Matchless G80

Matchless G80

Manufacturer	Associated Motor Cycles (AMC) (London}
Production	1949 to 1966
Engine	498cc Single cylinder, pushrod 2 valve, 4 stroke
Power	28 bhp (21 kW) @ 5,600 rpm
Transmission	4-speed AMC gearbox to final drive chain
Wheelbase	1,397 mm (55.0 in)

The Matchless G80 was a single cylinder 500 cc British motorcycle built by Associated Motorcycles (AMC) between 1946 and 1966. During the 1950s and 1960s, the main export product for AMC was the AJS/Matchless range – the road bikes were very similar, often with only the badges distinguishing one marque from the other; the equivalent AJS being the Model 18.

Development

In the early 1950s, the most popular British four-strokes were still pushrod singles. The Matchless G80 is typical of this era. The earliest G80 is sometimes referred to as a G80L, the L signifying "Teledraulic" forks, rather than girder forks.^[1]

The magneto on an AJS was in front of the cylinder, and the Matchless magneto was behind. A design originating in the 1930s, the Matchless was updated with a spring frame (swingarm) rear suspension in 1949, becoming the G80S. The suspension was a vast improvement on the bouncy rigid rear end but wheel travel was limited.^[2]

AMC had adopted Velocette's twin-shock swingarm rear suspension design for its top models. Vertical shock absorber units were introduced in 1949. The initial "Candlestick" shocks held only 50 cc of SAE 20 weight oil. Leak prone, they were replaced by the "Jampot" shocks in 1951,^[2] and by Girling shocks in 1956. In 1957, AMC switched from Burman gearboxes to their own make.^[3]

The leaky pressed-steel primary chain-case first appeared on AMC machines in the 1930s. In 1958 an alloy cover primary chain-case became available.

Engine

The motor was released with a compression ratio of 5.9:1, because of the poor quality fuel available in the United Kingdom immediately after the Second World War.^[2] In 1949 the hairpin valve springs were back, after the use of conventional coil valve springs in wartime engines. By 1951 the G80 had an alloy cylinder head and the barrel fins now went all the way to the base on competition models. The compression ratio was increased to 7.3:1 in 1956.

Low compression meant that it was easy to kick-start and was more flexible at low revs. The earlier long stroke version might not quite reach 80 miles per hour (130 km/h), but it could trundle along at less than 20 miles per hour (32 km/h) in top gear. It also gave good fuel economy.^[2]

Model variations

The 500 cc "long stroke" G80CS was produced from 1951 through 1955. In 1956 it was replaced by the shorter stroke, larger bore models that used the same numeric codes. The bore of these early G80CS's was 82.5 mm (3.25"), while the 1956 through 1966 “short stroke” (final version) models had a bore of 86 mm. The C is for Competition (Scrambles) and the S for Suspension (not a rigid rear frame).

Matchless also made a 600cc version of the G80 called Typhoon. The bore was increased to 89mm while the stroke was increased from 85.5mm to a whopping 96mm. 125 bikes were reportedly made and almost all of them were sold in the USA. There was a road model with lights and a competition model without lights. The engine prefix code was TCS on these bikes.

Engine numbers usually start with the year of production, followed by model designation, and completed with the production number of the motorcycle.

References

1. ^ [1] AJSOC.com 1947 G80 (Retrieved December 31 2006)
2. ^ ^{a b c d} Matchless G80
3. ^ "BSA Golden Flash on test", Classic Bike Guide, May 2008