Spatial cutoff frequency

Spatial cutoff frequency

In optics, spatial cutoff frequency is a precise way to quantify the smallest object resolvable by an optical system. Due to diffraction at the image plane, all optical systems act as low pass filters with a finite ability to resolve detail. If it were not for the effects of diffraction, a 2" aperture telescope could theoretically be used to read newspapers on a planet circling Alpha Centauri, over four light-years distant. Unfortunately, the wave nature of light will never permit this to happen.

The spatial cutoff frequency for a perfectly corrected optical system is given by

:f_o={1 over {lambda imes mathrm{(f/#)} mathrm{cycles/millimeter} , where lambda is the wavelength expressed in millimeters and f/# is the lens' focal ratio. As an example, a telescope having an f/6 objective and imaging at 0.55 micrometers has a spatial cutoff frequency of 303 cycles/millimeter. High-resolution black and white film is capable of resolving details on the film as small as 3 micrometers or smaller, thus its cutoff frequency is about 150 cycles/millimeter. So, the telescope's optical resolution is about twice that of high-resolution film, and a crisp, sharp picture would result (provided focus is perfect and atmospheric turbulence is at a minimum).

This formula gives the best-case resolution performance and is valid only for perfect optical systems. The presence of aberrations reduces image contrast and can effectively reduce the system spatial cutoff frequency if the image contrast falls below the ability of the imaging device to discern.

See also

* Modulation transfer function

References

*Goodman, J.A., "Introduction to Fourier Optics", McGraw Hill, 1969.


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • Frequency — For other uses, see Frequency (disambiguation). Three cyclically flashing lights, from lowest frequency (top) to highest frequency (bottom). f is the frequency in hertz (Hz), meaning the number of cycles per second. T is the period in seconds (s) …   Wikipedia

  • Modulation transfer function (infrared imaging) — The Modulation Transfer Function (MTF) is used to approximate the position of best focus of an infrared imaging system. In an imaging system, best focus is typically achieved when the MTF is between 0.4 and 0.6; most often at 0.5 (50% cutoff… …   Wikipedia

  • Waveguide — This page is about waveguides in the most general sense. For ordinary metal pipe waveguides, Waveguide (electromagnetism). For optical waveguides, see Waveguide (optics). A section of flexible waveguide with a pressurizable flange …   Wikipedia

  • High-pass filter — A high pass filter is a filter that passes high frequencies well, but attenuates (reduces the amplitude of) frequencies lower than the cutoff frequency. The actual amount of attenuation for each frequency varies from filter to filter. It is… …   Wikipedia

  • Comparison of analog and digital recording — This article compares the two ways in which sound is recorded and stored. Actual sound waves consist of continuous variations in air pressure. Representations of these signals can be recorded using either digital or analog techniques. An analog… …   Wikipedia

  • Nyquist–Shannon sampling theorem — Fig.1: Hypothetical spectrum of a bandlimited signal as a function of frequency The Nyquist–Shannon sampling theorem, after Harry Nyquist and Claude Shannon, is a fundamental result in the field of information theory, in particular… …   Wikipedia

  • Transfer function — A transfer function (also known as the system function[1] or network function) is a mathematical representation, in terms of spatial or temporal frequency, of the relation between the input and output of a linear time invariant system. With… …   Wikipedia

  • Superlens — A superlens, super lens or perfect lens is a lens which uses metamaterials to go beyond the diffraction limit. The diffraction limit is an inherent limitation in conventional optical devices or lenses.[1] In 2000, a type of lens was proposed,… …   Wikipedia

  • Earth Sciences — ▪ 2009 Introduction Geology and Geochemistry       The theme of the 33rd International Geological Congress, which was held in Norway in August 2008, was “Earth System Science: Foundation for Sustainable Development.” It was attended by nearly… …   Universalium

  • language — /lang gwij/, n. 1. a body of words and the systems for their use common to a people who are of the same community or nation, the same geographical area, or the same cultural tradition: the two languages of Belgium; a Bantu language; the French… …   Universalium

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”