- Pour point
The pour point of a
liquid is the lowesttemperature at which it will pour or flow under prescribed conditions. It is a rough indication of the lowest temperature at whichoil is readily pumpable.Also, the pour point can be defined as the minimum
temperature of a liquid, particularly alubricant , after which, on decreasing the temperature, the liquid ceases to flow.Measuring the pour point of petroleum products
The specimen is cooled inside a cooling bath to allow the formation of paraffin
wax crystals. At about 9oC above the expected pour point, and for every subsequent 3oC, the test jar is removed and tilted to check for surface movement. When the specimen does not flow when tilted, the jar is held horizontally for 5 secs. If it does not flow, 3oC is added to the corresponding temperature and the result is the pour point temperature.It is also useful to note that failure to flow at the pour point may also be due to the effect of viscosity or the previous thermal history of the specimen. Therefore, the pour point may give a misleading view of the handling properties of the oil. Additional
fluidity orpumpability tests may also be undertaken. An approximate range of pour point can be observed from the specimen's upper and lower pour point.Measuring the pour point of crude oils
Two pour points can be derived which can give an approximate temperature window depending on its thermal history. Within this temperature range, the sample may appear liquid or solid. This peculiarity happens because wax crystals form more readily when it has been heated within the past 24hrs and contributes to the lower pour point.
The upper pour point is measured by pouring the test sample directly into a test jar. The sample is then cooled and then inspected for pour point as per the usual pour point method.
The lower pour point is measured by first pouring the sample into a stainless steel
pressure vessel . The vessel is then screwed tight and heated to above 100oC in an oil bath. After a specified time, the vessel is removed and cooled for a short while. The sample is then poured into a test jar and immediately closed with a cork carrying thethermometer . The sample is then cooled and then inspected for pour point as per the usual pour point method.ee also
*
Viscosity
*Petroleum
*Cloud point
*Gel point
*Cold filter plugging point References
Wikimedia Foundation. 2010.