Chief Mechanical Engineer

Chief Mechanical Engineer

Chief Mechanical Engineer and Locomotive Superintendent are titles applied by British, Australian, and New Zealand railway companies to the person ultimately responsible to the board of the company for the building and maintaining of the locomotives and rolling stock. In Britain, the post of locomotive superintendent was introduced in the late 1830s, and chief mechanical engineer in 1886.

Contents

Emerging professional roles

In the early Victorian era, projected canal or railway schemes were prepared by groups of promoters who hired specialists such as civil engineers, surveyors, architects or contractors to survey a route; and this resulted in the issue of a prospectus setting out their proposals.[1] Provided that adequate capital could be raised from potential investors, agreements obtained from the landowners along the proposed route and, in Britain, an Act of Parliament obtained (different terminology is used in other countries), then construction might begin either by a new company specially formed to build and run it or by an existing company.[1]

Design, construction and day to day operation of the canal or railway was managed by men who might otherwise work for the promoters. Some of the pioneer railway builders were self-taught, but others had gained their engineering experience constructing canals, or in military service. In Britain, the Institution of Civil Engineers had been founded in London in 1818, with Thomas Telford as its first president and its formation pre-dated many of the railway schemes.[2] It obtained a Royal Charter in 1828.[3] Later, the Institution of Mechanical Engineers was formed in 1847, with George Stephenson as its first president.[2] The Corps of Royal Engineers, a British military organisation, was older than both of these civilian engineering institutions and it had extensive experience of (military) railway operations. For this reason, for almost 150 years from its foundation by the Board of Trade in 1840, Her Majesty's Railway Inspectorate recruited suitably qualified retired officers from the Corps into its "senior" arm, as railway inspecting officers.[4][5] These officers retained their former military rank within the Inspectorate.[5] It was to be 1985 before a railway inspecting officer without a previous military career was appointed: the officer transferred across from the "junior" arm: as a former railway employment inspector.[5] Over the same period, of almost a century and a half, the Inspectorate was headed by a retired officer of the Corps of Royal Engineers as its chief inspecting officer.[4] Other, former army officers, such as Charles Blacker Vignoles, were to gain new careers on the railways when they became under-employed after the Napoleonic War.[6]

In Britain, the various railway companies appointed and employed an engineer or chief engineer, who was usually a civil engineer by profession.[7] This was a permanent management role in the company in contrast to that of contractors, for instance, who were only hired to perform specific tasks such as construction of the line. The chief engineer had his own department (and budget) and was an important company official.[7] The chief engineer was responsible for all engineering functions: civil, which included bridges, viaducts, tunnels and track; and, later, mechanical, which included rolling stock. In some early railways, such as the Liverpool and Manchester Railway (L&MR), which opened in 1830, there was indecision on whether to use fixed engines and ropes or moving locomotives. Cases had arisen of locomotives being too heavy and breaking the cast iron rails that they had to run on; and locomotive wheels breaking and/or falling off. Finally, the L&MR's board agreed the use of moving locomotives; and the rolling stock was selected from various specialist builders by competition, at the Rainhill Trials.[8] Soon afterwards, many railway companies were to set up their own railway workshops, although railway companies continued to buy-in locomotives from specialist manufacturers, such as Robert Stephenson and Company which was founded by George and Robert Stephenson in 1828. Some railway companies operated their own ferries, boats, and ships and these would also be the responsibility of their Chief Engineer, but they would have been ordered from shipyards. Isambard Kingdom Brunel set an example, designing three great steamships: the SS Great Western, the SS Great Britain and the SS Great Eastern – the first two being built at Bristol shipyards and the third at Millwall, London. The Institute of Engineers and Shipbuilders in Scotland was formed in 1857 as a professional body for these trades in Scotland.[2]

The specialism of mechanical engineering became established on the railways, with an emphasis on moving parts; and, in terms of importance, this was concerned with designing and building of reliable locomotives, carriages and waggons. Private companies designed and built these items to order and could offer standard designs to railway companies as well as "specials" to meet specific customer's requirements;[9] otherwise railway companies could and did establish workshops to build their own locomotives and carriages. In August 1837, for example, Isambard Kingdom Brunel, the Engineer responsible for the Great Western Railway, appointed Daniel Gooch locomotive superintendent to the company; and it was his responsibility to provide the locomotives, the accommodation for them and the running and the repair shops.[10] Gooch suggested a green field site, New Swindon, and this was to lead to the building of a railway works, a railway village and eventually the town of Swindon.[11] Swindon was not the only example of railway town or community that was created in England: Crewe being another.

Locomotive superintendent

Initially, where a railway company choose to build its own rolling stock in house, the mechanical engineering aspect was regarded as a subsidiary function to that of the chief engineer and this was reflected in various job titles, such as chief of locomotive department, locomotive foreman and locomotive superintendent.[12]

Later, there was a desire to improve the prestige, and salary, of the locomotive superintendent and a means of achieving those aims was to seek to regrade the post as chief mechanical engineer (CME).[7] John Aspinall of the Lancashire and Yorkshire Railway was the first CME to be appointed to that post in 1886.[7] A further six British railway companies created the post of CME between 1902 and 1914.[7]

Functions

The chief mechanical engineer was responsible for all aspects of locomotives and that included their design, testing and modification of existing designs.

The early mechanical engineer was concerned with mechanical moving parts and for many years this responsibility also included railway signalling, particularly points and semaphore signals, as these were entirely mechanically operated. With the introduction of low-power electricity to the railways, various new systems such as telegraphs, telephones and electrical signalling systems were introduced; and responsibilities of these systems were transferred to the signal and telegraph (S&T) department.

Prominent examples

See also

References

  1. ^ a b Biddle, Gordon (1990). "Chapter 2: Promoting a Railway". The Railway Surveyors: The Story of Railway Property Management 1800-1990. London: Ian Allan Ltd. pp. 27-43. ISBN 0-7110-1954-1. 
  2. ^ a b c Simmons, Jack (1995). The Victorian Railway (1st Paperback ed.). London: Thames & Hudson Ltd. pp. 102-109. ISBN 978-0-500-28810-8. 
  3. ^ Simmons, Jack; Biddle, Gordon (1997). The Oxford Companion to British Railway History From 1603 to the 1990s (1st Ed. ed.). Oxford: Oxford University Press. p. 225. ISBN 0-19-211697-5. 
  4. ^ a b Hall, Stanley (1990). Railway Detectives: The 150-year Saga of the Railway Inspectorate. London: Ian Allan Ltd. pp. 9-10. ISBN 0-7110-1929-0. 
  5. ^ a b c Hutter, Bridget M. (1997). Compliance: Regulation and Environment. Oxford Socio-Legal Studies. Oxford: Oxford University Press. p. 49. ISBN 0-19-826475-5. 
  6. ^ Biddle, Gordon (1990). The Railway Surveyors: The Story of Railway Property Management 1800-1990. London: Ian Allan Ltd. p. 59. ISBN 0-7110-1954-1. 
  7. ^ a b c d e Simmons, Jack (1995). The Victorian Railway (1st Paperback ed.). London: Thames & Hudson Ltd. pp. 112–114. ISBN 978-0-500-28810-8. 
  8. ^ Simmons, Jack; Biddle, Gordon (1997). The Oxford Companion to British Railway History From 1603 to the 1990s (1st Ed. ed.). Oxford: Oxford University Press. pp. 415–416. ISBN 0-19-211697-5. 
  9. ^ Owen, Roy (1996). Norwegian Railways: from Stephenson to high-speed. Hitchin: Balholm Press. pp. 177-183. ISBN 0-9528069-0-8. 
  10. ^ Cattell, John; Falconer, Keith (1995). Swindon: The Legacy of a Railway Town. London: (Royal Commission on the Historical Monuments of England) HMSO. pp. 4-5. ISBN 0-11-300053-7. 
  11. ^ Cattell, John; Falconer, Keith (1995). "Chapter 1: 'Furze, Rushes and Rowen - a greenfield site". Swindon: The Legacy of a Railway Town. London: (Royal Commission on the Historical Monuments of England) HMSO. pp. 1-15. ISBN 0-11-300053-7. 
  12. ^ Simmons, Jack; Biddle, Gordon (1997). The Oxford Companion to British Railway History From 1603 to the 1990s (1st Ed. ed.). Oxford: Oxford University Press. pp. 317–318. ISBN 0-19-211697-5. 
  13. ^ a b c d e f g h i j k Lowe, James W. (1975). British Steam Locomotive Builders. Cambridge: Goose and Son. ISBN 0 900404 21 3. 
  14. ^ "Oliver Vaughan Snell Bulleid". January 4, 2011. http://www.steamindex.com/people/bulleid.htm. Retrieved September 5, 2011. 
  15. ^ Marsden, Richard (2011). "Oliver Bulleid". The London & North Eastern Railway (LNER) Encyclopedia. Winwaed Software Technology LLC. http://www.lner.info/eng/bulleid.shtml. Retrieved September 5, 2011. 
  16. ^ a b "Oliver Vaughn Snell Bulleid, CBE 1882–1970". 34058 – Sir Frederick Pile. http://www.34058.co.uk/Oliver%20Bulleid.htm. Retrieved September 5, 2011. 
  17. ^ Herring, Peter (2004). Yesterday's Railways. David & Herring. p. 172. ISBN 0715317334. http://books.google.com/books?id=sqBIcQ8D_foC. 
  18. ^ "George Jackson Churchward". SwindonWeb. http://www.swindonweb.com/index.asp?m=8&s=9&ss=269. Retrieved September 5, 2011. 
  19. ^ Bryan, Tim (2010). The Great Western Railway. Shire Publications. p. 23. ISBN 0747807884. http://books.google.com/books?id=PaUO2yobbtoC. 

Wikimedia Foundation. 2010.

Игры ⚽ Нужно сделать НИР?

Look at other dictionaries:

  • List of Chief Mechanical Engineers of the Great Western Railway — Great Western Railway= Locomotive Superintendent * Daniel Gooch (1837 1864) * Joseph Armstrong (1864 1877) * William Dean (1877 1902) * George Jackson Churchward (1902 1915)Chief Mechanical Engineer * George Jackson Churchward (1915 1921) *… …   Wikipedia

  • engineer — {{Roman}}I.{{/Roman}} noun 1 designs/builds engines, roads, etc. ADJECTIVE ▪ chief ▪ chartered (BrE), qualified, skilled, trained ▪ You need the advice of a qualified engineer …   Collocations dictionary

  • Institution of Mechanical Engineers — Founder George Stephenson Professional title Chartered Mechanical Engineer Founded 27 January 1847 (1847 01 27) …   Wikipedia

  • John Aspinall (engineer) — Infobox Engineer image size = 150px caption = name = John Aspinall nationality = birth date = 25 August 1851 birth place = death date = Death date and age|1937|1|19|1851|8|25|df=y death place = education = spouse = parents = children = discipline …   Wikipedia

  • Indian Railway Service of Mechanical Engineers — The Indian Railway Service of Mechanical Engineering (IRSME) is a cadre of the Government of India. The officers of this service are responsible for managing the Mechanical Engineering Organisation of the Indian RailwaysRecruitmentThe recruitment …   Wikipedia

  • Henry Fowler (engineer) — Sir Henry Fowler (July 29 1870–October 16 1938) was a Chief Mechanical Engineer of the Midland Railway and subsequently the London, Midland and Scottish Railway. Biography Fowler was born in Evesham, Worcestershire, on July 29 1870. His father,… …   Wikipedia

  • James Anderson (engineer) — James Edward Anderson, CBE (3 April 1871 mdash; 15 January 1945) was a mechanical engineer of the Midland Railway and later the London, Midland and Scottish Railway and had a great influence on the latter s adoption of the former s unwise… …   Wikipedia

  • Edward Thompson (engineer) — Edward Thompson (1881 1954) was Chief Mechanical Engineer of the London and North Eastern Railway between 1941 and 1946. Biography Edward Thompson came from an academic background having taken Mechanical Science Tripos at Pembroke College,… …   Wikipedia

  • Locomotive engineer — This article gives UK usage. For US usage see Railroad engineer A Locomotive engineer is a person who designs, builds or repairs locomotives. William Adams is an example.ee also* Chief Mechanical Engineer * Mechanical engineering …   Wikipedia

  • Harry Pollitt (engineer) — Harry Pollitt was Locomotive Engineer of the Manchester, Sheffield and Lincolnshire Railway from 1893 1897 and its successor, the Great Central Railway, from 1897 1900.He personally saw off the first Great Central passenger service from… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”