Spontaneous emission

Spontaneous emission is the process by which a light source such as an atom, molecule, nanocrystal or nucleus in an excited state undergoes a transition to the ground state and emits a photon. Spontaneous emission of light or luminescence is a fundamental process that plays an essential role in many phenomena in nature and forms the basis of many applications, such as fluorescent tubes, television screens, plasma display panels, lasers and light emitting diodes.

Introduction

If a light source ('the atom') is in the excited state with energy $E\_2$, it may spontaneously decay to the ground state, with energy $E\_1$, releasing the difference in energy between the two states as a photon. The photon will have angular frequency $omega$ and energy $hbar\; omega$:

:$E\_2\; -\; E\_1\; =\; hbar\; omega$,

where $hbar$ is Dirac's constant. The phase of the photon in spontaneous emission is random as is the direction the photon propagates in. This is not true for stimulated emission. An energy level diagram illustrating the process of spontaneous emission is shown below:

If the number of light sources in the excited state is given by $N$, the rate at which $N$ decays is:

:$frac\{partial\; N\}\{partial\; t\}\; =\; -A\_\{21\}\; N$,

where $A\_\{21\}$ is the rate of spontaneous emission. In the rate-equation $A\_\{21\}$ is a proportionality constant for this particular transition in this particular light source. The constant is referred to as the "Einstein A coefficient", and has units $s^\{-1\}$ [R. Loudon, The Quantum Theory of Light, 3rd ed. (Oxford University Press Inc.,New York, 2001).] . The above equation can be solved to give:

:$N(t)\; =N(0)\; e^\{\; -\; A\_\{21\}t\; \}=\; N(0)\; e^\{\; -\; Gamma\_\{rad\}t\; \}$,

where $N(0)$ is the initial number of light sources in the excited state, $t$ is the time and $Gamma\_\{rad\}$ is the radiative decay rate of the transition. The number of excited states $N$ thus decays exponentially with time, similar to radioactive decay. After one lifetime, the number of excited states decays to 36,8% of its original value ($frac\{1\}\{e\}$-time). The radiative decay rate $Gamma\_\{rad\}$ is inversely proportional to the lifetime $au\_\{12\}$:

$A\_\{21\}=Gamma\_\{12\}=frac\{1\}\{\; au\_\{21$.

Theory

Quantum mechanics explicitly prohibits spontaneous transitions. That is, using the machinery of ordinary first-quantized quantum mechanics and one computes the probability of spontaneous transitions from one stationary state to another, one finds that it is zero. In order to explain spontaneous transitions, quantum mechanics must be extended to a second-quantized theory, wherein the electromagnetic field is quantized at every point in space. Such a theory is known as a quantum field theory; the quantum field theory of electrons and electromagnetic fields is known as quantum electrodynamics.

In quantum electrodynamics (or QED), the electromagnetic field has a ground state, the vacuum state, which can mix with the excited stationary states of the atom (for more information, see Ref. [2] ). As a result of this interaction, the "stationary state" of the atom is no longer a true eigenstate of the combined system of the atom plus electromagnetic field. In particular, the electron transition from the excited state to the electronic ground state mixes with the transition of the electromagnetic field from the ground state to an excited state, a field state with one photon in it. Spontaneous emission in free space depends upon vacuum fluctuations to get started.cite book
author= Hiroyuki Yokoyama & Ujihara K
title=Spontaneous emission and laser oscillation in microcavities
publisher= CRC Press
location=Boca Raton
page=6
year=1995
isbn=0849337860
url=http://books.google.com/books?id=J_0ZAwf6AQ0C&printsec=frontcover&dq=%22spontaneous+emission%22&lr=&as_brr=0&sig=QbNGpi5P0uTHxwhHDECXhG2VA9M#PPA6,M1] cite book
author=Marian O Scully & Zubairy MS
title=Quantum optics
publisher= Cambridge University Press
location=Cambridge UK
page=§1.5.2 pp. 22-23
year=1997
isbn=0521435951
url=http://books.google.com/books?id=20ISsQCKKmQC&pg=PA430&dq=atom+transition+photon&lr=&as_brr=0&sig=d5TzC9UTl7CGU3PIJiCV0c0M6HU#PPA22,M1]

Although there is only one electronic transition from the excited state to ground state, there are many ways in which the electromagnetic field may go from the ground state to a one-photon state. That is, the electromagnetic field has infinitely more degrees of freedom, corresponding to the directions in which the photon can be emitted. Equivalently, one might say that the phase space offered by the electromagnetic field is infinitely larger than that offered by the atom. Since one must consider probabilities that occupy all of phase space equally, the combined system of atom plus electromagnetic field must undergo a transition from electronic excitation to a photonic excitation; the atom must decay by spontaneous emission. The time the light source remains in the excited state thus depends on the light source itself as well as its environment.

Rate of spontaneous emission

The rate of spontaneous emission (i.e., the radiative rate) can be described by Fermi's golden rule. [B. Henderson and G. Imbusch, Optical Spectroscopy of Inorganic Solids (Clarendon Press, Oxford, UK, 1989).] The rate of emission depends on two factors: an 'atomic part', which describesthe internal structure of the light source and a 'field part', which describes the density of electromagnetic modes of the environment. The atomic part describes the strength of a transition between two states in terms of transition moments. In a homogeneous medium, such as free space, the rate of spontaneous emission is given by:

;$Gamma\_\{rad\}(omega)=\; frac\{omega^3n|mu\_\{12\}|^2\}\; \{3pivarepsilon\_\{0\}hbar\; \{c\_0\}^3\}$

where $omega$ is the emission frequency, $n$ is the index of refraction, $mu\_\{12\}$ is the transition dipole moment, $varepsilon\_0$ is the vacuum permittivity, $hbar$ is Dirac's constant and $c\_0$ is the vacuum speed of light. Clearly, the rate of spontaneous emission in free space increases with $omega^3$. In contrast with atoms, which have a discrete emission spectrum, quantum dots form an ideal model system to probe the frequency dependence: the emission frequency of quantum dots can be tuned continuously by their size. In fact, it was confirmed that the rate of spontaneous emission of quantum dots follows the $omega^3$-frequency dependence as described by Fermi's golden rule. [A. F. van Driel, G. Allan, C. Delerue, P. Lodahl,W. L. Vos and D. Vanmaekelbergh,Frequency-dependent spontaneous emission rate from CdSeand CdTe nanocrystals: Influence of dark states, Physical Review Letters,95, 236804 (2005).http://cops.tnw.utwente.nl/pdf/05/PHYSICAL%20REVIEW%20LETTERS%2095%20236804%20(2005).pdf]

Radiative and nonradiative decay: the quantum efficiency

In the rate-equation above, it is assumed that decay of the number of excited states $N$ only occurs under emission of light. In this case one speaks of full radiative decay and this means that the quantum efficiency is 100%. Besides radiative decay, which occurs under the emission of light, there is a second decay mechanism; nonradiative decay. To determine the total decay rate $Gamma\_\{tot\}$, radiative and nonradiative rates should be summed:

:$Gamma\_\{tot\}=Gamma\_\{rad\}\; +\; Gamma\_\{nrad\}$

where $Gamma\_\{tot\}$ is the total decay rate, $Gamma\_\{rad\}$ is the radiative decay rate and $Gamma\_\{nrad\}$ the nonradiative decay rate. The quantum efficiency (QE) is defined as the fraction of emission processes in which emission of light is involved:

:$QE=frac\{Gamma\_\{rad\{Gamma\_\{nrad\}\; +\; Gamma\_\{rad$

In nonradiative relaxation, the energy is released as phonons, more commonly known as heat. Nonradiative relaxation occurs when the energy difference between the levels is very small, and these typically occur on a much faster time scale than radiative transitions. For many materials (for instance, semiconductors), electrons move quickly from a high energy level to a meta-stable level via small nonradiative transitions and then make the final move down to the bottom level via an optical or radiative transition. This final transition is the transition over the bandgap in semiconductors. Large nonradiative transitions do not occur frequently because the crystal structure generally can not support large vibrations without destroying bonds (which generally doesn't happen for relaxation). Meta-stable states form a very important feature that is exploited in the construction of lasers. Specifically, since electrons decay slowly from them, they can be piled up in this state without too much loss and then stimulated emission can be used to boost an optical signal.

Lifetime measurements

The total decay rate can be measured with a photoluminescence lifetime measurement. [J. R. Lakowicz, Principles of Fluorescence Spectroscopy, 2nd ed., Kluwer Academic/Plenum Publishers, New York, 1999] . Time-correlated–single-photon counting is generally used to obtain decay curves. The decay curve is built from a histogram which shows the distribution of arrival times of single photons after many excitation-detection cycles. The histogram is modelled with a decay function from which the decay time of the process is deduced. In the simplest case the decay curve can be described by a single-exponential function. In a semi-logarithmic plot a single-exponential decay function results in a straight line. The slope of the straight line equals the total decay rate of the process. In many cases the decay curve is more complex than single-exponential. [A. F. van Driel, I. S. Nikolaev, P. Vergeer, P. Lodahl, D. Vanmaekelbergh, and W. L. Vos, Statistical analysis of time-resolved emission from ensembles of semiconductor quantum dots: Interpretation of exponential decay models, Physical review B 75, 035329(2007).http://cops.tnw.utwente.nl/pdf/07/PhysRevB_75_035329.pdf] In case of multi-exponential decay the process is not characterized by a single rate, but by a sum or a distribution of rates. It is a general problem to model these complex multi-exponential decay processes. Double and triple-exponential functions or functions with a particular distribution of rates are often used although care should be taken since any decay function can be fitted with enough exponential terms. Some data sets, particularly those in which diffusion effects are present, generate non-exponential decays in which other functional forms should be used.

Controlling spontaneous emission: Purcell Effect

The rate of spontaneous emission depends partly on the environment of a light source. This means that by placing the light source in a special environment, the rate of spontaneous emission can be modified. In the 1950s E. Purcell discovered the enhancement of spontaneous emission rates of atoms when they are matched in a resonant cavity (the Purcell Effect) [E. M. Purcell, Phys. Rev. 69, 681 (1946).] . It has been predicted theoretically [V. P. Bykov, Spontaneous emission from a medium with a band spectrum, Soviet Journal of Quantum Electronics 4, 861 (1975).] [E. Yablonovitch, Inhibited spontaneous emission in solid-state physics and electronics, Physical Review Letters 58, 2059(1987).http://www.ee.ucla.edu/faculty/papers/eliy1987PhysRevLett.pdf] that a 'photonic' material environment can control the rate of radiative recombination of an embedded light source. A main research goal is the achievement of a material with a complete photonic bandgap: a range of frequencies in which no electromagnetic modes exist and all propagation directions are forbidden. At the frequencies of the photonic bandgap, spontaneous emission of light is completely inhibited. Fabrication of a material with a complete photonic bandgap is a huge scientific challenge. For this reason photonic materials are being extensively studied. Many different kinds of systems in which the rate of spontaneous emission is modified by the environment are reported, including cavities, two, [A. Kress, F. Hofbauer, N. Reinelt, M. Kaniber, H. J. Krenner, R. Meyer, G. Bohm, and J. J. Finley, Manipulation of the spontaneous emission dynamics of quantum dots in two-dimensional photonic crystals, Physical Review B 71, 241304 (2005).] [D. Englund, D. Fattal, E. Waks, G. Solomon, B. Zhang, T. Nakaoka, Y. Arakawa, Y. Yamamoto, J. Vuckovic, Controlling the Spontaneous Emission Rate of Single Quantum Dots in a 2D Photonic Crystal, [http://www.stanford.edu/group/nqp/jv_files/papers/dirk-exp1.pdf Physical Review Letters 95 013904 (2005)] ] and three-dimensional [P. Lodahl, A. F. van Driel, I. S. Nikolaev, A. Irman, K. Overgaag, D. Vanmaekelbergh andW. L. Vos, Controlling the dynamics of spontaneous emission from quantum dots by photonic crystals, Nature, 430, 654 (2004).http://cops.tnw.utwente.nl/pdf/04/nature02772.pdf] photonic bandgap materials.

ee also

* absorption (optics)
* stimulated emission
* photonic crystal
* laser science
* emission spectrum
* spectral line
* Atomic spectral line
* Vacuum Rabi oscillation
* Jaynes-Cummings model

References