM and PM signals because both have a constant amplitude. However an AM radio may detect the sound of an FM broadcast by the phenomenon of slope detection which occurs when the radio is tuned slightly above or below the nominal broadcast frequency. Frequency variation on one sloping side of the radio tuning curve gives the amplified signal a corresponding local amplitude variation, to which the AM detector is sensitive. Slope detection gives inferior distortion and noise rejection compared to the following dedicated FM detectors that are normally used.

Phase detector

A phase detector is a nonlinear device whose output represents the phase difference between the two oscillating input signals. It has two inputs and one output: a reference signal is applied to one input and the phase or frequency modulated signal is applied to the other. The output is a signal that is proportional to the phase difference between the two inputs.

In phase demodulation the information is contained in the amount and rate of phase shift in the carrier wave.

The Foster-Seeley discriminator

The Foster-Seeley discriminator[1][2] is a widely used FM detector. The detector consists of a special center-tapped transformer feeding two diodes in a full wave DC rectifier circuit. When the input transformer is tuned to the signal frequency, the output of the discriminator is zero. When there is no deviation of the carrier, both halves of the center tapped transformer are balanced. As the FM signal swings in frequency above and below the carrier frequency, the balance between the two halves of the center-tapped secondary is destroyed and there is an output voltage proportional to the frequency deviation.

Ratio detector

A ratio detector using solid-state diodes

The ratio detector[3][4][5][6] is a variant of the Foster-Seeley discriminator, but one diode conducts in an opposite direction. The output in this case is taken between the sum of the diode voltages and the center tap. The output across the diodes is connected to a large value capacitor, which eliminates AM noise in the ratio detector output. While distinct from the Foster-Seeley discriminator, the ratio detector will similarly not respond to AM signals, however the output is only 50% of the output of a discriminator for the same input signal.

Quadrature detector

In quadrature detectors, the received FM signal is split into two signals. One of the two signals is then passed through a high-reactance capacitor, which shifts the phase of that signal by 90 degrees. This phase-shifted signal is then applied to an LC circuit, which is resonant at the FM signal's unmodulated, "center," or "carrier" frequency. If the received FM signal's frequency equals the center frequency, then the two signals will have a 90-degree phase difference and they are said to be in "phase quadrature" — hence the name of this method. The two signals are then multiplied together in an analog or digital device, which serves as a phase detector; that is, a device whose output is proportional to the phase difference between two signals. In the case of an unmodulated FM signal, the phase detector's output is — after the output has been filtered; that is, averaged over time — constant; namely, zero. However, if the received FM signal has been modulated, then its frequency will vary from the center frequency. In this case, the resonant LC circuit will further shift the phase of the signal from the capacitor, so that the signal's total phase shift will be the sum of the 90 degrees that's imposed by the capacitor and the positive or negative phase change that's imposed by the LC circuit. Now the output from the phase detector will differ from zero, and in this way, one recovers the original signal that was used to modulate the FM carrier.

This detection process can also be accomplished by combining, in an exclusive-OR (XOR) logic gate, the original FM signal and a square wave whose frequency equals the FM signal's center frequency. The XOR gate produces an output pulse whose duration equals the difference between the times at which the square wave and the received FM signal pass through zero volts. As the FM signal's frequency varies from its unmodulated center frequency (which is also the frequency of the square wave), the output pulses from the XOR gate become longer or shorter. (In essence, this quadrature detector converts an FM signal into a pulse-width modulated (PWM) signal.) When these pulses are filtered, the filter's output rises as the pulses grow longer and its output falls as the pulses grow shorter. In this way, one recovers the original signal that was used to modulate the FM carrier.

Other FM detectors

Less common, specialized, or obsolescent types of detectors include [7]:

  • Travis[8] or double tuned circuit discriminator using two non-interacting tuned circuits above and below the nominal center frequency
  • Weiss discriminator which uses a single LC tuned circuit or crystal
  • Pulse count discriminator which converts the frequency to a train of constant amplitude pulses, producing a voltage directly proportional to the frequency.

Phase-locked loop detector

The phase-locked loop detector requires no frequency-selective LC network to accomplish demodulation. In this system, a voltage controlled oscillator (VCO) is phase locked by a feedback loop, which forces the VCO to follow the frequency variations of the incoming FM signal. The low-frequency error voltage that forces the VCO's frequency to track the frequency of the modulated FM signal is the demodulated audio output.

See also


  1. ^ US 2121103, Seeley, Stuart W., "Frequency Variation Response Circuits", issued June 21, 1938 
  2. ^ Foster, D. E.; Seeley, S. W. (March 1937), "Automatic tuning, simplified circuits, and design practice", Proceedings of the Institute of Radio Engineers 25 (3): 289–313 , part 1.
  3. ^ US 2497840, Seeley, Stuart William, "Angle Modulation Detector", issued February 14, 1950 
  4. ^ US 2561089, Anderson, Earl I., issued July 17, 1951 
  5. ^ Report L.B.-645: "Ratio detectors for FM receivers" (15 September 1945) issued by the Radio Corporation of America, RCA Laboratories Industry Service Division, 711 Fifth Avenue, N.Y., N.Y. Reprinted in Radio, pages 18-20 (October 1945).
  6. ^ Seeley, Stuart W.; Avins, Jack (June 1947), "The ratio detector", RCA Review 8 (2): 201–236 
  7. ^ D. S. Evans and G. R. Jessup, VHF-UHF Manual (3rd Edition), Radio Society of Great Britain,London, 1976 pages 4-48 through 4-51
  8. ^ Charles Travis, "Automatic oscillator frequency control system" U.S. patent: 2,294,100 (filed: 4 February 1935; issued: August 1942). See also: Charles Travis, "Automatic frequency control," Proceedings of the Institute of Radio Engineers, vol. 23, no. 10, pages 1125-1141 (October 1935).

External links

Simple block diagrams and descriptions of key circuits for FM transmitters and receivers: [1]

Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать реферат

Look at other dictionaries:

  • Plate detector (radio) — A plate detector is a vacuum tube detector circuit used in A.M. radios. This circuit employs a tube with an indirectly heated cathode, typically a medium mu triode, or a tetrode or pentode with a sharp cut off control grid. Rectification of R.F.… …   Wikipedia

  • Detector (disambiguation) — A detector is a device capable of registering a specific substance or physical phenomenon. Detector may also refer to: Detector (radio), a device that recovers information from a modulated wave Detector (film), a 2000 Norwegian film USS Detector …   Wikipedia

  • Detector de radar — Saltar a navegación, búsqueda Uno de los primeros modelos de detector de radar Un detector de radar, es un dispositivo pasivo electrónico usado por conductores de vehículos para saber si su velocidad está siendo monitoreada por inspectores con… …   Wikipedia Español

  • Radio — is the transmission of signals, by modulation of electromagnetic waves with frequencies below those of visible light.Electromagnetic radiation travels by means of oscillating electromagnetic fields that pass through the air and the vacuum of… …   Wikipedia

  • Detector de bigotes de gato — Saltar a navegación, búsqueda Detector de bigotes de gato …   Wikipedia Español

  • Radio receiver design — is a complex topic which can be broken down into a series of smaller topics. A radio communication system requires two tuned circuits each at the transmitter and receiver, all four tuned to the same frequency. [Cheney, M., Uth, R., Glenn, J.… …   Wikipedia

  • Radio a galena — Saltar a navegación, búsqueda Una radio a galena es un receptor de radio que emplea un cristal semiconductor de sulfuro de plomo, también llamado galena para captar las señales de radio de AM, FM u Onda Corta. Este receptor de radio, cuyo esquema …   Wikipedia Español

  • Radio cognitiva — Saltar a navegación, búsqueda La Radio cognitiva es un paradigma de la comunicación inalámbrica en la cual tanto las redes como los mismos nodos inalámbricos cambian los parámetros particulares de transmisión o de recepción para ejecutar su… …   Wikipedia Español

  • Detector de rayos — Saltar a navegación, búsqueda Detector de rayos en el Centro Espacial Kennedy, Florida Un detector de rayos es un aparato que detecta los relámpagos o rayos de luz producidos por tormentas. Hay tres tipos básicos de detectores: sistema terrestre …   Wikipedia Español

  • Radio Day — (Russian: День радио Den Radio), Communications Workers Day (as it is officially known in Russia) or Radio and Television Day (Ден на радиото и телевизията, as it is known in Bulgaria) is a commemoration of the development of radio in Russia. It… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”