LE-5

The LE-5 liquid rocket engine and it's derivative models were developed in Japan to meet the need for an upper stage propulsion system for the H-I and H-II series of launch vehicles. It is a bipropellant design, using LH2 and LOX. Primary design and production work was carried out by Mitsubishi Heavy Industries. In terms of liquid rockets, it is a fairly small engine, both in size and thrust output, being in the 20,000 lbs and the more recent models the 30,000 lbs thrust class. The motor is capable of multiple restarts, due to a spark ignition system as opposed to the single use pyrotechnic or hypergolic igniters commonly used on some contemporary engines. Though rated for up to 16 starts and 40+ minutes of firing time, on the H-II the engine is considered expendable, being used for one flight consisting of a single start followed by about 9 minutes of firing and jettisoned. In missions to GTO the engine is often fired a second time to inject the payload into the higher orbit after a temporarily lower orbit has been successfully established.

LE-5

The original LE-5 was built as a third stage engine for the H-I launch vehicle. It used a fairly conventional gas generator cycle.

LE-5A

The LE-5A was a heavily redesigned version of the LE-5 intended for use on the new H-II launch vehicle’s second stage. The major difference is that the operation of the engine was switched from the gas generator to expander bleed cycle. The LE-5A was the first expander bleed cycle engine to be put into operational service. Cryogenic liquid hydrogen fuel for the cycle is drawn through tubes and passages in both the engine’s nozzle and combustion chamber where the hydrogen heats up incredibly while simultaneously cooling those components. The heating of the initially cold fuel causes it to become significantly pressurized and it is utilized to drive the turbine for the propellant pumps.

LE-5B

The LE-5B was a farther modified version of the LE-5A. The changes focused on lowering the per-unit cost of the engine while continuing to increase reliability. The modifications veered towards simplification and cheaper production where possible at the cost of actually lowering the specific impulse to 447 seconds, the lowest of all three models. However, it produced the highest thrust of the three and was significantly cheaper. The primary change from the 5A model was that the 5B’s expander bleed system circulated fuel around only the combustion chamber as opposed to the both the chamber and the nozzle in the 5A. Alterations to the combustion chamber cooling passages and constituent materials were made with special emphasis on effective heat transfer to allow this method to be successful.

pecifications

ee also

* H-I
* H-II
* H-IIA
* LE-7

References

* [http://ja.wikipedia.org/wiki/LE-5B Japanese Wikipedia LE-5B (in Japanese)]
* [http://www.astronautix.com/engines/le5.htm Encyclopedia Astronautica info page on the LE-5]
* [http://www.astronautix.com/engines/le5a.htm Encyclopedia Astronautica info page on the LE-5A]
* [http://www.astronautix.com/engines/le5b.htm Encyclopedia Astronautica info page on the LE-5B]
* [http://www.la.dlr.de/ra/sart/publications/pdf/2003-4597.pdf Studies on Expander Bleed Cycle Engines for Launchers, AIAA Paper]