- Upholstery frame
In furniture-making, the upholstery frame of a piece of furniture gives the structural support and determines the basic shape [Cite book|last = Rix|first = J.|coauthors = S. Haas, and J. Teixeira, editors|title = Virtual Prototyping|date = 1995|publisher = Springer|ISBN=0412721600] of the upholstered furniture. The frame may be a basic piece of wooden furniture prior to its being upholstered. Like a finished piece of furniture prior to the upholstering, the frame establishes the final quality, including its durability, and sets limits upon the final design, padding, cushioning, or cover. Frames are made variously of solid wood,
engineered wood products, a variety ofpolymer s, andmetal s.Solid for upholstery frames may be of various kinds, including
hardwood s andsoftwood s. The type of wood depends upon the final piece, inlcuding function, style, and quality.Hardwoods destined for upholstery frames is primarily air dried. [{cite web|last = Denig|first = Joseph|coauthors = Eugene M. Wengert, William T. Simpson|title = Dryinghardwood lumber|url = http://www.woodweb.com/knowledge_base/fpl_pdfs/fplgtr118.pdf |publisher = U.S. Department of Agriculture, Forest Service, Forest Products Laboratory|date = 2000] Hardwood frames for high end furniture are often constructed from kiln-dried mixed hardwoods.
Beech ,birch , whiteash , andmahogany all have acceptable combinations of stregth, availability (country dependent), workability, and cost to be superior wood products for frame making.White oak ,red oak , andAmerican elm are good, and hardmaple is an acceptable framing wood. Softwoods can make poor frames, but are used in low end furniture manufacturing, particularly with partially upholstered frames on larger pieces in theUnited States . In Scandinavia, better quality softwoods are available and are used with suitable furniture making and upholstery techniques that their use is more common in furniture of a variety of qualities.Kiln drying reduces the moisture content of thelumber , a process which inhibits checking, splitting, and strengthens the finished product.Engineered wood products can be stronger than hardwood because layering methods increase the strength. They are sometimes used just at critical stress areas when maximum strength is needed. Modern furniture making, however, tends to rely upon a combination of engineered woods and solid woods in frame making. Engineered wood products commonly used in furniture making include
plywood ,hardboard ,millboard ,chipboard , andmedium-density fiberboard .cite book|last = James|first = David| Upholstery: A Complete Course|publisher = Guild of Master Craftsman Publications, Limited= 1999|ISBN= 9781861081186]Wooden frame joints are often double doweled, which means that round wooden pegs are fitted into holes in two adjacent frame sections and glued.
Epoxy coatedstaple s andgang nail s are also commonly used. The gang nail is a metal plate with saw teeth, which immobilizes the joint when it is pressed into the wood with ahydraulic press . Major joints need the additional support of corner blocks, which should be glued and screwed into place.Since lumber costs increase rapidly with increasing board thickness, some manufacturers may hold down frame coasts by skimping at the precise point where ample strength is most important. The engineering principle involved is that strength varies directly with rail width and with the cube of thickness. If we assume that a certain 1î x 1î beam will sustain a load of 100 pounds, then a beam 1î thick and 2î wide will sustain 200 pounds. An old rule of thumb suggests that rails of 3î or more in width should be 1 1/8thî thick, while rails less than 3î wide should exceed 11/8thî in thickness.
References
Wikimedia Foundation. 2010.