Seismic wave

Seismic wave

Seismic waves are waves that travel through the Earth, most often as the result of a tectonic earthquake, sometimes from an explosion. Seismic waves are also continually excited by the pounding of ocean waves and the wind. Seismic waves are studied by seismologists, and measured by a seismograph, which records the output of a seismometer, or geophone. For seismic studies of oil reservoirs, hydrophones may give additional information.

Types of seismic wave

There are two types of seismic waves, "body waves" and "surface waves". Other modes of wave propagation exist than those described in this article, but they are of comparatively minor importance. An excellent audience demonstration for seismic waves is shown in slinky seismology.

Body waves

Body waves travel through the interior of the Earth. They follow raypaths bent by the varying density and modulus (stiffness) of the Earth's interior. The density and modulus, in turn, vary according to temperature, composition, and phase. This effect is similar to the refraction of light waves. Body waves transmit the first-arriving tremors of an earthquake, as well as many later arrivals. There are two kinds of body waves: primary and secondary.

P waves

P waves (primary waves) are longitudinal or compressional waves, which means that the ground is alternately compressed and dilated in the direction of propagation. In solids, these waves generally travel almost twice as fast as S waves and can travel through any type of material. In air, these pressure waves take the form of sound waves, hence they travel at the speed of sound. Typical speeds are 330 m/s in air, 1450 m/s in water and about 5000 m/s in granite. When generated by an earthquake they are less destructive than the S waves and surface waves that follow them, due to their bigger amplitudes.


S waves (secondary waves) are transverse or shear waves, which means that the ground is displaced perpendicularly to the direction of propagation. In the case of horizontally polarized S waves, the ground moves alternately to one side and then the other. S waves can travel only through solids, as fluids (liquids and gases) do not support shear stresses. Their speed is about 60% of that of P waves in a given material. S waves are several times larger in amplitude than P waves for earthquake sources.

urface waves

Surface waves are analogous to water waves and travel just under the Earth's surface. They travel more slowly than body waves. Because of their low frequency, long duration, and large amplitude, they can be the most destructive type of seismic wave. There are two types of surface waves: Rayleigh waves and Love waves. Theoretically, surface waves can be understood as systems of interacting P and S waves which you can read in the few paragraphs below.

Propagation of seismic wave in the ground and the effect of presence of land mine. ]

Rayleigh waves

Rayleigh waves, also called ground roll, are surface waves that travel as ripples similar to those on the surface of water. The existence of these waves was predicted by John William Strutt, Lord Rayleigh, in 1885. They are slower than body waves, roughly 70% of the velocity of S waves.

Rayleigh waves have been assertedFact|date=April 2008 to be visible during an earthquake in an open space like a parking lot where the cars move up and down with the waves, however, reports among seismologists suggest that the apparent motion may be due to distortion of the human eye during shaking. Anecdotally, placing people on "shake tables" causes the room to appear to ripple. In any case, waves of the reported amplitude, wavelength, and velocity of the "visible waves" have never been recorded instrumentally.

Love waves

Love waves are surface waves that cause horizontal shearing of the ground. They are named after A.E.H. Love, a British mathematician who created a mathematical model of the waves in 1911. They usually travel slightly faster than Rayleigh waves, about 90% of the S wave velocity.

Seismic waves travel through water because gravity pulls the waves down causing friction of the waves.

P and S waves in Earth's mantle and core

When an earthquake occurs, seismographs near the epicenter, out to about 90 km distance, are able to record both P and S waves, but those at a greater distance no longer detect the high frequencies of the first S wave. Since shear waves cannot pass through liquids, this phenomenon was original evidence for the now well-established observation that the Earth has a liquid outer core, as demonstrated by Richard Dixon Oldham. This kind of observation has also been used to argue, by seismic testing, that the Moon has a solid core, although recent geodetic studies suggest the core is still molten.

Usefulness of P and S waves in locating an event

In the case of local or nearby earthquakes, the difference in the arrival times of the P and S waves can be used to determine the distance to the event. In the case of earthquakes that have occurred at global distances, four or more geographically diverse observing stations (using a common clock) recording P-wave arrivals permits the computation of a unique time and location on the planet for the event. Typically, dozens or even hundreds of P-wave arrivals are used to calculate hypocenters. The misfit generated by a hypocenter calculation is known as "the residual". Residuals of 0.5 second or less are typical for distant events, residuals of 0.1-0.2 s typical for local events, meaning most reported P arrivals fit the computed hypocenter that well. Typically a location program will start by assuming the event occurred at a depth of about 33 km; then it minimizes the residual by adjusting depth. Most events occur at depths shallower than about 40 km, but some occur as deep as 700 km.

A quick way to determine the distance from a location to the origin of a seismic wave less than 200 km away is to take the difference in arrival time of the P wave and the S wave in seconds and multiply by 8 kilometers per second. Modern seismic arrays use more complicated earthquake location techniques.

At teleseismic distances, the first arriving P waves have necessarily travelled deep into the mantle, and perhaps have even refracted into the outer core of the planet, before travelling back up to the Earth's surface where the seismographic stations are located. The waves travel more quickly than if they had traveled in a straight line from the earthquake. This is due to the appreciably increased velocities within the planet, and is termed Huygens' Principle. Density in the planet increases with depth, which would slow the waves, but the modulus of the rock increases much more, so deeper means faster. Therefore, a longer route can take a shorter time.

The travel time must be calculated very accurately in order to compute a precise hypocenter. Since P waves move at many kilometers per second, being off on travel-time calculation by even a half second can mean an error of many kilometers in terms of distance. In practice, P arrivals from many stations are used and the errors cancel out, so the computed epicenter likely to be quite accurate, on the order of 10-50 km or so around the world. Dense arrays of nearby sensors such as those that exist in California can provide accuracy of roughly a kilometer, and much greater accuracy is possible when timing is measured directly by cross-correlation of seismogram waveforms.

External links

* [ Illustrated discussion of seismic waves -]
* [ Earthquake Basics - Seismic Waves]
* [ Seismic Waves by EduMedia]

Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • seismic wave — seisminė banga statusas T sritis fizika atitikmenys: angl. earth quake wave; seismic wave vok. Erdbebenwelle, f; seismische Welle, f rus. сейсмическая волна, f pranc. onde seismique, f; onde sismique, f …   Fizikos terminų žodynas

  • seismic wave — Vibration generated by an earthquake, explosion, or similar phenomenon and propagated within the Earth or along its surface. Earthquakes generate two principal types of waves: body waves, which travel within the Earth, and surface waves, which… …   Universalium

  • seismic wave — GLOSSARY OF VOLCANIC TERMS A term for elastic earth waves formed by either earthquakes or explosions. Seismic waves include both surface waves as well as body waves …   Glossary of volcanic terms

  • seismic wave — …   Useful english dictionary

  • Seismic shadowing — is a global effect of an earthquake. The seismic waves generated by an earthquake pass through the body of the Earth, but between 104° and 140° from the focus of an earthquake, little or no seismic waves can be detected. This is because primary… …   Wikipedia

  • Wave propagation — is any of the ways in which waves travel through a waveguide.With respect to the direction of the oscillation relative to the propagation direction, we can distinguish between longitudinal wave and transverse waves.For electromagnetic waves,… …   Wikipedia

  • Seismic source — This article is about artificial seismic sources. For natural seismic sources, see Earthquake, Volcano, and related articles. A seismic source generates controlled seismic energy that is used in both reflection and refraction seismic surveys. A… …   Wikipedia

  • wave — waveless, adj. wavelessly, adv. wavingly, adv. wavelike, adj. /wayv/, n., v., waved, waving. n. 1. a disturbance on the surface of a liquid body, as the sea or a lake, in the form of a moving ridge or swell. 2. any surging or progressing movement …   Universalium

  • Wave — /wayv/, n. a member of the Waves. Also, WAVE. [1942; see WAVES] * * * I In oceanography, a ridge or swell on the surface of a body of water, normally having a forward motion distinct from the motions of the particles that compose it. Ocean waves… …   Universalium

  • seismic survey —       method of investigating subterranean structure, particularly as related to exploration for petroleum, natural gas, and mineral deposits (mineral deposit). The technique is based on determinations of the time interval that elapses between… …   Universalium

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”