Hall effect thruster

Hall effect thruster

In spacecraft propulsion, a Hall thruster is a type of ion thruster in which the propellant is accelerated by an electric field. Hall thrusters trap electrons in a magnetic field and then use the electrons to ionize propellant, efficiently accelerate the ions to produce thrust, and neutralize the ions in the plume. Hall thrusters are sometimes referred to as Hall Effect Thrusters or Hall Current Thrusters.

Hall thrusters are able to accelerate their exhaust to speeds of around 15-30km/s, and can produce thrusts of about one Newton.


Hall thrusters were studied independently in the US and the USSR in the 1950s and 60s. However, the concept of a Hall thruster was only developed into an efficient propulsion device in the former Soviet Union, whereas in the US, scientists focused instead on developing gridded ion thrusters.

Two types of Hall thrusters were developed in the Soviet Union:
*thrusters with wide acceleration zone, SPD ( _ru. СПД, стационарный плазменный двигатель; English: SPT, Stationary Plasma Thruster) at Design Bureau Fakel
*thrusters with narrow acceleration zone, DAS (Russian: ДАС, двигатель с анодным слоем; English: TAL, Thruster with Anode Layer), at the Central Research Institute for Machine Building (TsNIIMASH).

The common SPD design was largely the work of A. I. Morozov. [ [http://fluid.ippt.gov.pl/sbarral/hall.html Hall thrusters] ] SPD engines were operated since 1972. They were mainly used for satellite stabilization in North-South and in East-West directions. Since then until the late 1990s 118 SPD engines completed their mission and some 50 continued to be operated. Thrust of the first generation of SPD engines, SPD-50 and SPD-60 was 20 and 30 mN respectively. In 1982 SPD-70 and SPD-100 were introduced, their thrust being 40 mN and 83 mN. In the post-Soviet Russia high-power (a few kilowatts) SPD-140, SPD-160, SPD-180, T-160 and low-power (less than 500 W) SPD-35 were introduced.ru icon [http://novosti-kosmonavtiki.ru/content/numbers/198/35.shtml Native Electric Propulsion Engines Today] , Novosti Kosmonavtiki, 1999, No.7]

Soviet and Russian DAS-type engines include D-38 and D-55.

Soviet-built thrusters were introduced to the West in 1992 after a team of electric propulsion specialists, under the support of the Ballistic Missile Defense Organization, visited Soviet laboratories and experimentally evaluated the SPD-100 (i.e., a 100 mm diameter SPT thruster). Over 200 Hall thrusters have been flown on Soviet/Russian satellites in the past thirty years. They were used mainly for stationkeeping and small orbital corrections. Currently Hall Thruster research, design, and theoretical modelling is led by experts at NASA Glenn Research Center and the Jet Propulsion Laboratory. A considerable amount of development is being conducted in industry, such as Aerojet and Busek Co.

This technology was used on the European lunar mission SMART-1 and is used on a number of commercial geostationary satellites. [ [http://www.loral.com/inthenews/040628a.html Loral Space & Communications: International Space Technologies, Inc. Debuts Its Stationary Plasma Thrusters On Loral-Built Mbsat Satellite ] ]

Current research

Current research on Hall thrusters is ongoing and focuses mainly on
# Scaling the typically 1 kW Hall thruster to higher powers (50 to 100 kW) and lower powers (50 to 100 W)
# Resolving spacecraft integration issues regarding the large plume divergence
# Enabling operation at higher specific impulse and variable specific impulse
# Flight validating thrusters for use on western spacecraft
# Extending the operational lifetimes to enable use on deep space science missions

A Hall thruster typically operates at around 50–60% thrust efficiency and provides specific impulse from 1,200 to 1,800 seconds (12 to 18 kN·s/kg), and thrust-to-power ratios of 50–70 mN/kW.


The essential working principle of the Hall thruster is that it uses an electrostatic potential to accelerate ions up to high speeds. In a Hall thruster the attractive negative charge is provided by an electron plasma at the open end of the thruster instead of a grid. A radial magnetic field of a few milli Tesla [ [http://sci.esa.int/science-e/www/object/index.cfm?fobjectid=34201&fbodylongid=1538 ESA Science and Technology-Electric Spacecraft Propulsion] ] is used to hold the electrons in place, where the combination of the magnetic field and an attraction to the anode force a fast circulating electron current around the axis of the thruster and only a slow axial drift towards the anode occurs.

A schematic of a Hall thruster is shown in the image to the right. An electric potential on the order of 300 volts is applied between the anode and cathode.

The central spike forms one pole of an electromagnet and is surrounded by an annular space and around that is the other pole of the electromagnet, with a radial magnetic field in-between.

The propellant, such as Xenon gas is fed through the anode, which has numerous small holes in it to act as a gas distributor. Xenon propellant is used because of its high molecular weight and low ionization potential. As the neutral xenon atoms diffuse into the channel of the thruster, they are ionized by collisions with high energy circulating electrons (10–20 eV or 100,000 to 250,000 °C). Once ionised the xenon ions typically have a charge of +1 though a small fraction (~10%) are +2.

The xenon ions are then accelerated by the electric field between the anode and the cathode. The ions quickly reach speeds of around 15,000 m/s for a specific impulse of 1,500 seconds (15 kN·s/kg). Upon exiting however, the ions pull an equal number of electrons with them, creating a plume with no net charge.

The axial magnetic field is designed to be strong enough to substantially deflect the low-mass electrons, but not the high-mass ions which have a much larger gyroradius and are hardly impeded. The majority of electrons are thus stuck orbiting in the region of high radial magnetic field near the thruster exit plane, trapped in "E"×"B" (axial electric field and radial magnetic field). This orbital rotation of the electrons is a circulating Hall current and it is from this that the Hall thruster gets its name. Collisions and instabilities allow some of the electrons to be freed from the magnetic field and they drift towards the anode.

About 30% of the discharge current is an electron current which doesn't produce thrust, which limits the energetic efficiency of the thruster; the other 70% of the current is in the ions. Because the majority of electrons are trapped in the Hall current, they have a long residence time inside the thruster and are able to ionize almost all (~90%) of the xenon propellant. The ionization efficiency of the thruster is thus around 90%, while the discharge current efficiency is around 70% for a combined thruster efficiency of around 63% (= 90% × 70%).

The magnetic field thus ensures that the discharge power predominately goes into accelerating the xenon propellant and not the electrons, and the thruster turns out to be reasonably efficient.

Compared to chemical rockets the thrust is very small, on the order of 80 mN for a typical thruster. For comparison, the weight of a coin like the U.S. quarter or a 20-cent Euro coin is approximately 60 mN.

However, Hall thrusters operate at the high specific impulses that is achieved with ion thrusters. One particular advantage of Hall thrusters, as compared to an ion thruster, is that the generation and acceleration of the ions takes place in a quasi-neutral plasma and so there is no Child-Langmuir charge (space charge) saturated current limitation on the thrust density, and thus thrust is high for electrically accelerated thrusters.

Another advantage is that these thrusters can use a wider variety of propellants supplied to the anode, even oxygen, although something easily ionised is needed at the cathode. [ [http://www.permanent.com/t-el-iov.htm#how-russ PERMANENT - Transportation - Electric Propulsion ] ] One propellant that is starting to be used is liquid bismuth due to its low cost, high mass and low partial pressure.


The solar electric propulsion system of the European Space Agency's SMART-1 spacecraft used a Hall thruster (Snecma PPS-1350-G). Over the course of 13 months and 289 engine pulses it had consumed about 58.8 kg of xenon and produced a delta-v of 2737 m/s (46.5 m/s per kg xenon).

See also

* Ion thruster
** Electrostatic ion thruster
** Field Emission Electric Propulsion
** Pulsed inductive thruster


External links

* [http://www.busek.com/halleffect.html Busek (Natick, MA USA)- Hall Thruster Vendor]
* [http://users.gazinter.net/fakel/index_eng.html Experimental Design Bureau Fakel (Kaliningrad, Russia) - Hall Thruster Vendor]
* [http://www.aerojet.com/capabilities/spacecraft.php Aerojet (Redmond, WA USA) - Hall Thruster Vendor]
* [http://www.pwrengineering.com/dataresources/het-ppr-070903.pdf Pratt & Whitney Rocketdyne (West Palm Beach, FL USA) - Hall Thruster Vendor]
* [http://web.mit.edu/aeroastro/www/labs/SPL/ MIT Space Propulsion Laboratory]
* [http://www.me.mtu.edu/researchAreas/isp/ Michigan Tech. Univ. Ion Space Propulsion Laboratory]
* [http://www.engin.umich.edu/dept/aero/spacelab/ University of Michigan Plasmadynamics and Electric Propulsion Laboratory (PEPL)]
* [http://www.jetaerospace.org/Thruster/Hall/ Jet Aerospace Miniaturized Hall Thruster]
* [http://www.grc.nasa.gov/WWW/hall/ NASA Glenn Research Center Hall Thruster Program]
* [http://htx.pppl.gov/ht.html Princeton Plasma Physics Laboratory page on Hall Thrusters]
* [http://sci.esa.int/science-e/www/object/index.cfm?fobjectid=34201&fbodylongid=1538 ESA page on Hall thrusters]

Wikimedia Foundation. 2010.

Игры ⚽ Нужно сделать НИР?

Look at other dictionaries:

  • Hall effect — For the Colombian band, see The Hall Effect (band). The Hall effect is the production of a voltage difference (the Hall voltage) across an electrical conductor, transverse to an electric current in the conductor and a magnetic field perpendicular …   Wikipedia

  • Thruster — A thruster is a small propulsive device used by spacecraft and watercraft for station keeping, attitude control, or long duration low thrust acceleration.Thruster (surfing) is a surfboard fin design.Spacecraft thrusters,*Electrohydrodynamic… …   Wikipedia

  • Ion thruster — An ion thruster is a form of electric propulsion used for spacecraft propulsion that creates thrust by accelerating ions. Ion thrusters are characterized by how they accelerate the ions, using either electrostatic or electromagnetic force.… …   Wikipedia

  • Magnetoplasmadynamic thruster — An MPD thruster during test firing The Magnetoplasmadynamic (MPD) thruster (MPDT) is a form of electrically powered spacecraft propulsion which uses the Lorentz force (a force resulting from the interaction between a magnetic field and an… …   Wikipedia

  • Electrohydrodynamic thruster — EHD thruster stands for electrohydrodynamic thruster. This is the general and most appropriate term used for high voltage devices that propel air or other fluids, to achieve relative motion between the propulsion device and the propelled fluid.… …   Wikipedia

  • Electrodeless plasma thruster — The electrodeless plasma thruster is a spacecraft propulsion engine. It was created by Mr. Gregory Emsellem based on technology developed by French Atomic Energy Commission scientist Dr Richard Geller and Dr. Terenzio Consoli, for high speed… …   Wikipedia

  • Electrostatic ion thruster — The electrostatic ion thruster is a kind of design for ion thrusters (a kind of highly efficient low thrust spacecraft propulsion running on electrical power). These designs use high voltage electrodes in order to accelerate ions with… …   Wikipedia

  • Colloid thruster — 20 μN colloid thruster system.[1] A colloid thruster is a type of thruster which uses electrostatic acceleration of charged liquid droplets for propulsion. It is closely related to electrospray ionization and other hydrodynamic spraying processes …   Wikipedia

  • Pulsed inductive thruster — Pulsed inductive thrusters (or PITs) are a form of ion thruster, used in spacecraft propulsion. A PIT uses perpendicular electric and magnetic fields to accelerate a propellant. A nozzle releases a puff of gas (usually ammonia or argon) which… …   Wikipedia

  • Pulsed plasma thruster — Pulsed plasma thrusters are a method of spacecraft propulsion which use an arc of electric current adjacent to a solid propellant, to produce a quick and repeatable burst of impulse. PPTs are excellent for attitude control, and for main… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”