- Electrical network
An electrical network is an interconnection of electrical elements such as resistors, inductors, capacitors, transmission lines, voltage sources, current sources and switches. An electrical circuit is a special type of network, one that has a closed loop giving a return path for the current. Electrical networks that consist only of sources (voltage or current), linear lumped elements (resistors, capacitors, inductors), and linear distributed elements (transmission lines) can be analyzed by algebraic and transform methods to determine DC response, AC response, and transient response.
Linear Network Analysis Elements Components Series and parallel circuits Impedance transforms Generator theorems Network theorems Network analysis methods Two-port parameters
To design any electrical circuit, either analog or digital, electrical engineers need to be able to predict the voltages and currents at all places within the circuit. Linear circuits, that is, circuits with the same input and output frequency, can be analyzed by hand using complex number theory. Other circuits can only be analyzed with specialized software programs or estimation techniques such as the piecewise-linear model.
Circuit simulation software, such as HSPICE, and languages such as VHDL-AMS and verilog-AMS allow engineers to design circuits without the time, cost and risk of error involved in building circuit prototypes.
A number of electrical laws apply to all electrical networks. These include:
- Kirchhoff's current law: The sum of all currents entering a node is equal to the sum of all currents leaving the node.
- Kirchhoff's voltage law: The directed sum of the electrical potential differences around a loop must be zero.
- Ohm's law: The voltage across a resistor is equal to the product of the resistance and the current flowing through it.
- Norton's theorem: Any network of voltage and/or current sources and resistors is electrically equivalent to an ideal current source in parallel with a single resistor.
- Thévenin's theorem: Any network of voltage and/or current sources and resistors is electrically equivalent to a single voltage source in series with a single resistor.
- See also Analysis of resistive circuits.
Other more complex laws may be needed if the network contains nonlinear or reactive components. Non-linear self-regenerative heterodyning systems can be approximated. Applying these laws results in a set of simultaneous equations that can be solved either algebraically or numerically.
Network simulation software
Linearization around operating point
When faced with a new circuit, the software first tries to find a steady state solution, that is, one where all nodes conform to Kirchhoff's Current Law and the voltages across and through each element of the circuit conform to the voltage/current equations governing that element.
Once the steady state solution is found, the operating points of each element in the circuit are known. For a small signal analysis, every non-linear element can be linearized around its operation point to obtain the small-signal estimate of the voltages and currents. This is an application of Ohm's Law. The resulting linear circuit matrix can be solved with Gaussian elimination.
Software such as the PLECS interface to Simulink uses piecewise-linear approximation of the equations governing the elements of a circuit. The circuit is treated as a completely linear network of ideal diodes. Every time a diode switches from on to off or vice versa, the configuration of the linear network changes. Adding more detail to the approximation of equations increases the accuracy of the simulation, but also increases its running time.
- Analysis of resistive circuits
- Alternating current
- Bridge circuit
- Digital circuit
- Circuit diagram
- Circuit theory
- Diode bridge
- Direct current
- Quiescent current
- Ground (electricity)
- Hydraulic analogy
- Mathematical methods in electronics
- Network analyzer (electrical)
- Network analysis (electrical circuits)
- RC circuit
- LC circuit
- RLC circuit
- Lumped and distributed element model
- Potential divider
- Prototype filter
- Series and parallel circuits
- Superposition theorem
- Topology (electronics)
- Continuity test
- Voltage drop
- Mesh analysis
Wikimedia Foundation. 2010.