- Standedge Tunnels
Location map|United Kingdom
label =
background = white
lat = 53.591283
long = -1.95996
caption = Map showing the location of the Standedge Tunnels in the United Kingdom
float = right
width = 185The Standedge Tunnels (Standedge is normally pronounced "Stannige") are four paralleltunnel s that run beneath thePennines at the traditionalStandedge crossing point between Marsden and Diggle, on the edges of theconurbation s ofWest Yorkshire andGreater Manchester respectively, in northernEngland . There are three railway tunnels and acanal tunnel (on theHuddersfield Narrow Canal ). The canal tunnel is the longest and oldest of the tunnels, and holds the record as the longest and highest canal tunnel in Britain. All four tunnels are linked by cross-tunnels oradit s at strategic locations within the tunnels.cite web|url = http://www.aroundsaddleworth.co.uk/diggle2.htm|title = Saddleworth Magazine] The adits allowed the railway tunnels to be built much more quickly by allowing 'waste spoil'(sic) to be removed by boat and reducing the need for shafts for construction.Of the railway tunnels, only the tunnel built in 1894 is currently used for rail traffic. Closed in 1943, the canal tunnel was re-opened in May 2001. The Standedge Visitors Centre, at the Marsden end of the tunnel, serves as a base for boat trips into the canal tunnel and hosts an exhibition which depicts the various crossings.
The canal tunnel
The Standedge Tunnel is the longest, deepest and highest canal tunnel in Britain. It is 5,500 yards (5029 m) long, 638 feet (194 m) underground at the deepest point and 645 feet (197 m) above sea level.cite web|url=http://www.standedge.co.uk/about.htm|title=About Standedge Tunnel]
Construction
Benjamin Outram was the consulting engineer for the construction of the Huddersfield Narrow Canal (then known as the Huddersfield Canal), which links the towns ofAshton-under-Lyne andHuddersfield through the tunnel. However, Outram had so many commitments that construction took place under the supervision of a young and inexperienced surveyor, Nicholas Brown.Layout of the tunnel was difficult. It would be necessary to lay out a straight line across the mountain top and calculate how deep below the canal would be. At intervals, pits would be sunk to the requisite depth and the tunnel dug outwards from their bases.
In addition it was necessary to drive drainage adits. Outram had given his opinion that the hill was composed of gritstone and strong shale and should not present any difficulties. In fact he had not expected the need for a lining. It was an extremely ambitious undertaking for the time and Outram was not yet an established engineer, though he had gained experience with the
Butterley Tunnel on theCromford Canal . Nevertheless more than the expected amount of water entered the workings.The adits allowed so-called 'water engines' to be used. These were simply two buckets on a rope which ran over a pulley at the top of the shaft. One bucket would be filled with spoil from the workings and the other would be filled with water which counterbalance the spoil causing it to rise to the top. Once unloaded, the water would be drained allowing the spoil bucket to fall for another load. Although steam engine pumps were tried, they proved inefficient and expensive to run. A further problem was maintaining an adequate air supply for the workers. This was achieved by injecting water in a fine spray at the top of the shaft, which would carry sufficient fresh air down with it.
Work on the tunnel was fraught with difficulty and progress was slow. Gunpowder was used to blast through the solid rock and the work took place by candlelight. In "circa" 1801, Outram resigned from his post in order to devote himself entirely to work at Benjamin Outram and Company, which was expanding rapidly. Following his resignation,
Thomas Telford was called in to advise on the tunnel's completion.Before completion, a severe misalignment was found in the tunnel due to inaccuracy on the part of the surveyor who originally laid it out.
The tunnel was finally pierced through in 1809.
Re-financing
By 1804, work was well behind schedule and financially overstretched. Digging was progressing at each end of the tunnel, but the central section was untouched. Moreover there were problems along the canal from unworkable economies of design and bad workmanship, but also the disorganising effect of interference by the canal committee who, to be fair, were not experts in engineering matters, but were periodically starved of funds. In 1805, a further Act of Parliament was sought to raise more investment and
Thomas Telford was asked to prepare a programme for completing the work.Completion
The tunnel eventually opened in 1811, and the canal then became a through route 13 years after the rest of it had been completed and 17 years after work first began, at a cost of £123,803. Despite multiple problems, the building of the Huddersfield Narrow canal showed that the technique of quantity surveying had advanced greatly. Telford's report covered every expenditure to the last bucket; it was followed to the letter and the canal finally opened in 1811. Between 1811 and 1840 the tunnel was used on average by 40 boats daily. [ "The Saddleworth Story, by Mary Hodge", p. 19. 5th reprint, 1994. http://www.saddleworth-historical-society.org.uk/bibliography.htm]
The canal tunnel was brick-lined in places, though bare rock was left exposed in others.cite web|url=http://www.penninewaterways.co.uk/huddersfield/standedge3.htm|title = History]
Method of operation
The canal tunnel is only wide enough for one
narrowboat for much of its length, and to save on cost, as in some other canal tunnels in England, no tow-path was provided in the tunnel. As canal boats were horse-drawn, the boats had to be legged through the tunnel (a process where you lie on top of the cargo and push against the roof of the tunnel with your legs) by either one boatman or a team of boatmen.There are several widened points in the tunnel, originally designed to be passing places. However, due to intense competition between boat crews, two-way operation in the tunnel was found to be unpracticable. The canal company introduced a new method of working where one end of the tunnel was closed off by a locked chain, preventing access to the tunnel unless authorised. A similar system is used today.
The railway influence
The Huddersfield Narrow Canal was purchased by the former
Huddersfield and Manchester Railway in 1846. The canal tunnel proved most beneficial in assisting with the construction of the first railway tunnel at this location, as no vertical shafts were needed in the construction and the canal was an easy way to help remove the large amount of spoil excavated. Several cross-passages were retained.Closure
The last commercial boat to use the tunnel passed through in 1921, and the canal was officially closed in 1944, after which it soon fell into disrepair. One boat managed to struggle from one end of the canal to the other in 1948, but this soon became impracticable as the canal was blocked at several locations on both sides of the Pennines.
The canal tunnel became unsafe, and was closed off by large iron gates at each end. A conventional narrowboat would have been unable to navigate the tunnel due to several rockfalls inside.
Restoration and modern-day operation
The canal tunnel was the beneficiary of a £5 million restoration project as part of an effort to re-open the entire canal. Several rock-lined parts of the tunnel were found to be unstable. Where possible, these were stabilised by rock bolts, or where impractical, concrete was used to stabilise the rock face. The tunnel re-opened in May 2001.
Most modern canal boats are diesel-powered. When the canal was reopened it was felt that it would not be safe for boaters to navigate the tunnel under their own diesel power, due to the extreme length of the tunnel and the lack of ventilation. Instead, electric tug boats haul narrowboats through the tunnel.cite web|url = http://www.huddersfieldcanal.com/canal/tunnel.htm|title = Modern Operation]
Future operation
In September 2007, it was identified that significant repairs were required to one of the electric tug modules, and
British Waterways carried out a trial run for self-steer operation. The trip boat Pennine Moonraker was taken through the tunnel under her own power by owner John Lund, shadowed by a BW electric tug. The outcome of these trials is awaited.The railway tunnels
There are three railway tunnels, running parallel to each other and the canal tunnel. The rail tunnels are level for their whole length providing the only section of level track on the line where
water trough s could be installed to provide steam locomotives with fresh water supplies without the requirement for the train to stop.The 1848 tunnel
The first railway tunnel at Standedge was completed by the
London and North Western Railway in 1848, having acquired the former Huddersfield and Manchester Railway in 1847. This was a single line tunnel with a length of 3 miles, 57 yards (4803 m). The tunnel is located immediately to the south of, but at a slightly higher level than, the canal tunnel. Cross-passages or adits were dug linking the canal tunnel to the rail tunnel to facilitate the removal of spoil during construction.cite web | title = Communications and Transport in the Marsden area | url = http://www.marsdenhistory.co.uk/communications.html | publisher = Marsden Local History Group | accessdate = January 7 | accessyear = 2007 ] cite web | title = Huddersfield Narrow Canal Facts| url = http://www.huddersfield1.co.uk/huddersfield/narrowcanal/huddscanalfacts.htm | publisher = Huddersfield One | accessdate = January 7 | accessyear = 2007 ]The 1871 tunnel
The single track 1848 tunnel soon proved to be a bottleneck for rail traffic between Huddersfield and Manchester, and in 1871 a second parallel tunnel was opened. This tunnel was also a single line tunnel with a length of 3 miles, 57 yards (4803 m), and was situated to the south of the first rail tunnel, to which it is linked by adits.cite web | title = Communications and Transport in the Marsden area | url = http://www.marsdenhistory.co.uk/communications.html | publisher = Marsden Local History Group | accessdate = January 7 | accessyear = 2007 ]
The 1894 tunnel
In 1894 the London and North Western Railway opened a third rail tunnel, with double track and a length of 3 miles, 60 yards (4806 m). For most of its length, it is situated to the north of the canal tunnel, but passes over the canal tunnel just inside each tunnel entrance. The 1894 tunnel is linked to the 1848 tunnel by adits which pass above the canal tunnel; railway passengers can see the white painted arches of these adits near the ground on the southern side of the tunnel. This tunnel is the third longest rail tunnel in Britain after the
Severn Tunnel and theSheffield to Manchester route'sTotley Tunnel .cite web | title = Communications and Transport in the Marsden area | url = http://www.marsdenhistory.co.uk/communications.html | publisher = Marsden Local History Group | accessdate = January 7 | accessyear = 2007 ]The rail tunnels today
Today only the 1894 rail tunnel is still used for rail traffic, although all three rail tunnels are still maintained.
The 1848 tunnel is used to provide an emergency escape route for the other tunnels, and has been made accessible to road vehicles such as
fire engine s andambulance s. All passages through the canal tunnel are accompanied by a vehicle in the 1848 tunnel for safety purposes.The Visitors' Centre
The Standedge Visitors Centre is situated at the Marsden end of the tunnel. It is located in the former warehouse used for
transshipment of goods from canal barge topackhorse during the period between 1798, when the canal reached Marsden, and 1811, when the tunnel opened. The centre contains exhibitions on the history of the tunnels, and on the canal tunnel's recent restoration.The nearby "Tunnel End Cottages", which formerly housed canal maintenance workers, house a cafe and the booking office for 30 minute boat trips into the tunnel. These trips use the same electric tugs as are used to tow private boats through the tunnel, in this case pushing a passenger carying barge.
The visitors centre is situated about half a mile (0.8 km) to the west of
Marsden railway station and can easily be reached from the station by walking along thetowpath of theHuddersfield Narrow Canal , which runs adjacent to the station. Adjacent to the station is the headquarters of the National Trust'sMarsden Moor Estate , which includes a public exhibition, "Welcome to Marsden", that gives an overview of the area and its transport history.cite web | title = Marsden Moor - What to see and do | publisher = National Trust | accessdate = December 24 | accessyear = 2006 | url = http://www.nationaltrust.org.uk/main/w-vh/w-visits/w-findaplace/w-marsdenmoorestate/w-marsdenmoor-seeanddo.htm ]References
ee also
*
Canals of Great Britain
*History of the British canal system External links
*Aerial photos of the mmuknr photo|400590|407965|5|Diggle portal and the mmuknr photo|403990|411930|5|Marsden portal
* [http://www.standedge.co.uk/ Standedge Tunnel Visitor Centre]
* [http://www.waterscape.com/servicesdirectory/Standedge_Tunnel/sid2082 Waterscape services directory]
* [http://www.penninewaterways.co.uk/huddersfield/standedge1.htm Standedge Tunnel]
* [http://www.tripsbytrain.com/trip0104/index.html A walk between Marsden Station and Standedge Tunnel] from TripsByTrain.com
Wikimedia Foundation. 2010.