Load factor (aerodynamics)

Load factor (aerodynamics)

Load factor is the ratio of the lift on an aircraft to the weight of the aircraft.Clancy, L.J., "Aerodynamics", section 5.22] Hurt, H.H., "Aerodynamics for Naval Aviators", page 37] The load factor is expressed in multiples of g where one g represents conditions in straight and level flight. In straight and level flight the lift is equal to the weight so the ratio of lift to weight is one, and the load factor is one g. Load factors greater than one, and less than one, are achieved by maneuvering of the aircraft by the pilot, and by atmospheric gusts. [McCormick, Barnes W., "Aerodynamics, Aeronautics and Flight Mechanics", p.464-468]

In the definition of load factor, lift on an aircraft is not simply the lift generated by the wing. Lift on an aircraft is the vector sum of the lift generated by the wing and fuselage plus the lift generated by the tailplane which is almost always downwards. Lift on an aircraft is therefore almost always less than the lift generated by the wing and fuselage. [Clancy, L.J., "Aerodynamics", page 395]

Load factor is the ratio of two forces so it is dimensionless. Flight with a load factor of one does not mean the aircraft is accelerating at 9.8 m/s2. It means the lift on the aircraft is the same as in straight and level flight.

The load factor may be positive or negative.

Positive Load Factor

During straight and level flight the "right way up", the load factor is 1g. [Clancy, L.J., "Aerodynamics", page 90] In a turn, and during some aerobatic maneuvers, the load factor is greater than 1g. Whenever the load factor is greater than zero the load factor is said to be positive.

In turning flight the load factor is greater than +1g. For example, the load factor is +2g in a turn with 60° angle of bank. In a balanced turn in which the angle of bank is heta the load factor n is related to the cosine of heta: [Clancy, L.J., "Aerodynamics", page 407] :n = frac {1}{cos, heta}

Negative Load Factor

If the aircraft is flown "upside-down" (inverted), or in aerobatic maneuvers in which the pilot pushes forward strongly on the elevator control, the lift on the aircraft acts in the opposite direction to normal. The load factor in these situations is negative.

Design standards

Excessive load factor must be avoided because of the possibility of exceeding the structural strength of the aircraft. The maximum load factors, both positive and negative, applicable to an aircraft are usually specified in the Pilots Operating Handbook or Flight Manual.

The maximum load factors for different classes of airplane are typically:
*In airline airplanes, from -1g to +2.5g
*In light airplanes, from -1.5g to +3.8g
*In acrobatic airplanes, from -3g to +6gThese limits are specified in airplane design standards such as Parts 23 and 25 of the US Federal Aviation Regulations.

Most helicopters are not capable of safe flight with a negative load factor so it is important for pilots of such helicopters to avoid maneuvers that will cause zero or negative load factors.

Human perception of load factor

When the load factor is +1g, all occupants of the aircraft feel that their weight is normal. When the load factor is greater than +1g all occupants feel heavier than usual. For example, in a +2g maneuver all occupants feel that their weight is twice normal. When the load factor is zero, or very small, all occupants feel weightless. [Clancy, L.J., "Aerodynamics", page 398] When the load factor is negative, all occupants feel they are upside down.

Human beings have limited ability to withstand a load factor significantly greater than 1g, both positive and negative. Unmanned aerial vehicles can be designed for much greater load factors, both positive and negative, than conventional aircraft because these vehicles can be used in maneuvers which would be incapacitating for a human pilot.

References

* Clancy, L.J. (1975), "Aerodynamics", Pitman Publishing Limited, London ISBN 0 273 01120 0
* Hurt, H.H. (1960), "Aerodynamics for Naval Aviators", A National Flightshop Reprint, Florida
* McCormick, Barnes W., (1979), "Aerodynamics, Aeronautics and Flight Mechanics", John Wiley & Sons, New York ISBN 0-471-03032-5

Notes

See also

* g-force
* Spin (flight)
* Banked turn
* Aircraft dynamic modes
* Stick pusher
* Coffin corner (aviation)


Wikimedia Foundation. 2010.

Игры ⚽ Нужна курсовая?

Look at other dictionaries:

  • Load factor — may refer to:* Capacity factor, the ratio of the actual output of a power plant over a period of time and its output if it had operated a full capacity of that time period * Load factor (aerodynamics), n, is the vector expressed by the ratio of… …   Wikipedia

  • G force (disambiguation) — The term g force refers to a measure of the apparent acceleration acting on a body measured in multiples of the sea level acceleration due to gravity on Earth.Other uses include:* G Force (film) * G Force (Commodore 64 video game) * G Force… …   Wikipedia

  • Stall (flight) — For other uses, see stall. In fluid dynamics, a stall is a reduction in the lift coefficient generated by a foil as angle of attack increases. This occurs when the critical angle of attack of the foil is exceeded. The critical angle of attack is… …   Wikipedia

  • airplane — /air playn /, n. 1. a heavier than air aircraft kept aloft by the upward thrust exerted by the passing air on its fixed wings and driven by propellers, jet propulsion, etc. 2. any similar heavier than air aircraft, as a glider or helicopter. Also …   Universalium

  • North American P-51 variants — Main article: North American P 51 Mustang Further information: North American A 36, F 82 Twin Mustang The North American P 51 Mustang was an American long range single seat fighter aircraft that entered service with Allied air forces in the… …   Wikipedia

  • P-51 Mustang — infobox Aircraft name = P 51 Mustang type = Fighter manufacturer =North American Aviation caption = North American P 51 Mustangs of the 375th Fighter Squadron, 361st FG, summer 1944 first flight =26 October 1940 introduction =1942 retired =1957,… …   Wikipedia

  • Flight envelope — diagram. In aerodynamics, the flight envelope or performance envelope of an aircraft refers to the capabilities of a design in terms of airspeed and load factor or altitude.[1][2 …   Wikipedia

  • Flight control surfaces — Aircraft flight control surfaces allow a pilot to adjust and control the aircraft s flight attitude.Development of an effective set of flight controls was a critical advance in the development of the aircraft. Early efforts at fixed wing aircraft …   Wikipedia

  • Aircraft flight mechanics — In aeronautics, aircraft flight mechanics is the study of the forces that act on an aircraft in flight, and the way the aircraft responds to those forces. [Clancy, L.J. Aerodynamics . Section 14.1] Aircraft flight mechanics are relevant to… …   Wikipedia

  • Coffin corner (aviation) — The coffin corner (or Q corner) is the altitude at or near which a fast fixed wing aircraft s stall speed is equal to the critical Mach number, at a given gross weight and G force loading. At this altitude the airplane becomes nearly impossible… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”