Beverage antenna

Beverage antenna

The Beverage Antenna is a relatively inexpensive but very effective long wire receiving antenna used by amateur radio, shortwave listening, and longwave radio DXers and military applications. Harold H. Beverage experimented with receiving antennas similar to the Beverage antenna in 1919 at the [ Cliffs Naval Radio Station] . [ [ End of an Era: NSGA Winter Harbor to Close Its Doors ] ] [ [ Radio NBD, Otter Cliffs, Maine (circa 1917-1919) - from Les Smallwood, CTRCS, USN Retired ] ] By 1921, Beverage long wave receiving antennas up to nine miles (14 km) long had been installed at RCA's [ Riverhead, New York] , [ Belfast, Maine] , [ Belmar, New Jersey] , and [ Chatham, Massachusetts] receiver stations. The antenna was patented in 1921 and named for its inventor Harold H. Beverage. Perhaps the largest Beverage antenna -- an array of [ phased Beverages] three miles (5 km) long and two miles (3 km) wide -- was built by AT&T in Houlton, Maine for the [ transatlantic telephone system] opened in 1927.

While these antennas provide excellent directivity, a large amount of space is required. Beverage antennas are highly directional and physically far too large to be practically rotated so installations often use multiple antennas to provide a choice of azimuthal coverage.

A Beverage consists of a wire one or two wavelengths long (hundreds of feet at HF to several kilometres for longwave). A resistor connected to a ground rod terminates the end of the antenna pointed to the target area, a 470 ohm non-inductive resistor provides excellent results for most soils. A 50 or 75 ohm coaxial transmission connects the receiver to the opposite end of the antenna through an impedance-matching transformer. Some Beverage antennas use a two-wire design that allows reception in two directions from a single Beverage antenna. Other designs use sloped ends where the center of the antenna is six to eight feet high and both ends of the antenna gradually slope downwards towards the termination resistor and matching transformer.

Technical Description

Harold Beverage discovered in 1920 that an otherwise nearly bidirectional long wire antenna becomes unidirectional by placing it close to the lossy earth and by terminating one end of the wire with a non-inductive resistor with a resistance approximately matched to the surge impedance of the antenna. This was the fundamental discovery in his 1921 patent.

The Beverage Antenna relies on "wave tilt" for its directive properties. At low and medium frequencies, a vertically polarised radio frequency electromagnetic wave travelling close to the surface of the earth with finite ground conductivity sustains a loss that produces an electric field component parallel to the earth's surface. If a wire is placed close to the earth and approximately at a right angle to the wave front, the incident wave generates RF currents travelling along the wire, propagating from the near end of the wire to the far end of the wire. The RF currents travelling along the wire add in phase and amplitude throughout the length of the wire, producing maximum signal strength at the far end of the antenna where a receiver is typically connected. RF signals arriving from the receiver-end of the wire also increase in strength as they travel to end of the antenna terminated in a resistor, where most of the energy propagating in that direction is absorbed.

Radio waves propagate by the ionosphere at medium or high frequencies (MF or HF) typically arrive at the earth's surface with wave tilts of approximately 5 to 45 degrees. Ionospheric wave tilt allows the directivity inducing mechanism described above to produce excellent directivity in Beverage antennas operated at MF or HF.

While Beverage antennas have excellent directivity, because they are close to lossy earth they do not produce absolute gain (typically -20 to -10 dBi). This is rarely a problem, because the antenna is used at frequencies where there are high levels of atmospheric radio noise. The antenna has very low radiation resistance (less than one ohm) and will rarely be utilised for transmitting. The Beverage antenna is a popular receiving antenna because it offers excellent directivity over a broad bandwidth, albeit with relatively large size.

Directivity is a function of the length of the antenna. While directivity begins to develop at a length of only 0.25 wavelength, directivity becomes more significant at one wavelength and improves steadily until the antenna length reaches a length of about two wavelengths. Its generally accepted among Beverage antenna experts that directivity no longer improves when the antenna is longer than two wavelengths. Beverages longer than two wavelengths suffer from the phase incoherency of the incoming waves over distances of several wavelengths, resulting in phase incoherency of the currents induced in the antenna that degrades the directivity of the antenna.

The Beverage antenna is most frequently deployed as a single wire. A dual wire variant is sometimes utilised for rearward null steering or for bidirectional switching. The antenna can also be implemented as an array of two to 128 or more elements in broadside, endfire, and staggered configurations offering significantly improved directivity otherwise very difficult to attain at these frequencies. A four element broadside/staggered Beverage array was used by AT&T at their longwave telephone receiver site in Houlton, Maine. Very large phased Beverage arrays of 64 elements or more have been implemented for receiving antennas for Over-the-horizon radar systems.


A single wire Beverage Antenna is typically a single straight copper wire, between one and two wavelengths long, running parallel to the earth's surface from the receiver towards the direction of the desired signal. The wire is suspended by insulated supports approximately two meters above the ground. A 470 ohm non-inductive resistor is installed from the far end of the wire to a ground rod, although this value is not critical.

An impedance matching transformer (typically a 9:1 transformer to match the antenna to a 50 ohm transmission line) is used between the transmission line to the receiver and the antenna feedpoint. As an expediency, the transmission line can be connected directly to the end of the antenna and a ground rod usually with satisfactory results.

ee also

* Antenna (radio)
* Harold Beverage


* [ Patent 1,381,089]


External links

* [ AA3PX Antenna design page]
* [ AMANDX antenna page]
* [ W8JI Beverage antenna construction - definitive guide]
* [ VE4QRP "baby beverage" antenna]
* [ SWDXER] ¨The SWDXER¨ - with general SWL information and radio antenna tips.
* [ Harold H. Beverage article on 200 meter Beverages]
* [ of the AT&T Transoceanic Telephone Receiver Site in Houlton, Maine]
* [ U.S. Naval Radio Station Otter Cliffs]
* [ The Wave Antenna, A New Type of Highly Directive Antenna, Proceedings of the AIEE, February 1923]
* [ Beverage Antennas for High Frequency Communications, Direction Finding and Over the Horizon Radars, Canadian Research Center]
* [ The Wave Antenna, Edmund Laport]

Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Beverage antenna — Beveredžo antena statusas T sritis radioelektronika atitikmenys: angl. Beverage antenna vok. Wellenantenne, f rus. антенна Бевереджа, f pranc. antenne Beverage, f …   Radioelektronikos terminų žodynas

  • Antenna (radio) — Whip antenna on car …   Wikipedia

  • Microstrip antenna — In telecommunication, there are several types of microstrip antennas (also known as printed antennas) the most common of which is the microstrip patch antenna or patch antenna. A patch antenna is a narrowband, wide beam antenna fabricated by… …   Wikipedia

  • Harold Beverage — Infobox Scientist name = Harold Beverage caption = birth date = 14 October 1893 birth place = North Haven, ME death date = 27 January 1993 death place = Port Jefferson, NY residence = Stony Brook, NY nationality = American field = Electrical… …   Wikipedia

  • Parabolic antenna — A parabolic satellite communications antenna at Erdfunkstelle Raisting, the biggest facility for satellite communication in the world, in Raisting, Bavaria, Germany. It has a Cassegrain type feed. A parabolic antenna is an antenna that uses a… …   Wikipedia

  • Dipole antenna — A schematic of a half wave dipole antenna connected to an unbalanced coaxial cable. Better practice is to connect the balanced dipole to the unbalanced line with a balun. A dipole antenna is a radio antenna that can be made of a simple wire, with …   Wikipedia

  • Whip antenna — on car A whip antenna is an antenna consisting of a single straight flexible wire or rod, often mounted above some type of conducting surface called a ground plane.[1] The bottom end of the whip is connected to the radio receiver or transmitter.… …   Wikipedia

  • Discone antenna — Mounted discone antenna designed for VHF and UHF coverage …   Wikipedia

  • Loop antenna — A shortwave loop antenna A loop antenna is a radio antenna consisting of a loop (or loops) of wire, tubing, or other electrical conductor with its ends connected to a balanced transmission line. Within this physical description there are two very …   Wikipedia

  • Monopole antenna — Mast radiator monopole antenna used for broadcasting. AM radio station WARE, Warren, Massachusetts, USA. A monopole antenna is a class of radio antenna consisting of a straight rod shaped conductor, often mounted perpendicularly over some type of …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”