- Above ground level
aviationand atmospheric sciences, an altitudeis said to be above ground level (AGL) when it is measured with respect to the underlying ground surface. This is as opposed to above mean sea level(AMSL), or in broadcast engineering, height above average terrain(HAAT). In other words, these expressions (AGL, AMSL, or HAAT) indicate where the "zero level" or "reference altitude" is located.
A pilot flying a plane under
instrument flight rules(typically under poor visibilityconditions) must rely on its altimeterto decide when to deploy the aircraft undercarriageand prepare for landing. Therefore the pilot needs reliable information on the altitudeof the plane with respect to the air strip. The altimeter, which is normally a barometercalibrated in units of distance instead of atmospheric pressure, must therefore be set in such a way as to indicate the altitude of the craft above ground. This is done by communicating with the control tower of the airport (to get the current surface pressure) and setting the altimeter so as to report a null altitude AGL on the ground of that airport. Confusing AGL with AMSL, or improperly calibration of the altimeter may result in controlled flight into terrain, a crash under pilot control.
weatherand climatestudies, measurements or simulations often need to refer to a specific height or altitude, which is naturally AGL. However, the values of geophysical variables measured in various places on the natural (ground) surface may not be easily compared in hilly or mountainous terrain, because part of the observed variability is due to changes in the altitude of the surface. For this reason, variables such as pressure or temperature are sometimes 'reduced' to mean sea level.
In general circulation models and
global climate models, the state and properties of the atmosphereare specified or computed at a number of discrete locations and heights. When the topographyof the continents is explicitly represented, the altitudes of these locations are set above the simulated ground level. This is often implemented using the so-called sigma coordinatesystem, which is the ratio of the pressure at a location (latitude, longitude, altitude) divided by the pressure at the nadir of that location on ground surface (same latitude, same longitude, altitude AGL =0).
In broadcasting, AGL has relatively little direct bearing on the
broadcast rangeof a station. Rather, it is HAAT (the height above the "surrounding" area) which is used to determine how far a broadcast station(or any other sort of VHFor higher radio-frequencytransmission) will travel.
More important is the height of the
radio towerused to support the radio antenna. In this case, AGL is the only important measurement for aviation authorities, which require that some tall towers have proper paintingand lightingto avoid collisions.
* [http://www.airport-int.com/glossary/agl-above-ground-level AGL in aviation]
Wikimedia Foundation. 2010.