- M712 Copperhead
The M712 "Copperhead" is a 155 mm cannon-launched, fin-stabilized, terminally
laser guided ,explosive projectile intended to engage hard point targets such astank s, SPhowitzer s or other high-value targets. It may be fired from the following US Army field artillery weapons: M114A2 towedhowitzer s, and both the short-barrel (M109A1 and M109A1B) and long-barrel (M109A2, M109A3, M109A3B, M109A4, M109A5 and M109A6)M109 howitzer series SP howitzers and the M198 towed howitzer. The projectile has a minimumrange of 3km and a maximum range of 16km.In order for Copperhead to function, the target must be illuminated with a
laser . Once the laser signal is detected, the on-boardguidance system will operate the steering vanes to maneuver the projectile onto the target. The Copperhead targetinglogic is designed to (1) ensure that the optical system will always be able to detect the target, and (2) that once the target has been detected there will be sufficient time andvelocity to maneuver to hit the target. Copperhead must be below any cloud cover at critical parts of the trajectory, and there must be sufficient visibility to ensure that when the target is acquired the projectile will have sufficient time to maneuver.Modes of operation
Copperhead has two modes of operation: Ballistic mode and glide mode. Ballistic mode is used where the cloud ceiling is high and visibility is good. When the projectile is 3000 meters from the target, the guidance vanes extend, the target is acquired, and then the on-board guidance system adjusts the guidance vanes to maneuver onto the target.
Glide mode is used when the
cloud ceiling and/or thevisibility is too low to permit the use of the ballistic mode. A glide modetrajectory consists of two phases: a ballistic phase and a glide phase. At a predetermined point along the trajectory, the guidance vanes extend and there is a transition from ballistic phase to glide phase. Glide phase targeting logic is designed to ensure the largest possible angle of fall permitted by thecloud cover and the visibility. The target is acquired when the projectile is close enough to detect the laser illumination or when the projectile emerges from the cloud cover, which ever event occurs later in the trajectory. When a trajectory solution has been obtained, time-to-target andterminal velocity are checked to ensure that there will be enough time to maneuver and that the projectile is aerodynamically stable - that it will notstall while maneuvering.Initially the laser designation was intended to be performed by the
MQM-105 Aquila pilotless drone. [p.43, Yenne & Yenne]Combat history
Copperhead was used in
Desert Storm . [ [http://www.globalsecurity.org/military/systems/munitions/m712.htm M712 Copperhead - Global Security] ]References
ources
* Yenne, William , Yenne, Bill, "Attack of the Drones: A History of Unmanned Aerial Combat", Zenith Imprint, 2004 ISBN 0760318255
ee also
*
XM982 Excalibur
*XM1156 Precision Guidance Kit
* Krasnopol
Wikimedia Foundation. 2010.