- Pulse forming network
A Pulse Forming Network (PFN) accumulates
electrical energyover a comparatively long time, then releases the stored energy in the form of a relatively square pulse of comparatively short duration for various pulsed powerapplications. In practice, a PFN is charged by means of a high voltagepower source, then rapidly discharged into a load via a high voltage switch, such as a spark gapor hydrogen thyratron. The load may be a high power microwave oscillatorsuch as a klystronor magnetron, a flash lamp, or even an electromagnet. Depending upon the application, the output pulse repetition rate may range from a fraction of a Hertzto over 10 kHz.
A PFN consists of a series of high voltage energy storage
capacitors and inductors. These components are interconnected (as a "ladder network") that behaves similar to a length of transmission line. For this reason, a PFN is sometimes called an "artificial, or synthetic, transmission line". Electrical energy is initially stored within the charged capacitors of the PFN.
Sometimes an actual length of transmission line is used as the pulse forming network. This can give substantially flat topped pulses at the inconvenience of using of a large length of cable.
A "Blumlein" transmission line is a particular configuration of transmission lines used to create high-voltage pulses with short rise and fall times. Its principle is closely related to a pulse-forming
transmission linedischarge, although a Blumlein's output voltage is the same as the charging voltage whereas the Pulse-forming transmission line outputs half the charging voltage.
Uses of PFNs
Upon command, a high voltage switch then transfers the energy stored within the PFN into the load. When the switch "fires", the network of capacitors and inductors within the PFN creates an approximately square output pulse of short duration and high power. This high power pulse becomes a brief source of high power to the load.
Sometimes a specially designed pulse transformer is connected between the PFN and load. This technique improves the impedance match between the PFN and the load so as to improve power transfer efficiency. A pulse transformer is typically required when driving higher impedance devices such as klystrons or magnetrons from a PFN. Because the PFN is charged over a relatively long time and then discharged over a very short time, the output pulse may have a peak power of megawatts or even terawatts.
The combination of high voltage source, PFN, HV switch, and pulse transformer (when required) is sometimes called a "power modulator" or "pulser".
* missile operations
External links and references
* " [http://www.ieci.com.au/highvoltage/type_PFN.html Pulse Forming Networks] ". Plastic Capacitors, Inc.
* Eric Heine, " [http://www.nikhef.nl/~erichn/conversion/conv.html Conversion] ". NIKHEF Electronic Department, Amsterdam, The Netherlands.
* Riepe, Kenneth B., "High-voltage microsecond pulse-forming network". Review of Scientific Instruments Vol 48(8) pp. 1028-1030. August 1977. ( [http://content.aip.org/RSINAK/v48/i8/1028_1.html Abstract] )
* Glasoe, G. Norris, Lebacqz, Jean V., "Pulse Generators", McGraw-Hill, MIT Radiation Laboratory Series, Volume 5, 1948.
Wikimedia Foundation. 2010.