N connector

N connector
Type N
N Connector.jpg
Type N connector (male)
Type RF coaxial connector
Designer Paul Neill
Designed 1940s
Diameter Male:      0.800 in (2.03 cm)
Female:  0.550 in (1.40 cm)
(outer, typical)
Cable Coaxial
Passband 0-11 GHz, often up to 18 GHz
Type N connector (female)
Picture to show the similarity between 50Ω (bottom) and 75Ω (top) N connectors
Type N connector Male

The N connector (in full, Type N connector) is a threaded RF connector used to join coaxial cables. It was one of the first connectors capable of carrying microwave-frequency signals, and was invented in the 1940s by Paul Neill of Bell Labs, after whom the connector is named.

Contents

Design

Originally, the connector was designed to carry signals of up to 1 GHz in military applications, but the common Type N today handles up to 11 GHz comfortably. More recent precision enhancements to the design by Julius Botka at Hewlett Packard have scaled this to 18 GHz. The male connector is hand-tightened (though versions with a hex nut are also available) and has an air gap between center and outer conductors. The coupling has a 5/8-24 thread. Amphenol [1] suggest tightening to a torque of 15 foot-pounds (20 N·m), while Andrew Corporation suggest 20 for their hex nut variant. Since torque limit depends only on thread quality and cleanliness, whereas the main operational requirement is good RF contact without significant steps or gaps, these values should be seen as indicative rather than critical.

Power rating

The peak power rating of an N connector is determined by voltage breakdown/ionisation of the air near the center pin. The average power rating is determined by overheating of the centre contact and is a function of frequency, as heating depends on the resistive insertion loss. Typical makers curves for a new clean connector with a perfect load such as page 275 of [2] for example imply ~5000 watts at 20 MHz and ~500watts at 2 GHz, i.e. a square root frequency derating law as might be expected from skin depth decreasing with frequency. At lower frequencies the same maker recommends an upper bound of ~1000V RMS. To achieve reliable operation in practice over an extended period, a safety factor of 5 or more is not uncommmon, particularly when generic parts may be substituted, or the operating environment is likely to lead to eventual tarnishing of the contacts.

Impedance options

The N connector follows the MIL-C-39012 standard, defined by the US military, and comes in 50 and 75 ohm versions. The 50 ohm version is widely used in the infrastructure of land mobile, wireless data, paging and cellular systems. The 75 ohm version is primarily used in the infrastructure of cable television systems. Connecting these two different types of connectors to each other can lead to damage due to the difference in diameter of the center pin.[3] Unfortunately, many type N connectors are not labeled, and it can be difficult to prevent this situation in a mixed impedance environment. The situation is further complicated by some makers of 75 ohm sockets designing them with enough spring yield to accept the larger 50ohm pin without irreversible damage, while others clearly do not, and expect users to segragate their connectors and adaptors. In general a 50 ohm socket is not damaged by a 75 ohm pin, but the loose fit means the contact quality is not guaranteed.

The 50 ohm type N connector is favored by enthusiasts who create their own Wireless LAN antenna systems, which run at 2.4 GHz or 5 GHz. The Cantenna is one such design. The enthusiasts have settled on using the N connector as a standard connection for homebrew antennas. By using a cable with an N connector one can easily interchange homebrew antennas. 50Ω N connectors are also commonly used on amateur radio devices (e.g., transceivers) operating in UHF bands.

Variations

SnapN was originally designed by Rosenberger Hochfrequenztechnik in 2006 and is a quick locking replacement for the threaded interface of the widely applied Type N connector. Though part of the Quick Lock Formula Alliance (QLF), engineers at Rosenberger independently designed the SnapN in order to correct the performance issues of QLF’s version of the quick lock N connector, QN. This design achieves better electronic performance because, unlike the QN, this new version maintains the basic structural parameters of the original Type N in which the inner dimensions of the outer conductor are 7.00 mm, and the inner conductor’s outer dimensions are 3.04 mm.

See also

  • LC connector

References

  1. ^ Amphenol, N type datasheet, http://www.amphenolrf.com/products/CatalogPages/TypeN.pdf 
  2. ^ Suhner, Huber. Radio Frequency connector catalogue. pp. 275–276. http://ipaper.ipapercms.dk/hubersuhner/Technologies/Radiofrequency/RFConnectorsEN/. 
  3. ^ Golio, Mike (2008). The RF and Microwave Handbook, Second Edition. CRC. pp. 8–7. ISBN 978-0849372179. http://books.google.com/books?id=MCj9jxSVQKIC&printsec=frontcover&cad=0. 

Wikimedia Foundation. 2010.

Игры ⚽ Нужно сделать НИР?

Look at other dictionaries:

  • Connector — may refer to: Electrical connector, a device for joining electrical circuits together Audio and video connector Gender of connectors and fasteners Power connector RF connector MIL STD 1553 Circular connector Cigar lighter receptacle Blind mate… …   Wikipedia

  • Connector Motorways — Headquarters Sydney, Australia Website http://www.connectormotorways.com.au/ Connector Motorways is an Australian toll road operator. Connector owns the Lane Cove Tunnel and the Falcon Street Gateway in northern Sydney. Both projects opened to… …   Wikipedia

  • Connector Pens — are a type of felt tip pen. They are available in 100 different shades, and are sold in packs of 10, 20, 50, and 100. They are widely popular with children as the pens can be joined to each other by their caps to make long chains or other… …   Wikipedia

  • Connector (Коннектор) — «Connector» («Коннектор») грузовое судно (Великобритания) Тип: грузовое судно (Великобритания). Водоизмещение: 2032 тонны. Размеры: 52 м х 9 м. Силовая установка: одновальная, компаунд машина. Спущен на воду: 1852 г. «Connector» был одним из… …   Энциклопедия кораблей

  • Connector — Con*nect or, n. One who, or that which, connects; as: (a) A flexible tube for connecting the ends of glass tubes in pneumatic experiments. (b) A device for holding two parts of an electrical conductor in contact. [1913 Webster] …   The Collaborative International Dictionary of English

  • Connector —   [engl.], Stecker …   Universal-Lexikon

  • connector neuron — n INTERNEURON * * * interneuron …   Medical dictionary

  • connector — 1795, tube for connecting other materials, agent noun in Latin form from CONNECT (Cf. connect) and usefully distinct from connecter …   Etymology dictionary

  • connector — A device which joins two items. Also see adapter battery connector blade connector cell connector engine diagnostic connector eyelet connector helmet connector multicon connector system T connector …   Dictionary of automotive terms

  • Connector (road) — A connector is a highway or freeway road that connects to another highway or freeway. It can be part of an interchange such as the MacArthur Maze or a longer roadway such as the 13 mi (20 km) Interstate 635 (Kansas Missouri). A connector route is …   Wikipedia

  • connector bar — a connector unit of a removable partial denture that is fabricated as parallel , round , or oval sided bars and serves to connect parts of dentures, splint or connect abutments, connect and splint crowns, or splint teeth that have received root… …   Medical dictionary

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”