OC-135B Open Skies

Infobox Aircraft
name = OC-135 Open Skies
type = Observation Support/Support Open Skies Treaty
manufacturer = Boeing Military Airplanes Division

---

caption =
designer =
first flight =
introduction = June avyear|1993
retired =
status =
primary user = United States Air Force
more users =
produced =
number built = 3
unit cost =
developed from = C-135 Stratolifter
variants with their own articles = WC-135 Constant Phoenix

The OC-135B Open Skies United States Air Force observation aircraft supports the Treaty on Open Skies. The aircraft, a modified WC-135B, flies unarmed observation flights over participating parties of the treaty. Three OC-135B aircraft were modified by the Aeronautical Systems Center's 4950th Test Wing at Wright-Patterson Air Force Base in Ohio. The first initial operational capability OC-135B was assigned to the 24th Reconnaissance Squadron at Offutt AFB in October 1993. It is now fitted with a basic set of navigational and sensor equipment, and placed in inviolate storage at the Aerospace Maintenance and Regeneration Center at Davis-Monthan Air Force Base near Tucson, Arizona. Two fully operational OC-135B aircraft were delivered in 1996 with the full complement of treaty allowed sensors, which includes an infrared line scanner, synthetic aperture radar and video scanning sensors.

Description of aircraft

The interior seats 35 people, including the cockpit crew, aircraft maintenance crew, foreign country representatives and crew members from the U.S. Department of Defense's Defense Threat Reduction Agency (DTRA). Cameras installed include one vertical and two oblique KS-87E framing cameras used for low-altitude photography approximately 3,000 feet (900 m) above the ground, and one KA-91C panoramic camera, which scans from side to side to provide a wide sweep for each picture used for high altitude photography at approximately 35,000 feet (10,000 m).

The data annotation and recording system (DARMS) processes navigational, altitude, time and camera signals to annotate each picture with correct position, altitude, time, roll angle and other information. In addition, this system records every picture taken according to camera, frame and navigational position and downloads these data to a 3.5-inch floppy disk. A keyboard with trackball is the input device for operation of this system. Two Barco 12-inch VGA color monitors display camera annotation and other camera data on screen for the sensor operator and observer use.

Camera control, located in the sensor operator's console, operates and adjusts individual cameras for cloud cover, frame overlap and other functions. The sensor operator console seats four and has all the equipment listed above plus camera bay heating control, chronometers, emergency oxygen, interphone and individual lighting. The flight following console also seats four and includes most of the equipment listed above except for DARMS and camera controls.

Seven commercial Norcoid Tek II coolers with individual refrigeration units maintain temperature and humidity control to maintain peak film performance. The units can be removed, if necessary, from the aircraft in order to transport film. The coolers are capable of storing 40,000 feet (12 km) of film.

Flight path

The aircraft flies on its intended flight path throughout the entire mission with no reliance on ground-based navigation devices. A top-of-the-line commercial system, Litton 92 INS/GPS, which is an integrated inertial navigation system (INS) with a global positioning system (GPS), provides continuous updates. The GPS updates the INS several times per second to correct any deviations in the flight path. The INS also feeds precise latitude, longitude, time, roll angle and barometric altitude to the DARMS and camera systems. A true airspeed computer feeds true airspeed data to the INS.

A combined altitude radar altimeter provides precise height above ground information to the pilot for navigational purposes as well as a signal to DARMS for film annotation. It is accurate from 0 to 50,000 feet (15,000 m) above the ground level. Plus, a metric altimeter is installed on the pilot's instrument panel for altitude reference when flying in countries that use meters for altitude reference.

The aircraft are being upgraded with the Block 30 Pacer Crag Navigational System upgrade, a first step in making them compliant with ICAO mandated Global Air Traffic Management and Global Air Navigation Standards guidelines.

Modifications

The OC-135B modifications center around four cameras installed in the rear of the aircraft. Since its primary mission is to take pictures, most of the installed equipment and systems provide direct support to the cameras and the camera operator. Other modifications to the aircraft also included installing an auxiliary power unit, crew luggage compartment, sensor operator console, flight following console and upgraded avionics.Other modifications support the aircrew. A gaseous oxygen system replaced the liquid oxygen system to be more compatible with foreign airfields, and fluorescent lighting system was added throughout the cabin to provide adequate lighting for operation and inspections. Four upgraded seats with a conference table, interphone, lighting and oxygen comprise the mission commanders' station for both countries' mission commanders. A four channel interphone system enables segregated communications between various elements onboard.

The auxiliary power unit enables the aircraft to start engines and provides electrical power and cabin heat independent of ground support equipment. It was manufactured by Allied Signal with the installation and design of the installation by E-Systems and World Auxiliary Power Company.

The aircraft are assigned to Air Combat Command at the 55th Wing, 45th Reconnaissance Squadron, Offutt Air Force Base near Omaha, Nebraska, for operations, training and maintenance. When tasked, ACC's role is to transport a DTRA observation team to an Open Skies point of entry airport, and conduct the observation flight, then return the team to the continental United States.

pecifications (OC-135)

aircraft specifications
plane or copter?=plane
jet or prop?=jet
ref=Fact|date=February 2008
crew=Seven (three pilots, two navigators, and two sensor maintenance technicians), also DTRA mission flight crew: mission commander, deputy mission commander, two sensor operators and one flight follower
capacity=
payload main=
payload alt=
length main= 135 ft
length alt= 41.1 m
span main= 131 ft
span alt= 39.9 m
height main= 42 ft
height alt= 12.8 m
area main=
area alt=
airfoil=
empty weight main=
empty weight alt=
loaded weight main=
loaded weight alt=
useful load main=
useful load alt=
max takeoff weight main= 297,000 lb
max takeoff weight alt= 134,700 kg
more general=
engine (jet)=Pratt and Whitney TF33-P-5
type of jet=Turbofans with thrust reversers
number of jets=4
thrust main= 16,050 lbf
thrust alt= 71.4 kN
thrust original=
afterburning thrust main=
afterburning thrust alt=
max speed main= 500+ mph
max speed alt= 800+ km/h
cruise speed main=
cruise speed alt=
stall speed main=
stall speed alt=
never exceed speed main=
never exceed speed alt=
range main= 3,900 miles
range alt=6,500 km
ceiling main=
ceiling alt=
climb rate main=
climb rate alt=
loading main=
loading alt=
thrust/weight=
power/mass main=
power/mass alt=
more performance=
armament=
avionics=

References

This article includes public domain text from the following United States Government source:
* [http://www.af.mil/factsheets/factsheet.asp?fsID=120 OC-135B Fact Sheet] published by the Air Combat Command

ee also

aircontent
related=
* C-135 Stratolifter
* KC-135 Stratotanker
* WC-135 Constant Phoenix
similar aircraft=
sequence=
* C-131 - C-132 - C-133 - C-135 - C-137 - C-138 - C-139
lists=
* List of active military aircraft of the United States
see also=