- Ethernet Automatic Protection Switching
Ethernet Automatic Protection Switching (EAPS) is used to create a fault tolerant topology by configuring a primary and secondary path for each VLAN.
It was invented by
Extreme Networks . The idea is to provide highly available Ethernet switched rings (commonly used inMetro Ethernet ). Other implementations include Ethernet Protection Switching Ring (EPSR [ [http://www.alliedtelesis.com/media/datasheets/howto/config_epsr_sd_a.pdf How to configure EPSR] ] ) byAllied Telesis .Operation
A ring is formed by configuring a Domain. Each domain has a single "master node" and many "transit nodes". Each node will have a primary port and a secondary port, both known to be able to send control traffic to the master node. Under normal operation only the primary port on the master node is used to avoid loops (the secondary port is blocked for all non-control traffic).
When there is a link down situation, the devices that detect the failure send a control message to the master, and the master will then unblock the secondary port and instruct the transits to flush their databases. The next packets sent by the network can then be flooded and learned out of the (now enabled) secondary port without any network disruption.
Fail-over times are demonstrably in the region of 50ms.
The same switch can belong to multiple domains and thus multiple rings. However, these act as independent entities and can be controlled individually.
EAPS v2
EAPSv2 is configured and enabled to avoid the potential of super-loops in environments where multiple EAPS domains share a common link. EAPSv2 works using the concept of a controller and partner mechanism. Shared port status is verified using health PDUs exchanged by controller and partner. When a shared link goes down, the configured Controller will open only one segment port for each of the protected VLANs, keeping all other segment ports in a blocking state. This state is maintained as long as the Controller fails to receive the health PDUs over the (broken) shared link.
Although not supported by ExtremeNetworks, it is possible to complete this shared link with non EAPS (but tag aware) switches between the Controller and Partner.
When the shared link is restored, the Controller can then unblock its' ports, the masters will see their hello packets, and the rings will be protected by their respective masters.
See also
*
Rapid Spanning Tree Protocol References
External links
* RFC 3619 (EAPS)
* [http://www.itu.int/rec/T-REC-G.8031-200606-P/en ITU-T G.8031/Y.1342]
Wikimedia Foundation. 2010.
