Single-circuit transmission line

Single-circuit transmission line

A single-circuit transmission line is a transmission line where one circuit is carried on a tower line.

For a three-phase system, this implies that each tower supports and insulates three conductors.

Construction

For a single wood pole structure, a pole is placed in the ground, then three crossarms extend from this, either staggered or all to one side. The insulators are attached to the crossarms.

For an "H"-type wood pole structure, two poles are placed in the ground, then a crossbar is placed on top of these, extending to both sides. The insulators are attached at the ends and in the middle.

For a lattice tower structure, there are two common forms.

One has a pyramidal base, then a vertical section, where three crossarms extend out, typically staggered. The insulators are attached to the crossarms.

Another has a pyramidal base, which extends to four support points. On top of this a horizontal truss-like structure is placed. The insulators are attached to this.

Steel pole structures follow the wood pole structures in an obvious way.

In all cases, there are usually one or two ground wires attached to the top of the poles or towers.


Wikimedia Foundation. 2010.

Игры ⚽ Нужно сделать НИР?

Look at other dictionaries:

  • Double-circuit transmission line — A double circuit transmission line is a transmission line where two circuits are carried on a tower line.For a three phase system, this implies that each tower supports and insulates six conductors.ConstructionFor a lattice tower structure, these …   Wikipedia

  • Transmission line — This article is about the radio frequency transmission line. For the power transmission line, see electric power transmission. In communications and electronic engineering, a transmission line is a specialized cable designed to carry alternating… …   Wikipedia

  • Single-circuit line —   A transmission line with one electric circuit. For three phase supply, a single circuit requires at least three conductors, one per phase.   U.S. Dept. of Energy, Energy Information Administration s Energy Glossary …   Energy terms

  • Single-wire earth return — (SWER) or single wire ground return is a single wire transmission line for supplying single phase electrical power from an electrical grid to remote areas at low cost. It is principally used for rural electrification, but also finds use for… …   Wikipedia

  • Overhead power line — This article is about power lines for general transmission of electrical power. For overhead lines used to power road and rail vehicles, see Overhead lines. Transmission lines in Lund, Sweden …   Wikipedia

  • single-ended — /sing geuhl en did/, adj. 1. (of a boiler) fired from one end only. 2. Elect. (of a circuit or transmission line) unbalanced, as when one part of a circuit is grounded. * * * …   Universalium

  • Electric power transmission — Electric transmission redirects here. For vehicle transmissions, see diesel electric transmission. 400 kV high tension transmission lines near Madrid Electric power transmission or high voltage electric transmission is the bulk transfer of… …   Wikipedia

  • Power line communication — or power line carrier (PLC), also known as power line digital subscriber line (PDSL), mains communication, power line telecom (PLT), power line networking (PLN), or broadband over power lines (BPL) are systems for carrying data on a conductor… …   Wikipedia

  • Goubou line — A Goubau line, Goubou line, or G line for short, is a single wire transmission line intended for use at UHF and microwave wavelengths. DescriptionThe Goubau line itself consists of a single conductor coated with dielectric material. Coupling to… …   Wikipedia

  • Transmission Voie-Machine — (TVM), or track to train transmission , is a form of in cab signalling used on lignes à grande vitesse (high speed railway lines based on the French TGV system) that differs considerably from signalling on conventional railway lines. Because TGV… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”