Rail gauge in Hong Kong

In Hong Kong, the Kowloon-Canton Railway Corporation (KCRC), which currently runs East Rail, West Rail and Light Rail uses 1,435 mm (4 ft 8 ¹⁄₂ in).

The Mass Transit Railway uses 1,432 mm (4 ft 8 ³⁄₈ in) track gauge, 3 mm (⅛in) narrower than standard gauge. A new railway line across the Tsing Ma Bridge, an extension to the 1,432 mm gauge Tung Chung Line. This 3 mm difference should cause no more problems than the 4 mm (⁵⁄₃₂in) difference causes between Russia and Finland or the former 8 mm (⁵⁄₁₆in) difference between Spain and Portugal.

Hong Kong Tramways, which has been operating tram service on Hong Kong Island since 1904, uses 1,067 mm (3 ft 6 in) gauge.

Narrow gauge

Preserved Kowloon-Canton Railway locomotive

The Kowloon-Canton Railway (now East Rail) was originally partially laid to 2 ft (610 mm) and 3 ft (914 mm) gauge during its construction, and the latter was proposed to be its gauge since the tunnel could only accommodate 3 ft (914 mm) gauge if the line was to be double track throughout. However it was built to standard gauge and was single track, retaining space at places for later expansion. The now-defunct Sha Tau Kok Railway, built in 1911 and closed in 1928, constructed of the same materials used for constructing the main line, was 2 ft (610 mm) gauge. The famous Hong Kong Tramways are 3 ft 6 in (1,067 mm) gauge. The MTR uses a gauge of 1432 mm, 3 mm narrower than the standard gauge. Originally it was to be standard gauge but when the link between the KCR and MTR at Kowloon Tong fell into disuse due to the difference in the choice of voltage for their respective electrification plans, the latter favoured a narrower gauge for technical reasons. This has proven to be an impediment of the proposed merger between the two systems.^[1]

The haematite mine at Ma On Shan used an electric internal railway network of 2 ft 6 in (762 mm) gauge, but closed in 1975.^[1]

The Kowloon Godowns in Tsim Sha Tsui, before redevelopment in the 1970s, also had an extensive network of 2 ft (610 mm) gauge tracks using tiny hand-pushed 2-axle trucks. Similar systems existed elsewhere in Hong Kong. Railways believed to be metre gauge existed in Taikoo Dockyards and Whampoa Dockyards, though standard gauge is more probable for the latter, since it was connected to the main line network after 1937. A cement works in To Kwa Wan, north of the Whampoa dockyards, used a small internal narrow gauge system with jubilee track(prefabricated panels) and wagons, but apart from a few aerial photographs available at the Lands Department Mapping Office, there is little available information about this system.^[1]

During the reclamation of Kowloon Bay for the construction of the Kai Tak estates, "jubilee" track and steam locomotives were used to convey spoil. This area became the Kai Tak Airport which has now been demolished.^[1]

References

1. ^ ^{a b c d} A Picture Album of Steam Locomotives in China, 1876 - 2001. China Rail Publishing House. ISBN 7-113-04147-7.