- Size exclusion chromatography
Infobox chemical analysis
name = Size exclusion chromatography
caption =Equipment for running size exclusion chromatography. The buffer is pumped through the column (right) by a computer controlled device
acronym = SEC
classification =Chromatography
analytes =macromolecule ssynthetic polymer sbiomolecule s
manufacturers =
related =High performance liquid chromatography Aqueous Normal Phase Chromatography Ion exchange chromatography Micellar liquid chromatography
hyphenated =Size exclusion chromatography (SEC) is a chromatographic method in which particles are separated based on their size, or in more technical terms, their
hydrodynamic volume . It is usually applied to largemolecule s or macromolecular complexes such as proteins and industrial polymers. When an aqueous solution is used to transport the sample through the column, the technique is known as gel filtration chromatography. The name gel permeation chromatography is used when an organic solvent is used as a mobile phase. The main application of gel filtration chromatography is thefractionation of proteins and other water-soluble polymers, while gel permeation chromatography is used to analyze the molecular weight distribution of organic-soluble polymers. Either technique should not be confused withgel electrophoresis , where an electric field is used to "pull" or "push" molecules through the gel depending on their electrical charges.SEC is a widely used technique for the purification and analysis of synthetic and biological polymers, such as
proteins ,polysaccharides andnucleic acids . Biologists and biochemists typically use a gel medium — usuallypolyacrylamide ,dextran oragarose — and filter under low pressure. Polymer chemists typically use either asilica or crosslinkedpolystyrene medium under a higher pressure. These media are known as the stationary phase.The advantage of this method is that the various solutions can be applied without interfering with the filtration process, while preserving the biological activity of the particles to be separated. The technique is generally combined with others that further separate molecules by other characteristics, such as acidity, basicity, charge, and affinity for certain compounds.
Discovery
The technique was invented by Grant Henry Lathe and Colin R Ruthven, working at Queen Charlotte’s Hospital, London [Lathe, GH and Ruthven, CR (1955) The separation of substances on the basis of their molecular weights, using columns of starch and water. Biochem J. 60(4):xxxiv.] [Lathe, GH and Ruthven, CR (1956) The separation of substances and estimation of their relative molecular sizes by the use of columns of starch in water. Biochem. J. 62(4): 665-674. [http://www.pubmedcentral.nih.gov/articlerender.fcgi?tool=pubmed&pubmedid=13315231 article] ] . They later received the John Scott Award for this invention [ [http://www.garfield.library.upenn.edu/johnscottaward.html John Scott Award] ] . While Lathe and Ruthven used starch gels as the matrix, Porath and Flodin later introduced dextran gels [Porath, J and Flodin, P (1959) Gel filtration: A method for desalting and group separation. Nature 183(4676): 1657-1659.] ; other gels with size fractionation properties include agarose and polyacrylamide. A short review of these developments has appeared [Eisenstein, M (2006) A look back, adventures in the matrix. Nature Methods 3(5): 410 [http://www.nature.com/nmeth/journal/v3/n5/full/nmeth0506-410.html article] ] .
Theory and method
The underlying principle of SEC is that particles of different sizes will elute (filter) through a stationary phase at different rates. This results in the separation of a solution of particles based on size. Provided that all the particles are loaded simultaneously or near simultaneously, particles of the same size should elute together.This is usually achieved with an apparatus called a column, which consists of a hollow tube tightly packed with extremely small porous polymer beads designed to have pores of different sizes. These pores may be depressions on the surface or channels through the bead. As the solution travels down the column some particles enter into the pores. Larger particles cannot enter into as many pores. The larger the particles, the less overall volume to traverse over the length of the column, and the faster the elution.
The filtered solution that is collected at the end is known as the eluate. The void volume includes any particles too large to enter the medium, and the solvent volume is known as the column volume.
Factors affecting filtration
In real life situations particles in solution do not have a constant, fixed size, resulting in the probability that a particle which would otherwise be hampered by a pore may pass right by it. Also, the stationary phase particles are not ideally defined; both particles and pores may vary in size. Elution curves therefore resemble Gaussian distributions. The stationary phase may also interact in undesirable ways with a particle and influence retention times, though great care is taken by column manufacturers to use stationary phases which are inert and minimize this issue.
Like other forms of chromatography, increasing the column length will enhance the resolution, and increasing the column diameter increases the capacity of the column. Proper column packing is important to maximize resolution: an overpacked column can collapse the pores in the beads, resulting in a loss of resolution. An underpacked column can reduce the relative surface area of the stationary phase accessible to smaller species, resulting in those species spending less time trapped in pores.
Analysis
In simple manual columns the eluent is collected in constant volumes, known as fractions. The more similar the particles are in size, the more likely they will be in the same fraction and not detected separately. More advanced columns overcome this problem by constantly monitoring the eluent. The collected fractions are often examined by spectroscopic techniques to determine the concentration of the particles eluted. Three common spectroscopy detection techniques are refractive index (RI), evaporative light scattering (ELS), and ultraviolet (UV). When eluting spectroscopically similar species (such as during biological purification) other techniques may be necessary to identify the contents of each fraction. It is also possible to analyse the eluent flow continuously with RI, LALLS UV and or viscosity measurements.
The elution volume (Ve) decreases roughly linearly with the
logarithm of the molecularhydrodynamic volume (for globular proteins this is proportional tomolecular weight ). Columns are often calibrated using 4-5 standard samples (e.g., folded proteins of known molecular weight), and a sample of the very large molecule blue dextran to determine thevoid volume . The elution volumes of the standards are divided by the elution volume of the blue dextran (Ve/Vo) and plotted against the log of the standards' molecular weights.Applications
Proteomics
SEC is generally considered a low resolution chromatography as it does not discern similar species very well, and is therefore often reserved for the final "polishing" step of a purification. The technique can determine the
quaternary structure of purified proteins which have slow exchange times, since it can be carried out under nativesolution conditions, preserving macromolecular interactions. SEC can also assay proteintertiary structure as it measures the hydrodynamic volume (not molecular weight), allowing folded and unfolded versions of the same protein to be distinguished. For example, the apparenthydrodynamic radius of a typical protein domain might be 14 Å and 36 Å for the folded and unfolded forms respectively. SEC allows the separation of these two forms as the folded form will elute much later due to its smaller size. Alternatively, folded and unfolded versions of the samemetalloprotein s can be separated according to their differentisoelectric point s by using quantitative preparative native continuous polyacrylamide gel electrophoresis (QPNC-PAGE ).Polymer synthesis
SEC can be used as a measure of both the size and the
polydispersity of a synthesised polymer - that is, the ability to be able to find the distribution of the sizes of polymer molecules. If standards of a known size are run previously, then acalibration curve can be created to determine the sizes of polymer molecules of interest. Alternatively, techniques such as light scattering and/orviscometry can be used online with SEC to yield absolute molecular weights that do not rely on calibration with standards of known molecular weight. Due to the difference in size of two polymers with identical molecular weights, the absolute determination methods are generally more desirable. A typical SEC system can quickly (in about half an hour) give polymer chemists information on the size and polydispersity of the sample. The preparative SEC can be used forpolymer fractionation on an analytical scale.References
Wikimedia Foundation. 2010.