Motor vehicle type approval

Motor vehicle type approval

The new Framework Directive (Directive 2007/46/EC establishing a framework for the approval of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles)[1] rules approval schemes of the new motor vehicles and their trailers in the European Union:[2]

  • European Community Whole Vehicle Type Approval (ECWVTA), that applies to passenger cars. Over the next few years, ECWVTA will be extended to cover all new road vehicles and trailers.[3]
  • United Nations Economic Commission for Europe (UNECE) regulations.
  • National Small Series Type Approval (NSSTA) - the key advantages of this scheme are that some technical requirements may be reduced in comparison with ECWVTA; however, the number of vehicles that can be manufactured are limited.
  • Individual Vehicle Approval (IVA)

The European Commission shall adopt amendments to this Directive which are necessary to lay down technical requirements for small series vehicles, vehicles approved under the individual approval procedure and 'special purpose vehicles'.[1]

UNECE Regulations to which the Community has acceded and which are listed in Part I of Annex IV and in Annex XI of the frame Directive are part of the EC type-approval of a vehicle in the same way as the separate directives or regulations. They shall apply to the categories of vehicles listed in this Annexes. When the Community has decided to apply on a compulsory basis a UNECE Regulation for the purpose of EC vehicle type-approval in accordance with Article 4(4) of Decision 97/836/EC,[4] the annexes to the Frame Directive shall be amended as appropriate in accordance with the regulatory procedure with scrutiny referred to in Article 40(2) .The UNECE Regulations listed in Part II of Annex IV are recognised as being equivalent to the corresponding separate directives or regulations in as much as they share the same scope and subject matter. Where the Community has decided to applya new UNECE Regulation or a UNECE Regulation as amended, Part II of Annex IV shall be amended as appropriate.[5]

Automotive EC Directives and ECE Regulations require third party approval - testing, certification and production conformity assessment by an independent body. Each Member State is required to appoint an Approval Authority to issue the approvals, and a Technical Service to carry out the testing to the Directives and Regulations.

An approval issued by one Authority will be accepted in all the Member States.[6] If a vehicle is produced in a very small quantity (e.g. M1 maximum 75 per year), single EU Member States can grant exception on a discretionary basis, however the validity of the Type Approval is limited to the boundaries of those Nations which concede to it.[7]

Cornerstones of the Type Approval process are:[7]

  • Application by the vehicle or component manufacturer
  • Testing by a technical service
  • Granting of the approval by an Approval Authority
  • Conformity of Production by the manufacturer in agreement with the Approval Authority
  • Certificate of Conformity by the manufacturer for the end-user

Theare are multiple methods of type-approval:[8]

  • multi-stage Type Approval: a the procedure whereby one or more Member States certify that, depending on the state of completion, an incomplete or completed type of vehicle satisfies the relevant administrative provisions and technical requirements of this Directive
  • step-by-step Type Approval: a vehicle approval procedure consisting in the step-by-step collection of the whole set of EC type-approval certificates for the systems, components and separate technical units relating to the vehicle, and which leads, at the final stage, to the approval of the whole vehicle
    • mixed Type Approval: means a step-by-step Type Approval procedure for which one or more system approvals are achieved during the final stage of the approval of the whole vehicle, without it being necessary to issue the EC Type Approval certificates for those systems
  • single-step Type Approval: a procedure consisting in the approval of a vehicle as a whole by means of a single operation

EC Whole Vehicle Type Approval (also called Pan European Type Approval) is to prevent trade barriers, and at the same time guarantee the level of safety and restricted environmental influence of a vehicle. Thanks to that, the car can be registered in each European member state without additional national tests or approval. This harmonisation results in reduced costs and lead time for the manufacturer, importer as well as the consumer.[9] Mandatory compliance date for ECWVTA for M1 vehicles was 2009-04-29.[10]

In the United Kingdom, this function is performed by the Vehicle Certification Agency (VCA).[11] This body has the power to issue International Organization for Standardization (ISO) certifications.

Contents

Electric vehicles

Electric vehicles are rules by Regulation No 100 of the Economic Commission for Europe of the United Nations (UNECE) — Uniform provisions concerning the approval of battery electric vehicles with regard to specific requirements for the construction, functional safety and hydrogen emission[12]

See also

  • Retrofitting

External links

References

  1. ^ a b "Directive 2007/46/EC of the European Parliament and of the Council of 5 September 2007 establishing a framework for the approval of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles (Framework Directive) Text with EEA relevance". eur-lex.europa.eu - Access to European Union law. publications.europa.eu - Publications Office of the European Union. 09/10/2007. http://eur-lex.europa.eu/LexUriServ/LexUriServ.do?uri=CELEX:32007L0046:EN:NOT. Retrieved 27 September 2009. 
  2. ^ "Motor Vehicle Approval Schemes". Ireland: National Standards Authority of Ireland. NSAI.ie. 1 April 2009. http://www.nsai.ie/index.cfm/area/page/information/motorvehicleapproval. Retrieved 27 September 2009. [dead link]
  3. ^ "EC Whole Vehicle Type Approval - Introduction". UK Vehicle Certification Agency, Department for Transport. VCA.gov.uk. 24 September 2009. http://www.vca.gov.uk/vehicletype/ecwvta-framework-directive.asp. Retrieved 27 September 2009. 
  4. ^ EUR-Lex – Decision 97/836 - EN
  5. ^ http://eur-lex.europa.eu/LexUriServ/LexUriServ.do?uri=CELEX:32007L0046:EN:NOT
  6. ^ Type Approval for Cars
  7. ^ a b http://ec.europa.eu/enterprise/automotive/speeches_presentations/brussels_15052009.pdf
  8. ^ Directive 2007/46
  9. ^ Minister Eurlings of the Netherland Ministry of Transport was handing over the first ever Pan European EV homologation certificate – to Think. / Press releases / Press Materia...
  10. ^ http://www.rsa.ie/SERVICES/upload/File/ECWVTA/implementation%20dates%20for%20ECWVTA.pdf
  11. ^ Vehicle Type Approval and ISO Certification through VCA worldwide
  12. ^ http://eur-lex.europa.eu/LexUriServ/LexUriServ.do?uri=CELEX:42009X0214%2801%29:EN:NOT

Wikimedia Foundation. 2010.

Игры ⚽ Нужно сделать НИР?

Look at other dictionaries:

  • Type approval — is granted to a product that meets a minimum set of regulatory, technical and safety requirements. Generally, type approval is required before a product is allowed to be sold in a particular country, so the requirements for a given product will… …   Wikipedia

  • Vehicle — Vehicles, derived from the Latin word, vehiculum , are non living means of transport. Most often they are manufactured (e.g. bicycles, cars, motorcycles, trains, ships, boats, and aircraft), although some other means of transport which are not… …   Wikipedia

  • Vehicle registration plates of the United Kingdom — See also: Vehicle registration plate British number plates (1983 – 2001 numbering system), as observed in 2004 (last character of registration not shown); bottom plate lacks the EU band, which is not compulsory. Vehicle registration plates are… …   Wikipedia

  • Vehicle registration — is the (usually) compulsory registration of a vehicle with a government authority. Vehicle registration s purpose is to establish clear ownership and to tax motorists or vehicle owners. While almost all vehicles are uniquely identified by a… …   Wikipedia

  • Vehicle inspection — is a procedure mandated by national or subnational governments in many countries, in which a vehicle is inspected to ensure that it conforms to regulations governing safety, emissions, or both. Inspection can be required at various times, e.g.,… …   Wikipedia

  • Vehicle Certification Agency — (VCA) is an Executive Agency of the UK Department for Transport and the UK’s type approval authority and a leading certification body. VCA have been supporting the motor industry since the early 1970’s, with offices both in the UK, and North… …   Wikipedia

  • Vehicle registration plate — A vehicle registration plate is a metal or plastic plate attached to a motor vehicle or trailer for official identification purposes. The registration identifier is a numeric or alphanumeric code that uniquely identifies the vehicle within the… …   Wikipedia

  • Vehicle registration plates of Germany — German car number plates ( Kfz Kennzeichen ) show the place where the car carrying them is registered. Whenever a person changes their main place of residence in Germany, or buys a new car, they are required to buy new number plates. Number… …   Wikipedia

  • Electric vehicle — Sustainable energy Renewable energy …   Wikipedia

  • Great Wall Motor — Co Ltd 长城汽车 or 長城汽車 Type Public Traded as SEHK: 2333 …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”