Stetsbar

The Stetsbar Tremolo system is a tremolo arm/vibrato bridge system for the electric guitar developed by Eric Stets during the late ‘80s and patented in 1995. The system was originally designed to offer an extremely stable tremolo system that could be retro fitted to “stop-tail” guitars such as the Gibson Les Paul without the need to make any permanent modifications to the recipient guitar.

Since its introduction, other mounts for the system have been introduced to enable a wide variety of guitars to be accommodated.

Principle of operation

The Stetsbar is a floating tremolo system where the pull of the guitar strings are held in equilibrium at the scale length of the guitar by two heavy duty springs anchored to a spring retainer block on the base plate of the unit.

When actuated by moving the tremolo arm up or down, the bridge operates with a linear motion in the same plane as the strings of the guitar. A Tune-O-Matic style bridge is mounted on the bridge plate which also holds the string anchor block. The bridge plate moves over a pair of roller bearings installed in the base plate of the unit. Thus, the bridge and string anchors move as one, eliminating any friction over the bridge saddles.

This method has a number of advantages, chief amongst which are; the elimination of string friction at the bridge of the guitar and, due to the surface mounting of all components, no additional holes or routs are needed to the guitar to fit the unit.

The design itself uses a minimum of parts thus providing a long operational life.

Available models

The Stetsbar comes in a number of variants all of which are due to differences in the base plate design only. All other parts are common across the entire range. Various finishes are available for the base plates and other parts to allow for a close match to a guitars existing bright work, scratch plate and pickup surrounds.

Available models are:

* Stop Tail - designed to fit to guitars that have a stop tail bridge assembly such as the Gibson Guitar's Les Paul, Gibson SG, Gibson ES-335 and other similar models. Mounting to the guitar is achieved by using the existing threaded stop tail bushings. The base plate design mimics the curve of the lower bout of the guitar.
* Minimal Stop Tail - designed to fit to guitars that have a stop tail bridge assembly as above but with a rectangular base plate of similar width to a normal pickup surround and more suited to fitting on angular guitars such as the Flying V and Explorer.
* T-Style – with a base plate designed to replace a Fender Telecaster or similar guitar’s “ashtray” bridge. This base plate allows for the remounting of the guitars diagonal bridge pickups and offers both three and four screw hole fitting points that are found on the various T-Style makes and models.
* Hard Tail – a base plate mount for those guitars that have a hard tail mount point such as certain models of Fender Stratocasters and Fender Telecasters.
* OEM – a mount designed specifically for guitar builders who will build around the unit. This features a minimal base plate almost completely hidden under the main bridge plate and normally counter-sunk into the top of the guitar by a few millimetres.

Other Variations - some units are fitted with various makes of piezo pickup saddle or graphite bridges dependent upon requirement.

Notable users

Amongst the professional users of the Stetsbar are artists such as Jan Akkerman, formally of Focus, Snowy White (who tours extensively with Roger Waters and other members of Pink Floyd), Randy Bachman, Mike Chain as well as many US, UK and European session guitarists.

External links

* [http://www.stetsbar.com Stetsbar official site]