Toss bombing

Toss bombing (sometimes known as loft bombing) is a method of bombing where the attacking aircraft pulls upwards when releasing its bomb load, giving the bomb additional time of flight by starting its ballistic path with an upward vector.

Variants

Pop-Up

In pop-up bombing, the pilot approaches from low altitude in level flight, and on cues from the computer pulling up at the last moment to toss the bomb. Release usually occurs between 20°–75° above the horizontal (generally 45°, providing maximum range), causing the bomb to be tossed upward and forward, much like an underarm throw of a ball.

Level Toss

Although "pop-up" bombing is generally characterized by its low-level approach, the same technique of a toss starting from level flight can be used at any altitude when it is not desirable to overfly the target. Additional altitude at release gives the bomb additional time of flight and range, at the cost (in the case of unguided munitions) of accuracy due to windage and the increased effect of a slight deviation in flight path.

Dive Toss

Although toss bombing might seem the direct opposite to dive bombing, where the plane pitches downwards to aim at its target, toss bombing is often performed with a short dive before the bomber raises its nose and releases its bomb. This variant is known as "dive tossing". This gives both the bomb and aircraft extra momentum, thereby helping the aircraft regain altitude after the release and also ensuring that airspeed at the calculated release point is still sufficient to get the bomb to the target.

Over-The-Shoulder

A more dynamic variant of toss bombing, called over-the-shoulder bombing, or the LABS (Low Altitude Bombing System) maneuver (known to pilots as the "idiot's loop"), is a particular kind of loft bombing where the bomb is released past the vertical so it is tossed back towards the target. This tactic was first made public in 1957 at Eglin AFB, when a B–47 entered its bombing run at low altitude, pulled up sharply (3.5 "g") into a half loop, releasing its bomb under computer control at a predetermined point in its climb, then executed a half roll, completing a maneuver similar to an Immelmann turn or Half Cuban Eight. The bomb continued upward for some time in a high arc before falling on a target which was a considerable distance from its point of release. In the meantime, the maneuver had allowed the bomber to change direction and distance itself from the target.

Tactical Use

Toss bombing is generally used by pilots whenever it is not desirable to overfly the target with the aircraft at an altitude sufficient for dive-bombing or level bombing. Such cases include heavy anti-air defenses such as AAA and SAMs, when deploying powerful weapons such as 2,000 lb. "iron bombs" or even tactical nuclear bombs, and the use of limited-aspect targeting devices for guided munitions.

To counter air defenses en route to the target, remaining at a low altitude for as long as possible allows the bomber to avoid radar and visual tracking and the launch envelope of older missile systems designed to be fired at targets overflying the missile site. However, a level pass at the target at low altitude will not only expose the aircraft to short-range defenses surrounding the target, but will place the aircraft in the bomb's blast radius. By executing a "pop-up" loft, on the other hand, the pilot releases the munition well outside the target area, out of range of air defenses. After release, the pilot can either dive back to low altitude or maintain the climb, in either case generally executing a sharp turn or "slice" away from the target. The blast produced by powerful munitions is thus avoided.

The value of toss-bombing was increased with the introduction of precision-guided munitions such as the laser-guided bomb. Previous "dumb bombs" required a very high degree of pilot and fire control computer precision to loft the bomb accurately to the target. Unguided loft bombing also generally called for the use of a larger bomb than would be necessary for a direct hit, in order to generate a larger blast that would destroy the target even if the bomb did not hit accurately due to windage or computer/pilot error. Laser-targeting (and other methods like GPS as used in the JDAM system) allows the bomb to correct minor deviations from the intended ballistic path after it has been released, making toss-bombing as accurate as level bombing while still providing most of the advantages of toss-bombing using unguided munitions. However, the targeting pods used to deliver guided munitions generally have a limit to their field of view; most specifically, the pod usually cannot look behind the aircraft at more than a certain angle. Lofting the bomb allows the pilot to keep the target in front of the aircraft and thus within the targeting pod's field of view for as long as possible.

"Dive-tossing" is generally used at moderate altitude (to allow for the dive) when the target, for whatever reason, cannot be designated precisely by radar. A target for instance may present too small a signature to be visible on radar (such as the entrance to an underground bunker) or may be indistinguishable in a group of radar returns. The pilot can in this case use a special "boresight" mode that allows the pilot to designate a target by pointing his aircraft directly at it. For a target on the ground, this means entering a dive. Thus designated, the pilot can then begin a climb, lofting the bomb at the target from a distance and regaining lost altitude at the same time.

Technology

Due to the intense pilot workload involved with flying and entering the window of opportunity, some aircraft are equipped with a “Toss Bomb Computer” (in US nuclear delivery, a part of the Low Altitude Bombing System) that enables the pilot to release the bomb at the correct angle. The Toss Bomb Computer takes airspeed inputs from the aircraft’s Pitot system, altitude inputs from the static system, attitude inputs from the gyroscopic system and inputs from weapons selectors signifying the type of bomb to calculate the appropriate release point of the ordinance. Instead of triggering the release directly, the pilot instead "consents" to release the weapon, then begins a steady climb. The computer then calculates the desired ballistic path, and when that path will be produced by the current aircraft attitude and airspeed, the computer releases the bomb. While deployed in Europe with NATO, RCAF CF-104 fighter-bombers carried a Toss Bomb Computer until their nuclear role was eliminated by the Canadian government effective 1 January 1972.

The same computational solutions used in the LABS system are now incorporated into two of the major bombing modes (the computer-controlled CCRP and a dedicated visually-oriented "Dive-Toss" mode) of the Fire Control Computer of modern strike fighters such as the F-15E and F-16. As with LABS, the pilot designates their desired impact point, then consents to release while executing a climb, and the computer controls the actual release of the bomb. The integration into the FCC simplifies the pilot's workload by allowing the same bombing mode (CCRP) to be used for level, dive and loft bombing, providing similar cues in the pilot's displays regardless of the tactics used.

References

* [http://www.nationalmuseum.af.mil/factsheets/factsheet.asp?fsID=1865 “Over-the-Shoulder” Fact Sheet] , National Museum of the United States Air Force

ee also

*Tactical bombing
*Strategic bombing
*Carpet bombing
*Terror bombing