Universal Time

Universal Time

Universal Time (UT) is a timescale based on the rotation of the Earth. It is a modern continuation of Greenwich Mean Time (GMT), i.e., the mean solar time on the meridian of Greenwich, and GMT is sometimes used loosely as a synonym for UTC. In fact the expression "Universal Time" is ambiguous, as there are several versions of it, the most commonly used being UTC and UT1 (see below). All of these versions of UT are based on sidereal time, but with a scaling factor and other adjustments to make them closer to solar time.

Universal Time and standard time

Prior to the introduction of standard time, every municipality around the civilized world set its official clock, if it had one, according to the local position of the sun (see solar time). This served adequately until the introduction of the steam engine, the telegraph, and rail travel, which made it possible to travel fast enough over long distances to require almost constant re-setting of timepieces, as a train progressed in its daily run through several towns. Standard time, where all clocks in a large region are set to the same time, was established to solve this problem. Chronometers or telegraphy were used to synchronize these clocks.

Standard time, as originally proposed by Sir Sandford Fleming in 1879, divided the world into twenty-four time zones, each one covering exactly 15 degrees of longitude. All clocks within each of these zones would be set to the same time as the others, but differed by one hour from those in the neighbouring zones. The local time at the Royal Greenwich Observatory in Greenwich, England was chosen as standard at the 1884 International Meridian Conference, leading to the widespread use of Greenwich Mean Time in order to set local clocks. This location was chosen because by 1884 two-thirds of all charts and maps already used it as their prime meridian. The conference did not adopt Fleming's time zones because they were outside the purpose for which it was called, to choose a prime meridian. Nevertheless, by 1929 all major countries had adopted standard time zones. Political considerations have now increased the number of standard time zones to 39.

Charles F. Dowd proposed in 1870 (after consulting railroad officials in 1869) that American railroads adopt four standard time zones. After further discussion among themselves, American and Canadian railroads adopted five standard time zones on November 18 1883. Newspapers referred to that day as "the Day of Two Noons." There was no legislative enactment or ruling: the railroads simply adopted a five zone system encompassing North America from Nova Scotia to California, and assumed the public would follow. The American Railway Association, an organization of railroad managers, had noticed growing scientific interest in standardizing time. The ARA devised their own system, which had irregular zone boundaries which followed then-existing boundaries of different lines, partly in order to head off government action which might have been inconvenient to their operations. Most people simply accepted the new time, but a number of cities and counties refused to accept "railroad time", which, after all, had not been made law. In, for example, the expiration of a contract, what does "midnight" mean? In one Iowa Supreme Court case, the owner of a saloon argued that he operated by local (sun) time, not "railroad time," and so he had not violated laws about closing time.Fact|date=February 2008 Standard time remained a local matter until 1918, when it was made law as part of the introduction of daylight saving.

On November 2 1868 New Zealand officially adopted a standard time to be observed nationally, and was perhaps the first country to do so. It was based on the longitude 172° 30' East of Greenwich, that is 11 hours 30 minutes ahead of Greenwich Mean Time. This standard was known as New Zealand Mean Time.


One can measure time based on the rotation of the Earth by observing celestial bodies crossing the meridian every day. Astronomers have preferred observing meridian crossings of stars over observations of the Sun, because these are more accurate. Nowadays, UT in relation to International Atomic Time (TAI) is determined by Very Long Baseline Interferometry (VLBI) observations of distant quasars, a method which has an accuracy of micro-seconds. Most sources of time and celestial coordinate system standards use UT1 as the default meaning of UT, though occasionally UTC may be implied.

The rotation of the Earth and UT are monitored by the International Earth Rotation and Reference Systems Service (IERS). The International Astronomical Union is also involved in setting standards, but the final arbiter of broadcast standards is the International Telecommunication Union or ITU.

The rotation of the Earth is somewhat irregular; also the length of the day very gradually increases due to tidal acceleration. Furthermore, the length of the second is based on its conventional length as determined from observations of the Moon between 1750 and 1890. This also causes the mean solar day, on the average, to now extend longer than the nominal 86,400 SI seconds. As UT is slightly irregular in its rate, astronomers introduced Ephemeris Time, which has since been replaced by Terrestrial Time (TT). However, because Universal Time is synchronous with night and day, and more precise atomic-frequency standards drift away from this, UT is still used to produce a correction called leap seconds to atomic time to obtain a broadcast form of civil time that carries atomic frequency. Thus, civil broadcast standards for time and frequency are a compromise that usually follows, with an offset found from the total of all leap seconds, International Atomic Time (TAI), but occasionally jumps in order to prevent it from drifting too far from mean solar time. Terrestrial Time is TAI + 32.184 s.

Barycentric Dynamical Time (TDB), a form of atomic time, is now used in the construction of the ephemerides of the planets and other solar system objects, for two main reasons. For one thing, these ephemerides are tied to optical and radar observations of planetary motion, and the TDB time scale is fitted so that Newton's laws of motion, with corrections for general relativity, are followed. For another, the time scales based on Earth's rotation are not uniform, so are not suitable for predicting the motion of solar system objects.

In 1928, the term Universal Time was adopted internationally as a more precise term than Greenwich Mean Time, because the GMT could refer to either an astronomical day starting at noon or a civil day starting at midnight. However, the term Greenwich Mean Time persists in common usage to this day in reference to civil timekeeping.


There are several versions of Universal Time:

* UT0 is Universal Time determined at an observatory by observing the diurnal motion of stars or extragalactic radio sources, and also from ranging observations of the Moon and artificial Earth satellites. It is uncorrected for the displacement of Earth's geographic pole from its rotational pole. This displacement, called polar motion, causes the geographic position of any place on Earth to vary by several metres, and different observatories will find a different value for UT0 at the same moment. It is thus not, strictly speaking, Universal.

* UT1 is the principal form of Universal Time. It is computed from the raw observed UT0 by correcting UT0 for the effect of polar motion on the longitude of the observing site. UT1 is the same everywhere on Earth, and is proportional to the true rotation angle of the Earth with respect to a fixed frame of reference. Since the rotational speed of the earth is not uniform, UT1 has an uncertainty of plus or minus 3 milliseconds per day. The ratio of UT1 to mean sidereal time is defined to be 0.997269566329084 − 5.8684×10−11T + 5.9×10−15T², where T is the number of Julian centuries of 36525 days each that have elapsed since JD 2451545.0 (J2000). [Seidelmann, p.52]

* UT1R is a smoothed version of UT1, filtering out periodic variations due to tides. It includes 62 smoothing terms, with periods ranging from 5.6 days to 18.6 years. [ [http://hpiers.obspm.fr/eop-pc/models/UT1/UT1R_tab.html Earth rotation variations due to zonal tides] ]

* UT2 is a smoothed version of UT1, filtering out periodic seasonal variations. It is mostly of historic interest and rarely used anymore. It is defined by the equation::UT2 = UT1 + 0.0220cdotsin(2pi t) - 0.0120cdotcos(2pi t) - 0.0060cdotsin(4pi t) + 0.0070cdotcos(4pi t);mbox{seconds} where "t" is the time as fraction of the Besselian year.

* UT2R is a smoothed version of UT1, incorporating both the seasonal corrections of UT2 and the tidal corrections of UT1R. It is the most smoothed form of Universal Time. Its non-uniformities reveal the unpredictable components of Earth rotation, due to atmospheric weather, plate tectonics, and currents in the interior of the Earth.

* UTC (Coordinated Universal Time) is an atomic timescale that approximates UT1. It is the international standard on which civil time is based. It ticks SI seconds, in step with TAI. It usually has 86400 SI seconds per day, but is kept within 0.9 seconds of UT1 by the introduction of occasional intercalary leap seconds. As of 2007 these leaps have always been positive, with a day of 86401 seconds. When an accuracy better than one second is not required, UTC can be used as an approximation of UT1. The difference between UT1 and UTC is known as DUT1.

* UTC-SLS (UTC with Smoothed Leap Seconds) is a proposed modification of UTC that avoids unequal day lengths. It usually ticks the same as UTC, but modifies the length of the second for the last 1000 UTC seconds of a day containing a leap second so that there are always 86400 seconds in the UTC-SLS day.

* UTS (Smoothed Universal Time) is an obscure form of UT used internally at IERS. The same abbreviation was for a time used to refer to UTC-SLS. [http://www.cl.cam.ac.uk/~mgk25/time/utc-sls/ UTC with Smoothed Leap Seconds (UTC-SLS)] ]

ee also

*Greenwich Mean Time (GMT)
*Sir Sandford Fleming



* cite book
authorlink = Peter Galison | last = Galison | first = Peter
title = Einstein's clocks, Poincaré's maps: Empires of time | location = New York
publisher = W.W. Norton & Company | year = 2003 | isbn = 0-393-02001-0
Discusses the history of time standardization.
* cite book
last = O'Malley | first = Michael
title = Keeping watch: A history of American time | location = Washington
publisher = Smithsonian | year = 1996 | isbn = 1-56098-672-7

* cite book
last = Seidelmann | first = P. Kenneth
title = Explanatory supplement to the Astronomical Almanac | location = Mill Valley, California
publisher = University Science Books | year = 1992 | isbn = 0-935702-68-7

* cite journal
first = Dennis D. | last = McCarthy
url = http://www.cl.cam.ac.uk/~mgk25/volatile/astronomical-time.pdf
title = Astronomical Time | journal = Proceedings of the IEEE
volume = 79 | issue = 7 | month = July | year = 1991 | pages = 915-920

External links

* [http://www.ontarioplaques.com/Plaques_Toronto/Plaque_Toronto32.html Ontario Plaques - The Birthplace of Standard Time]
* [http://www.randomhouse.ca/catalog/display.pperl?isbn=9780676974737 "Time Lord"] by Clark Blaise: a biography of Stanford Fleming and the idea of standard time

Wikimedia Foundation. 2010.

Поможем сделать НИР

Look at other dictionaries:

  • Universal Time — n. Greenwich mean time used as a basis for standard time: cf. COORDINATED UNIVERSAL TIME: abbrev. UT …   English World dictionary

  • universal time — (often caps.) See Greenwich Time. Abbr.: UT. [1885 90] * * * Mean (solar) time of the Greenwich meridian (0° longitude). Universal Time replaced the designation Greenwich Mean Time in 1928; since 1972 it has been based on international atomic… …   Universalium

  • Universal Time — Die Universal Time (UT) ist die durch astronomische Beobachtung gewonnene mittlere Ortszeit des durch die Sternwarte von Greenwich führenden Nullmeridians. Sie ist eine universelle Zeitskala, welche die wahre Erdrotation widerspiegelt. In den… …   Deutsch Wikipedia

  • Universal Time — A measure of time that conforms, within a close approximation, to the mean diurnal rotation of the Earth and serves as the basis of civil timekeeping. Universal Time (UT1) is determined from observations of the stars, radio sources, and also from …   Military dictionary

  • Universal Time — noun A measure of time that conforms, within a close approximation, to the mean diurnal rotation of the Earth and serves as the basis of civil timekeeping. Universal Time (UT1) is determined from observations of the stars, radio sources, and also …   Wiktionary

  • universal time — A measure of time that conforms, within a close approximation, to the mean diurnal rotation of the earth and serves as the basis of civil timekeeping. Universal Time is based on mean sidereal time as measured in Greenwich. It is approximately… …   Aviation dictionary

  • Universal Time — (UT or Z)    the correct name for the time system previously called Greenwich Mean Time (GMT): the standard time at longitude 0°. Universal Time is five hours later than Eastern Standard Time in the U.S. It is always stated on the 24 hour clock;… …   Dictionary of units of measurement

  • universal time — noun the local time at the 0 meridian passing through Greenwich, England; it is the same everywhere • Syn: ↑Greenwich Mean Time, ↑Greenwich Time, ↑GMT, ↑UT, ↑UT1 • Hypernyms: ↑time • Hyponym …   Useful english dictionary

  • Universal Time — /junəvɜsəl ˈtaɪm/ (say yoohnuhversuhl tuym) noun 1. a system of time measurement based on Greenwich Mean Time, but counted from 0 h, which is equivalent to midnight Greenwich Mean Time, introduced in 1928 and used internationally until the… …   Australian-English dictionary

  • universal time — pasaulinis laikas statusas T sritis automatika atitikmenys: angl. universal time vok. Weltzeit, f rus. всемирное время, n; мировое время, n pranc. temps universel, m …   Automatikos terminų žodynas

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”