Antenna analyzer

Antenna analyzer
An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ Enterprises Inc. MFJ-269.

An antenna analyzer (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the efficiency of antenna systems in radio electronics applications.

Contents

Theory of operation

The antenna analyzer is essentially a bridge where two legs are frequency-dependent complex-valued impedances by impedance matching these legs. When the two impedances are the same the bridge will be balanced. Using this circuit it is possible to either measure the impedance of the antenna connected between ANT and GND, or it is possible to adjust an antenna until it has the same impedance as the network on the left hand side. The bridge can be driven either with white noise or a simple carrier (connected to drive). In the case of white noise the amplitude of the exciting signal can be very low and a radio receiver used as the detector. In the case where a simple carrier is used then depending on the level either a diode detector or a receiver can be used. In both cases a null will indicate when the bridge is balanced.

A typical antenna bridge, the trimmer capacitor (C) is adjusted to make the bridge balance when the variable capacitor on the left is half meshed. Hence the bridge will be able to detect if an aerial is either a resistive or inductive load.

Unlike an SWR meter which measures the standing wave ratio in the cable feeding the antenna, a complex-impedance antenna analyzer requires little or no transmitted power applied to the antenna. The SWR meter works by measuring the reflected wave from the antenna back to the transmitter, which is minimal when the antenna is balanced. A badly tuned antenna can produce enough reflected power to damage the transmitter. Since an RX bridge can be used without transmitting, there is no risk of transmitter damage.[1][2]

Uses

Many amateur radio operators use antenna analyzers to optimize an existing antenna or troubleshoot antenna related problems such as diagnosing a break in coax cable and finding faulty antenna components.[3]

References

  1. ^ Practical Radio Frequency Test and Measurement: A Technician's Handbook by Joseph J. Carr, P. 319. Published by Newnes, 1999. ISBN 0750671610, 9780750671613
  2. ^ Secrets of RF Circuit Design by Joseph J. Carr, Chapter 17, Building and using the RF noise bridge. ISBN 0-07-137067-6
  3. ^ The ARRL Handbook for Radio Communications 2007: The Comprehensive RF Engineering Reference by Mark J. Wilson, Dana G. Reed. Published by American Radio Relay League, ISBN 0872599760, 9780872599765

See also


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • Lecher lines — are a form of parallel conductor that can be used at UHF for creating resonant circuits. They are used at frequencies between HF/VHF where lumped components are used, and UHF/SHF where resonant cavities are more practical. Ernst Lecher of Vienna …   Wikipedia

  • SWR meter — The SWR meter or VSWR (voltage standing wave ratio) meter measures the standing wave ratio in a transmission line. This is an item of radio equipment used to check the quality of the match between the antenna and the transmission line.The VSWR… …   Wikipedia

  • Radio transmitter design — In plate modulation systems the voltage delivered to the stage is changed. As the power output available is a function of the supply voltage, the output power is modulated. This can be done using a transformer to alter the anode (plate) voltage.… …   Wikipedia

  • Avalanche diode — An avalanche diode is a diode (usually made from silicon, but can be made from another semiconductor) that is designed to go through avalanche breakdown at a specified reverse bias voltage and conduct as a type of voltage reference.The Zener… …   Wikipedia

  • Noisebridge — For the device used to measure the efficiency of antennas systems, see antenna analyzer. Noisebridge Organization Motto Be Excellent To Each Other v · d · …   Wikipedia

  • Signals intelligence — SIGINT redirects here. For the UNIX signal, see SIGINT (POSIX). RAF Menwith Hill, a large site in the United Kingdom, part of ECHELON and the UK USA Security Agreement. Signals intelligence (often contracted to SIGINT) is intelligence gathering… …   Wikipedia

  • Mars Polar Lander — Artist depiction of Mars Polar Lander on Mars. Operator NASA / JPL Major contractors Martin Marietta …   Wikipedia

  • Cassini–Huygens — Artist s concept of Cassini s Saturn Orbit Insertion Operator NASA / ESA / ASI Mission type …   Wikipedia

  • Mathematics of radio engineering — A complex valued function. The mathematics of radio engineering is a pleasant and very useful subject. This article is an attempt to provide a reasonably comprehensive summary of this almost limitless topic. While the ideas have historically… …   Wikipedia

  • SETI — Search for Extra Terrestrial Intelligence (SETI) is the collective name for a number of activities to detect intelligent extraterrestrial life. The general approach of SETI projects is to survey the sky to detect the existence of transmissions… …   Wikipedia

Share the article and excerpts

Direct link
… Do a right-click on the link above
and select “Copy Link”