- Kilobyte
A

**kilobyte**(derived from theSI prefix "kilo -", meaning 1,000) is a unit ofinformation orcomputer storage equal to either 1,024byte s (2^{10}) or 1,000byte s (10^{3}), depending on context.It is abbreviated in a number of ways:

**kB**,**KB**,**K**and**Kbyte**.**Ambiguity**The exact number of bytes in a kilobyte has traditionally been ambiguous. Locations in electronic memory circuits are identified by

binary number s, which means that the number of addressable locations naturally becomes apower of 2 , and memory sizes are therefore not integer multiples (or fractions) of 1000. However, as 2^{10}= 1024 ≈ 1000, the established 'k' (for "kilo") was early on employed as a convenient "approximate" prefix for memory capacities in multiples of 1024. On the other hand, for products where (some) capacity factors were not equally bound to powers of two, such asmagnetic disk s (sector and track numbers) and networking equipment (bit rates), strict decimal-based units were used.Some have suggested that the capitalized prefix

**K**be used to distinguish this quantity from the SI prefix**k**, but this has never been formally mandated. Further, it is not extensible to higher-order prefixes, asSI already uses the prefixes**m**and**M**to mean "milli-" and "mega-" respectively. There are also proposals to capitalize all greater-than-unity prefixes (D, H, K, M, G, ...), which would conflict with this. See SI prefix.These prefixes are therefore used with either decimal (powers of 1000) or binary (powers of 1024) values, depending on context:

* 1024 bytes (2

^{10}): This unit is used when expressing quantities which are based on powers of two, such as memory chip capacities. Most software also expresses storage capacity in units of 1024 bytes. Although the use of "kilobyte" for this unit is common, this usage has been expressly forbidden by the SI standard [*[*] and other standards organisations. To indicate a quantity of 1024 bytes, the term*http://www.bipm.org/utils/en/pdf/si-brochure.pdf*] section 3.1, marginal note(kibibyte **KiB**) has been recommended instead. [*http://physics.nist.gov/cuu/Units/binary.html Prefixes for Binary Multiples*] — The NIST Reference on Constants, Units, and Uncertainty] IEEE Std 260.1-2004, IEEE Standard Letter Symbols for Units of Measurement (SI Units, Customary Inch-Pound Units, and Certain Other Units), Revision of IEEE Std 260.1-1993 (IEEE, New York, 2004)]* 1000 bytes (10

^{3}): This definition is recommended for all uses by international standards organizations such as IEC, IEEE, and ISO, with the abbreviation "kB". This unit is common for quantities which are not based on powers of two, such asbitrate s. This term is starting to be adopted by some software, such as theLinux kernel . [*[*]*http://lwn.net/2002/0103/a/esr-kibi.php3 Post on Linux Kernel Mailing List announcing the change.*]Kilobyte (abbreviated as "KB") is not to be confused with the term

kilobit (abbreviated as kb).To make it simple, there are 1000 KB in a MB, and there are 1000 MB in a GB, and so on so forth...

**ee also***

Orders of magnitude (data)

*Megabyte

*kilobit **References**

*Wikimedia Foundation.
2010.*