Inert pair effect

Inert pair effect

The term inert pair effect is often used in relation to the increasing stability of oxidation states that are 2 less than the group valency for the heavier elements of groups 13, 14, 15 and 16. The term "inert pair" was first proposed by Sidgwick in 1927. [N.V. Sidgwick , "The Electronic Theory of Valency" first published 1927]
As an example in group 13 the +1 oxidation state of Tl is the most stable and TlIII compounds are comparatively rare. The stability increases in the following sequence:Greenwood&Earnshaw] :AlI < GaI < InI < TlI. The situation in groups 14, 15 and 16 is that the stability trend is similar going down the group, but for the heaviest members, e.g. lead, bismuth and polonium both oxidation states are known.
The lower oxidation state in each of the elements in question has 2 valence electrons in s orbitals. On the face of it a simple explanation could be that the valence electrons in an s orbital are more tightly bound are of higher energy than electrons in p orbitals and therefore less likely to be involved in bonding. Unfortunately this explanation does not stand up. If the total ionization potentials(see below) of the 2 electrons in s orbitals (the 2d + 3d ionization potentials), are examined it can be seen that they increase in the sequence:: In < Al < Tl < Ga.

The high IP(2nd + 3rd) of gallium is explained by d-block contraction, and the higher IP(2nd + 3rd) of thallium relative to indium, has been explained by relativistic effects. [Holleman, A. F.; Wiberg, E. "Inorganic Chemistry" Academic Press: San Diego, 2001. ISBN 0-12-352651-5.]
An alternative explanation of the inert pair effect by Drago in 1958 [cite journal
title = Thermodynamic Evaluation of the Inert Pair Effect
author = Russell S. Drago
journal =J Phys Chem
year = 1958
volume = 62
issue = 3
pages = 353–357
doi = 10.1021/j150561a027
] attributed the effect to low M-X bond enthalpies for the heavy p-block elements and the fact that it requires less energy to oxidize an element to a low oxidation state than to a higher oxidation state. This energy has to be supplied by ionic or covalent bonds, so if bonding to a particular element is weak, the high oxidation state may be inaccessible. Further work involving relativistic effects confirms this. [cite journal
title = Low valencies and periodic trends in heavy element chemistry. A theoretical study of relativistic effects and electron correlation effects in Group 13 and Period 6 hydrides and halides
author = Schwerdtfeger P, Heath G A, Dolg M, Bennet M A
journal =Journal of the American Chemical Society
year = 1992
volume = 114
issue = 19
pages = 7518–7527
doi = 10.1021/ja00045a027
] In view of this it has been suggested that the term inert pair effect should be viewed as a description rather than as an explanation.

teric activity of the lone pair

The chemical inertness of the s electrons in the lower oxidation state is not always married to steric inertness, (where steric inertness means that the presence of the s electron lone pair has little or no influence on the geometry of molecule or crystal). A simple example of steric activity is that of SnCl2 which is bent in accordance with VSEPR. Some examples where the lone pair appears to be inactive are Bismuth(III) iodide, BiI3, and the BiI63 anion. In both of these the central Bi atom is octahedrally coordinated with little or no distortion, in contravention to VSEPR theory. [cite journal
title = Stereochemically active or inactive lone pair electrons in some six-coordinate, group 15 halides
author = Ralph A. Wheeler and P. N. V. Pavan Kumar
journal =Journal of the American Chemical Society
year = 1992
volume = 114
issue = 12
pages = 4776–4784
doi = 10.1021/ja00038a049
] The steric activity of the lone pair has long been assumed to be due to the orbital having some p character, i.e. the orbital is not spherically symmetric. More recent theoretical work shows that this is not always necessarily the case. For example the litharge structure of PbO contrasts to the more symmetric and simpler rock salt structure of PbS and this has been explained in terms of PbII anion interactions in PbO leading to an asymmetry in electron density. Similar interactions do not occur in PbS. [cite journal
title = The origin of the stereochemically active Pb(II) lone pair: DFT calculations on PbO and PbS
author = Walsh A, Watson G W
journal =Journal of Solid State Chemistry
year = 2005
volume = 178
issue = 5
pages = 1422–1428
doi = 10.1016/j.jssc.2005.01.030
] Another example are some thallium(I) salts where the asymmetry has been ascribed to s electrons on Tl interacting with antibonding orbitals. [cite journal
title = Lone Pair Effect in Thallium(I) Macrocyclic Compounds
author = Mudring A J, Rieger F
journal =Inorg. Chem.
year = 2005
volume = 44
issue = 18
pages = 6240–6243
doi = 10.1021/ic050547k
]

References

External links

* [http://www.chemguide.co.uk/inorganic/group4/oxstates.html Chemistry guide] An explanation of the inert pair effect.


Wikimedia Foundation. 2010.

Игры ⚽ Поможем сделать НИР

Look at other dictionaries:

  • nitrogen group element — ▪ chemical elements Introduction  any of the chemical elements that constitute Group Va of the periodic table (see Figure >). The group consists of nitrogen (N), phosphorus (P), arsenic (As), antimony (Sb), and bismuth (Bi). The elements share… …   Universalium

  • Bohr model — In atomic physics, the Bohr model created by Niels Bohr depicts the atom as a small, positively charged nucleus surrounded by electrons that travel in circular orbits around the nucleus mdash;similar in structure to the solar system, but with… …   Wikipedia

  • VSEPR theory — Valence shell electron pair repulsion (VSEPR) theory is a model in chemistry used to predict the shape of individual molecules based upon the extent of electron pair electrostatic repulsion.[1] It is also named Gillespie–Nyholm theory after its… …   Wikipedia

  • Magnetochemistry — is concerned with the magnetic properties of chemical compounds. Magnetic properties arise from the spin and orbital angular momentum of the electrons contained in a compound. Compounds are diamagnetic when they contain no unpaired electrons.… …   Wikipedia

  • List of effects — This is a list of names for observable phenonema that contain the word effect, amplified by reference(s) to their respective fields of study. #*3D audio effect (audio effects)A*Accelerator effect (economics) *Accordion effect (physics) (waves)… …   Wikipedia

  • Indium — Not to be confused with Iridium. cadmium ← indium → tin Ga ↑ In ↓ Tl …   Wikipedia

  • Tin(II) bromide — Chembox new Name = Tin(II) bromide ImageFile = Tin(II) bromide.jpg ImageName = Tin(II) bromide OtherNames = tin dibromide, stannous bromide Section1 = Chembox Identifiers CASNo = 10031 24 0 Section2 = Chembox Properties Formula = SnBr2 MolarMass …   Wikipedia

  • Atomic radius — Diagram of a helium atom, showing the electron probability density as shades of gray. The atomic radius of a chemical element is a measure of the size of its atoms, usually the mean or typical distance from the nucleus to the boundary of the… …   Wikipedia

  • D-block contraction — (sometimes called scandide contraction) is a term used in chemistry to describe the effect of having full d orbitals on the period 4 elements. The elements in question are the Ga, Ge, As, Se and Br. Their electronic configurations include… …   Wikipedia

  • d-block contraction — Atomic radius of elements of the groups 2,13 and 14. It shows d block contraction , especially for Ga and Ge d block contraction (sometimes called scandide contraction) is a term used in chemistry to describe the effect of having full d orbitals… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”