Reduced Gigabit Media Independent Interface

Reduced Gigabit Media Independent Interface

Reduced Gigabit Media Independent Interface (RGMII) specifies a particular interface between an Ethernet MAC and PHY.

RGMII uses half the number of pins as used in the GMII interface. This reduction is achieved by clocking data on both the rising and falling edges of the clock, and by eliminating non-essential signals (carrier-sense and collision-indication). Thus RGMII consists only of: RXC, RD [3:0] , RX_CTL, TXC, TXD [3:0] , and TX_CTL (12 pins, as opposed to GMII's 24).

Unlike GMII, the transmit clock signal is always provided by the MAC on the TXC line, rather than being provided by the PHY for 10/100 Mbit/s operation and by the MAC at 1000 Mbs.

RGMII supports Ethernet speeds of 10 Mbit/s, 100 Mb/s and 1000 Mbit/s.

ee also

* Media Independent Interface (MII)
* Gigabit Media Independent Interface (GMII)

References

*http://www.hp.com/rnd/pdfs/RGMIIv2_0_final_hp.pdf


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • Gigabit Media Independent Interface — (GMII) is an interface between the Media Access Control (MAC) device and the physical layer (PHY). The interface defines speeds up to 1000 Mbit/s, implemented using an eight bit data interface clocked at 125 MHz, and is backwards compatible with… …   Wikipedia

  • Serial Gigabit Media Independent Interface — The Serial Gigabit Media Independent Interface (SGMII) is a sequel of MII, a standard interface used to connect an Ethernet MAC block to a PHY. It is used for Gigabit Ethernet (contrary to Ethernet 10/100 for MII). It differs from GMII by its low …   Wikipedia

  • Media Independent Interface — The Media Independent Interface (MII) was originally defined as a standard interface used to connect a Fast Ethernet (i.e. 100 Mbit/s) MAC block to a PHY chip. The MII design has been extended to support reduced signals and increases speeds.… …   Wikipedia

  • Reduced Media Independent Interface — (RMII) is a standard that addresses the connection of Ethernet physical layer transceivers (PHY) to Ethernet switches. It reduces the number of signals/pins required for connecting to the PHY from 16 (for an MII compliant interface) to between 6… …   Wikipedia

  • Ethernet — An 8P8C modular connector (often called RJ45) commonly used on cat 5 cables in Ethernet networks Ethernet   …   Wikipedia

  • Energy-Efficient Ethernet — Logo of the study group and standard task force Energy Efficient Ethernet is a set of enhancements to the twisted pair and backplane Ethernet family of computer networking standards that will allow for less power consumption during periods of low …   Wikipedia

  • Abkürzungen/Computer — Dies ist eine Liste technischer Abkürzungen, die im IT Bereich verwendet werden. A [nach oben] AA Antialiasing AAA authentication, authorization and accounting, siehe Triple A System AAC Advanced Audio Coding AACS …   Deutsch Wikipedia

  • Liste der Abkürzungen (Computer) — Dies ist eine Liste technischer Abkürzungen, die im IT Bereich verwendet werden. A [nach oben] AA Antialiasing AAA authentication, authorization and accounting, siehe Triple A System AAC Advanced Audio Coding AACS …   Deutsch Wikipedia

  • Liste von Abkürzungen (Computer) — Dies ist eine Liste technischer Abkürzungen, die im IT Bereich verwendet werden. Inhaltsverzeichnis A B C D E F G H I J K L M N O P Q R S T U V W X Y Z siehe auch: Liste von Dateiendu …   Deutsch Wikipedia

  • Interframe gap — Ethernet devices must allow a minimum idle period between transmission of Ethernet frames known as the interframe gap (IFG), interframe spacing, or interpacket gap (IPG). A brief recovery time between frames allows devices to prepare for… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”