Nominal analogue blanking

Nominal analogue blanking

Nominal analog blanking or nominal analogue blanking is the outermost part of the overscan of a standard definition digital television image. It consists of a variable and arbitrary gap of black (or nearly black) pixels at the left and right sides, which correspond to the end and start of the horizontal blanking interval: the front porch at the right side (the end of a line, before the sync pulse), and the back porch at the left side (the start of a line, after the sync pulse and before drawing the next line). Digital television ordinarily contains 720 pixels, but only about 702 (PAL) to 704 (NTSC) of them contain picture signal. The edge may not be clean — some blurring can occur — and the location is arbitrary, since analogue equipment may typically shift the picture sideways in an unexpected amount or direction. Really old analogue equipment can cause the total width of 'active picture' to vary, usually downwards, perhaps to as little as 680.

The exact width is determined by taking the definition of the time required for an active line in PAL or NTSC, and multiplying it by the pixel clock of 13.5MHz of Digital SDTV. PAL is exactly 52μs, so it will equate to exactly 702 pixels.

Notably, screen shapes and aspect ratios were defined in an era of purely analogue broadcasting for TV. This means that any picture with nominal analogue blanking, whether it be 702, around 704, or less, will be — by definition — a 4:3 picture. Therefore when cross-converting into a square-pixel environment (like MPEG-4 and its variants), this width must always scale to 768 (PAL) or 640 (NTSC). This has the outcome of causing a full picture of 720x576 or 720x480 to be wider than 4:3. In fact, a purely digitally sourced SDTV image, with no analogue blanking, will be close to 788x576 or 655x480 once stretched to square pixels.

Standard definition widescreen pictures were also defined in an analogue environment and must also be treated as such. This means that a purely digitally sourced widescreen SDTV image, with no analogue blanking, will be close to 1050x576 or 854x480.

For details, see the technical specifications of overscan amounts.


  • ITU-R BT.601: Studio encoding parameters of digital television for standard 4:3 and wide screen 16:9 aspect ratios
  • ITU-R BT.1700: Characteristics of composite video signals for conventional analogue television systems

See also

Wikimedia Foundation. 2010.

Игры ⚽ Нужно решить контрольную?

Look at other dictionaries:

  • Overscan — is extra image area around the four edges of a video image that may not be seen reliably by the viewer. It exists because television sets in the 1930s through 1970s were highly variable in how the video image was framed within the cathode ray… …   Wikipedia

  • Output power of an analog TV transmitter — Output power of a TV transmitter is the electric power applied to antenna system. There are two definitions: nominal (or peak) and thermal. Contents 1 Power defined in terms of voltage 2 Nominal power of a TV transmitter 3 The thermal power …   Wikipedia

  • NICAM — This article is about a compression form for digital audio. For the media content rating institute, see Netherlands Institute for the Classification of Audiovisual Media. NICAM stands for Near Instantaneous Companded Audio Multiplex. It is an… …   Wikipedia

  • NTSC — This article is about the television system. For the Indonesian government agency, see National Transportation Safety Committee. Television encoding systems by nation; countries using the NTSC system are shown in green. NTSC, named for the… …   Wikipedia

  • PAL — For other uses, see PAL (disambiguation). Television encoding systems by nation; countries using the PAL system are shown in blue. PAL, short for Phase Alternating Line, is an analogue television colour encoding system used in broadcast… …   Wikipedia

  • Terrestrial television — Air TV redirects here. For the anime, see Air (visual novel). Terrestrial television is a mode of television broadcasting which does not involve satellite transmission or cables typically using radio waves through transmitting and receiving… …   Wikipedia

  • 405-line television system — The 405 line monochrome analogue television broadcasting system was the first fully electronic television system to be used in regular broadcasting. It was introduced with the BBC Television Service in 1936, suspended for the duration of World… …   Wikipedia

  • PALplus — is an extension of the PAL analogue broadcasting system for transmitting 16:9 programs without sacrificing vertical resolution. It followed experiences with the HD MAC and D2 MAC, standards that were incompatible with existing receivers but… …   Wikipedia

  • SECAM — SECAM, also written SÉCAM (Séquentiel couleur à mémoire,[1] French for Sequential Color with Memory ), is an analog color television system first used in France. A team led by Henri de France working at Compagnie Française de Télévision (later… …   Wikipedia

  • Multichannel television sound — Multichannel television sound, better known as MTS (often still as BTSC, for the Broadcast Television Systems Committee that created it), is the method of encoding three additional channels of audio into an NTSC format audio carrier. Contents 1… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”