Futurebus (IEEE 896) is a computer bus standard, intended to replace all local bus connections in a computer, including the CPU, memory, plug-in cards and even, to some extent, LAN links between machines. The effort started in 1979 and didn't complete until 1987, and then immediately went into a redesign that lasted until 1994. By this point everyone involved lost interest, and Futurebus saw little use.


The original in the late 1970s, VMEBus was faster than the parts plugged into it. it was quite reasonable to connect a CPU and RAM to VME on separate cards to build a computer. However as the speed of the CPUs and RAM rapidly increased, VME was quickly overwhelmed. Increasing the speed of VME was not easy, because all of the parts plugged into it would have to be able to support these faster speeds as well.

Futurebus looked to fix these problems and create a successor to systems like VMEbus with a system that could grow in speed without affecting existing devices. In order to do this the primary technology of Futurebus was built using asynchronous links, allowing the devices plugged into it to talk at whatever speed they could. Another problem that needed to be addressed was the ability to have several cards in the system as "masters", allowing Futurebus to build multiprocessor machines. This required some form of "distributed arbitration" to allow the various cards gain access to the bus from any point, as opposed to VME which put a single master in slot 0 with overall control. In order to have a clear performance benefit, Futurebus was designed to have the performance needed ten years in the future.

Typical IEEE standards start with a company building a device, and then submitting it to the IEEE for the standardization effort. In the case of Futurebus this was reversed, the whole system was being designed as during the standardization effort. This proved to be its downfall. As companies came to see Futurebus as "the" system, they all joined in. Soon the standards meetings had hundreds of people attending, all of them demanding that their particular needs and wants be included. As the complexity grew, the standards process slowed. In the end it took eight long years before the specification was finally agreed on in 1987. Tektronix did make a few workstations based on Futurebus.

That was just in time for the US Navy who had been looking for a new high-speed system for the Next Generation Computer Resources (NGCR) project for passing sonar data around in their newly designed Seawolf class submarines, and they said they would standardize on Futurebus if only a "few" more changes would be made. Seeing a potential massive government buy, the additions effort started immediately on Futurebus+. This also had the unexpected side effect of killing any effort to produce Futurebus system while everyone waited for the new version to come out, "real soon now". Real soon turned out to be another four years, and when the resulting Futurebus+ was released, no one was interested any longer.

All of the Futurebus+ proponents had their idea of what Futurebus+ should be. This degenerated into "profiles", different versions of Futurebus+ targeted towards a particular market. Boards that were compliant with one Futurebus+ profile were not guaranteed to work with boards built to a different profile. The Futurebus+ standards development politics got so complicated that the IEEE 896 committee split from the IEEE Microcomputer Standards Committee and formed the IEEE Bus Architecture Standards Committee (BASC).

In the end very little use of Futurebus was attempted. The decade-long performance gap they gave the system had evaporated in the decade-long standards process, and conventional local bus systems like PCI were close in performance terms. Meanwhile the VME ecosystem had evolved to such a degree that it continues to be used today, another decade on. The Futurebus technology is currently used as an internal backplane technology for systems such as routers.

However the Futurebus effort did act as a catalyst for change in other ways. After the 1987 version shipped and the Futurebus+ effort started, a number of the original designers realized the effort was doomed. One member did a quick back-of-the-envelope calculation and showed that by the time Futurebus+ shipped, it would already be too slow for the supercomputer market. A group then organized to create a system aimed directly at this need, which eventually led to Scalable Coherent Interconnect. Meanwhile another member decided to simple re-create the entire concept on a much simpler basis, which resulted in QuickRing. Due to the simplicity of these standards, both standards were completed before Futurebus+.

Futurebus was the source of some of the original work on Cache Coherency, Live Insertion of boards, and Trapezoidal Transceivers. Trapezoidal Transceivers have a controlled risetime and make backplane and bus design much simpler. The original Trapezoidal Transceivers were made by National Semiconductor. Newer Futurebus+ transceivers that meet the IEEE Std 1194.1-1991 Backplane Transceiver Logic (BTL) standard are still made by Texas Instruments. Futurebus+ was used as the I/O bus in the DEC 4000 AXP and DEC 10000 AXP systems. Futurebus+ FDDI boards are still supported in the OpenVMS operating system.


Futurebus is described in just a few IEEE standards;
* 896.1-1987 IEEE Standard Backplane Bus Specifications for Multiprocessor Architectures: Futurebus
* 1101-1987 IEEE Standard for Mechanical Core Specifications for Microcomputers Using IEC 603-2 Connectors

Futurebus systems were implemented with 9Ux280 Eurocard mechanics using 96-pin DIN connectors resulting in a backplane that supported both 16 and 32 bit bus widths.

To understand Futurebus+ you need to read many IEEE standards;
* 896.1-1991 IEEE Standard for Futurebus+ — Logical Protocol Specification
* 896.2-1991 IEEE Standard Backplane Bus Specification for Multiprocessor Architectures: Futurebus+
* 896.3-1993 IEEE recommended practice for Futurebus+
* 896.4-1993 IEEE Standard for Conformance Test Requirements for Futurebus+
* 896.5-1993 IEEE Standard for Futurebus+, Profile M (Military)
* 896.6 Futurebus+ telecommunications systems, profile T (telecommunications)
* 896.7 Interconnect between Futurebus+ systems
* 896.8 Small computer expandibility module for Futurebus+ systems, profile D (desktop)
* 896.9-1994 Fault tolerant extensions to the Futurebus+ architecture
* 896.10-1997 Standard for Futurebus+ Spaceborne Systems - Profile S
* 896.11 Standard for IEEE 1355 Links on Futurebus+ Backplane Connector
* 896.12 Standard for Fault Tolerance Classification of Computer-Based Systems
* 1194.1-1991 IEEE Standard for Electrical Characteristics of Backplane Transceiver Logic (BTL) Interface Circuits
* 1301 Standard for Metric Equipment Practice for Microcomputers - Coordination Document
* 1301.1-1991 IEEE Standard for a Metric Equipment Practice for Microcomputers—Convection-Cooled with 2 mm Connectors
* 1156.1 Standard Microprocessor Environmental Specifications for Computer Modules
* EIA IS-64 (1991) 2 mm Two-Part Connectors for Use with Printed Boards and Backplanes

896.2 contains three Profiles for target markets, A for general purpose systems, B for an I/O bus, and F for a Futurebus+ will all the options that will make it go fast. Profile A was sponsored by the VMEbus community. Profile B was sponsored by Digital Equipment and implemented in VAX systems as an I/O bus. Profile F was sponsored by John Theus while he worked at Tektronix and was intended for high end workstations.

Futurebus+ supports bus widths from 32 to 256 bits. It is possible to build a board that supports all of these bus widths and will interoperate with boards that only support a subset. Split bus transactions are supported so that slow response to a read or write will not tie up the backplane bus. Cache Coherence, implemented using the MESI protocols, was very complicated but significantly improved performance. Futurebus+ was one of the first open standards to support Live Insertion which allowed boards to be replaced while the system was running.

Futurebus+ boards are 12SUx12SU Hard Metric size defined in the IEEE 1301 standards.

One of the most elegant features of the Futurebus design is its distributed bus arbitration mechanism. See US patent number 5060139 for more information. In the end this was replaced by a central arbiter.

See also

* InfiniBand
* QuickRing
* Bus topology
* The Futurebus+ Handbook, John Theus, VITA
* Futurebus+ Handbook for Digital Systems, Digital Equipment

External links

* [http://www.cs.umass.edu/~weems/CmpSci635/635lecture12.html Buses]

Wikimedia Foundation. 2010.

Игры ⚽ Нужно решить контрольную?

Look at other dictionaries:

  • Futurebus — El Futurebus (IEEE 896) es un estándar de bus de datos, ideado para reemplazar todas las conexiones de bus local en una computadora, incluyendo la unidad central de proceso, la memoria, las tarjetas de expansión e incluso, hasta cierto punto, los …   Wikipedia Español

  • FMUG — Futurebus+ Manufacturers and Users Group …   Acronyms

  • FMUG — Futurebus+ Manufacturers and Users Group …   Acronyms von A bis Z

  • DEC 7000/10000 AXP — The DEC 7000 AXP and DEC 10000 AXP are a series of high end multiprocessor server computers developed and manufactured by Digital Equipment Corporation, introduced on 10 November 1992 (although the DEC 10000 AXP was not available until the… …   Wikipedia

  • Scalable Coherent Interface — SCI, for Scalable Coherent Interface, is a high speed computer bus that supports a variety of topologies, speeds and connection systems. It is used primarily in the high performance computing market, where it is used to build NUMA computer… …   Wikipedia

  • QuickRing — was a gigabit rate interconnect that combined the functions of a computer bus and a network. It was designed at Apple Computer as a multimedia system to run on top of existing local bus systems inside a computer, but was later taken over by… …   Wikipedia

  • DEC 4000 AXP — The DEC 4000 AXP is a series of departmental server computers developed and manufactured by Digital Equipment Corporation introduced on 10 November 1992. These systems formed part of the first generation of systems based on the 64 bit Alpha AXP… …   Wikipedia

  • DEC Alpha — Alpha Designer Digital Equipment Corporation Bits 64 bit Introduced 1992 Design RISC Type Register Register Encoding Fixed …   Wikipedia

  • Wei Yen — Dr. Wei Yen is a software developer and entrepreneur. Yen has been involved with several companies, including most recently as chairman and founder of AiLive. Dr. Yen and his brother David Yen published the paper Data Coherence Problem in a… …   Wikipedia

  • DEC Alpha — Микропроцессор DEC Alpha AXP 21064 DEC Alpha (также известный как Alpha AXP)  64 разрядный …   Википедия

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”