Dynamic compression plate

Dynamic compression plate

A dynamic compression plate (DCP) is a metallic plate used in orthopedics for internal fixation of bone, typically after fractures. As the name implies, it is designed to exert dynamic pressure between the bone fragments to be transfixed. Dynamic compression is achieved either by attaching a tension device to a plate or by using a special dynamic compression plate. However, compression plating requires a longer surgical incision to allow insertion of the tension device and the possibility of refracture after the plate is removed. A neutralization plate is used to bridge a comminuted fracture; it also transmits bending or torsional forces from the proximal to the distal fragment. Plates used for buttressing prevent collapse by supporting an area of thin cortex or cancellous bone graft.

When plates are used, atrophy of the bone beneath the plate may predispose the bone to fracture. After removal of plates, fractures may occur through the screw holes.

Sliding screw plate

The sliding screw plate (dynamic compression screw, dynamic hip screw) may be used to treat intertrochanteric fractures as well as other injuries. This device consists of a lag screw and a side plate with a barrel. The sliding screw telescopes and provides fixation while allowing impaction to occur at the fracture during healing and weight bearing. Among the complications of sliding screw plate fixation are "cutting out" of the nail, penetration of the screw into the joint, bending or breaking of the nail, and disengagement of the screw from the barrel and even protrusion of the screw into the vertabrae.

Limited contact dynamic compression plate

LCDCP or LC-DCP stands for Limited contact dynamic compression plate. It is a dynamic compression plate with limited contact to the underlying bone which supposedly minimizes disruption in periosteal capillary network and thus in the fracture zone. Also, it should have more uniform bending characters than ordinary DCP:s due to less prone inclination to bend on the area of holes in the plate.