BMW V12 LMR

The BMW V12 LMR was a Le Mans Prototype built for sports car racing from 1999 to 2000. The car was built through an alliance between BMW Motorsport and WilliamsF1, and was the successor to the failed BMW V12 LM of 1998. It is famous for being BMW's only overall victor of the 24 Hours of Le Mans.

Development

Racing car


Category = Le Mans Prototype
Car_name = BMW V12 LMR
Constructor = flagicon|Germany BMW Motorsport
flagicon|United Kingdom WilliamsF1
Team = flagicon|Germany BMW Motorsport
flagicon|Germany Schnitzer Motorsport
Designer =
Drivers = flagicon|Finland J.J. Lehto
flagicon|Germany Jörg Müller
flagicon|United Kingdom Steve Soper
flagicon|Germany Joachim Winkelhock
flagicon|Italy Pierluigi Martini
flagicon|France Yannick Dalmas
flagicon|Denmark Tom Kristensen
flagicon|United States Bill Auberlen
flagicon|France Jean-Marc Gounon
Test Drivers =
Chassis = carbon and aluminum honeycomb monocoque
Front suspension =
Rear suspension =
Engine position = mid, longitudinally mounted
Engine name = BMW S70
Capacity = 6100cc
Turbo/NA = Naturally-aspirated
Configuration = V12.
Gearbox name = X-Trac
Gears = 6-speed
Type = sequential manual
Differential =
Tyres = Michelin radial
Fuel = Petrobras | Debut = 1999 12 Hours of Sebring
Races = 18
Cons_champ = 0
Drivers_champ = 0
Wins = 7
Poles = 4
Fastest_laps = 3
Last_season = 2000
Immediately following the 1998 24 Hours of Le Mans in which both BMW V12 LMs had failed to finish due to mechanical difficulties and a slow pace caused by aerodynamic inefficiencies, BMW Motorsport made the decision to radically revamp their sportscar project and quickly replace the V12 LM with a new car for 1999, the V12 LMR.

The V12 LMR would retain only the basic structures of the V12 LM, while all of the car's bodywork was redone from scratch. The cooling ducts, a major problem on the V12 LM, were moved to the top of the car instead of from the bottom where it had suffered from ambient track heat. Among the more radical design features was the use of a small rollhoop located only behind the driver's seat, instead of a wide rollhoop which covered the entire cockpit. This was done through using a loophole in the ACO's Le Mans prototype regulations. This allowed for less drag as well as less obstruction for the air to the rear wing. A total of four new chassis were built by WilliamsF1 in the United Kingdom.

Internally, the V12 LMR retained the same BMW S70 6.1L V12 as the V12 LM. Also retained was Schnitzer Motorsport, who would run the team not only at the 24 Hours of Le Mans, but also in the new American Le Mans Series for 1999.

Racing History

1999

Debuting at the 12 Hours of Sebring, BMW Motorsport and Schnitzer Motorsport entered a two car team. The cars were immediately fast, taking the pole position in qualifying. During the race, both cars ran towards the front for the first six hours. Unfortunately, V12 LMR chassis #001 suffered a large accident, damaging the car to the point that it would never race again. However, the second V12 LMR was successful in taking the overall win.

From Sebring, the team went back to Europe in order to prepare for the 24 Hours of Le Mans. In early May, at the initial test session for Le Mans, three V12 LMRs appeared. In the tradition of the famous [http://www.bmwworld.com/artcars/ BMW Art Cars] , one of the three cars featured a paint job created by artist Jenny Holzer. Unlike at Sebring, the V12 LMRs would be facing closed cockpit prototypes which were theoretically faster over a single lap yet not as fuel efficient. Even with this apparent set back, a V12 LMR was able to take the 4th fastest lap time over the practice session, behind two Toyota GT-Ones and a Panoz prototype.

For the race itself, only two cars appeared with the Art Car beind dropped from the line-up. In qualifying the two LMRs again showed their speed, taking 3rd and 6th places, again beaten only by the Toyota GT-Ones. During the race the V12 LMRs ran strong, outlasting a large number of closed cockpit competitors who suffered woes, including Mercedes-Benz, Nissan, Toyota, and Audi. In the second half of the race, BMW's main competitors were a pair of open-cockpit Audi R8Rs and the lone remaining Toyota GT-One. Unfortunately, in the closing hours of the race the #17 BMW V12 LMR driven by JJ Lehto crashed heavily in the Porsche Curves section of the track, as a result of a stuck throttle. This left the #15 BMW LMR in the lead, less than a lap ahead of the 2nd place Toyota. The Toyota was catching the BMW in the final hour until it suffered a tire blowout at high speed, allowing the Schnitzer BMW team to solidify their lead. The driving team of Joachim Winkelhock, Pierluigi Martini, and Yannick Dalmas were successful in bringing the V12 LMR home for the victory, a single lap ahead of the GT-One.

The BMW V12 LMR is estimated to put out about 580 hp, which in the 1999 edition of the 24 Hours of Le Mans allowed the German prototype to hit 342 km/h (214 mph) on the Mulsanne Straight.

Following the success of BMW at Le Mans, the team decided to return to North America to finish the American Le Mans Series season. Making their return at Sears Point, the pair of BMWs won again. Over the final four races of the season, the BMWs would take two more victories, losing twice to the American Panoz prototypes. Even with four victories on the season, due to BMW's decision to return to Europe following Sebring and thus miss two ALMS races, BMW failed to take the team's championship, losing to Panoz by a mere two points.

2000

For 2000, BMW's alliance with WilliamsF1 brought the marque into Formula One, with BMW providing the engines for the WilliamsF1 team. It was therefore decided by BMW that the company would concentrate on the worldwide exposure of Formula One for the future, and that they would not return to Le Mans to attempt to follow-up on their victory. However, in order to not see the V12 LMRs go to waste, it was decided that BMW would run the full American Le Mans Series season before the cars were retired.

Starting the season at Sebring, the BMWs suddenly found themselves facing new competition, with Audi debuting their second generation R8 Le Mans prototype. The BMWs found themselves qualified in 5th and 6th, behind both the Audis as well as both Panoz LMPs. During the race, the BMWs were able to outlast the Panozes, but struggled with the Audis. BMW was forced to settle for 3rd and 4th behind both Audis.

For the next two rounds, Audi attempted to perfect their R8 for Le Mans and therefore decided to race their older R8R instead. This allowed BMW to take victory at Charlotte and at the European event at Silverstone. Unfortunately in BMW's home race at the Nürburgring in Germany, the V12 LMR was defeated by a Panoz, although it did beat out an Audi R8.

Returning to America, with Audi having taken victory at Le Mans, the V12 LMR was now forced to finish out the rest of the season fighting the dominant R8. For the next four rounds, BMW could muster no better than second against the Audi, which won every round.

For Petit Le Mans, BMW decided to bring out chassis #004, the Art Car which had only ever ran at Le Mans testing in 1999. The car retained its paintjob from Jenny Holzer. Unfortunately the V12 LMRs suffered during the race, including one of the cars backflipping and flying into the side barriers, as did a Porsche 911 GT1 in the same place 2 years earlier, and the Art Car was the only V12 LMR able to finish, taking a distant 5th place.

In the final two North American rounds of the season, BMW still could not muster a win. It was decided by the team that they would not travel to Australia for the final round of the season, instead retiring the cars and concentrating on their new Formula One partnership. BMW would take second in the teams championship behind the dominant Audi. Unlike the V12 LMs, the V12 LMRs would not be sold to customers after their retirement.

External links

* [http://www.mulsannescorner.com/bmwlmr.html Mulsannes Corner technical analysis of the V12 LMR]
* [http://wspr-racing.com/chassis/grc/ChassisBMW.html BMW V12 LM & V12 LMR chassis numbers]