FCM 36

Infobox Weapon
name=FCM 36


caption=The last surviving FCM 36 in the Musée des Blindés in Saumur
type=Light tank
origin=flagcountry|France
is_vehicle=yes
service=
used_by=
wars=
designer=
design_date=1933 - 1936
manufacturer= Forges et Chantiers de la Méditerranée
unit_cost=₣ 450,000
production_date= 1938 - 1939
number= 100
variants=
weight= 12.35 metric tons
length= 4.46 m
width= 2.14 m
height= 2.20 m
crew=2 (commander, driver)
armour= 40 mm
primary_armament= 37 mm L/21 gun
secondary_armament=7.5 mm coaxial machine gun
engine=V-4 Berliet diesel
engine_power= 91 hp ( kW)
transmission= 5 forward, 1 reverse
fuel_capacity=217 litres
pw_ratio= 7.36 hp/ton
suspension=vertical coil spring
clearance= 0.36 m
vehicle_range= 225 km
speed= 24 km/h

The FCM 36 or "Char léger Modèle 1936 FCM", was a light infantry tank that was designed for the French Army prior to World War II. It had a crew of two and was equipped with a short 37 mm main armament and a 7.5 mm coaxial machine gun. Power was provided by a diesel engine.

Development

In 1933 the Hotchkiss company proposed to build a cheap mass produced light infantry tank. In reaction to this proposal the French Army invited the whole of French industry to offer alternative designs. In the end three of the competing prototypes would be taken into production: the Hotchkiss H35, the Renault R35 and the FCM 36.

The "Forges et Chantiers de la Méditerranée" (FCM), located at Toulon, had some previous experience with tank production as it had constructed the ten giant Char 2C tanks in 1921 and had been involved in the development of the Char B1. Engineer Boudrot, who had designed the suspension of the Char B, was ordered to create a modern tank design taking full advantage of the large electro-welding capacity of the warf. In March 1934 he presented a wooden mock-up that was approved by the Army. On 2 April 1935 the prototype was delivered to the "Commission de Vincennes", with a turret equipped with two machine-guns. The commission was quite impressed by the vehicle, especially because of its welded sloped armour and the use of a diesel engine promising a good range. It was a bit heavier than the specified nine metric tons at 10,168 kilogrammes. However the prototype was untestable because of mechanical problems. After the first evaluation had been finished on 9 June it was sent back to the manufacturer.

In fact FCM hadn't tested the prototype itself yet; this was now done and many shortcomings became apparent. As a result the vehicle was completely redesigned with a new and lighter hull and turret configuration, suspension and track. The roof of the engine compartment was now bolted on to ease replacement. On 10 September it was again sent to Vincennes only to be sent back on 23 October to have its suspension reinforced. On 19 December it returned to be tested until 14 May 1936. It was then approved on the provision that the armour would be thickened from 30 to 40 mm, according to the new specifications. This was done by welding an appliqué 10 mm armour plate on top of the main armour; a feature maintained for the production vehicles. The prototype was now brought to the attention of the "Commission d'Infanterie", who declared on 9 July that it was the best of all competitors, especially since it had been proven on 17 June to be completely gas-proof, a unique quality that was considered a very desirable feature at the time.

Production

Even before the type had been approved however, because of the Rhineland crisis on 26 May hastily an order was made for 100 vehicles of the "Char léger Modèle 1936 FCM" for 450,000 FRF a piece. The production vehicles had to be equipped with a 37 mm gun. The Hotchkiss H35 and Renault R35 would also be taken into production, and as these competing types were a lot cheaper they would constitute the bulk of the French light infantry tanks produced. The reason to coproduce the more expensive third type was its development potential. The FCM 36 was seen as the most advanced French tank and should function as a testbed for further improvements. This also meant there was no hurry to start series production. The production facilities only began to be prepared from December 1936 and actual manufacture was delayed for a year to first test a newer design with a stronger engine and a lighter track. Only when this didn't render the expected results, the original type was produced with the first delivery on 2 May 1938. During 1938 and 1939 several modifations were tested on vehicle number 30,057 including a new track, clutch and engine, but none of these would be applied on the existing vehicles.

On 12 May 1938 and 3 February 1939 two additional orders were made of a hundred each. However when the last tank, series number 30,100, of the original order was delivered on 13 March 1939, FCM suddenly announced that it would permanently cease production unless the price was raised to at least 900,000 FF, apparently the actual cost of production. Also FCM indicated that given its increased demanded production quota of the Char B1, there simply would be no capacity to manufacture any FCM 36s before September 1940. In view of these circumstances Inspector-General Jacomet allowed the production of the hull to be discontinued. The FCM turret however had already been planned to become the standard for all light tanks, as the old standard APX R in the beginning suffered from serious production delays; when these eased an earlier proposal to have it replaced after number 1350 was postponed; but it was still considered to cease production after number 2000 as the APX R was heavier (1,552 to 1,287 kg) and yet inferior in protection to the FCM turret because of constant quality problems with its cast steel that was either too soft or too brittle. However, this issue was complicated by the planned introduction of the longer 37 mm gun as tests showed that the welds of the FCM type had to be reinforced to prevent them from cracking by the stronger recoil; as a result the existing vehicles would not be fitted with the new gun.

Description

The FMC 36 is a small vehicle, 4.46 m long, 2.20 m high and 2.14 m wide, with a crew of two. It has a weight of 12.35 metric tons. The most conspicuous feature of the tank is the futuristic pyramidical shape of its armour, consisting of many panels, electro-welded together to avoid shot-traps and fully implement the principle of sloped armour. Only the engine deck is bolted on to provide easier access. Even the upper track run and the suspension units are protected by zig-zag armour plates. As the armour is of good quality, the 40 mm thickness angled at 30 to 45 degrees from the vertical, renders an equivalence of about 45-55 mm, enough to defeat the standard anti-tank guns of its day, even when the gun was ideally positioned. The reclining armour implied that more raking shots would quickly start to deflect. The other modern feature, the diesel engine, gives the vehicle a range of 225 kilometers from a fuel tank of 217 litres.

In some ways the tank is more oldfashioned. The V-4 91 hp Berliet diesel allows for a top speed of just 24 km/h. The suspension is accordingly simplistic, consisting of eight roadwheels per side sprung by eight vertical coil springs. The tank can cross a two metres trench and climb a 70 cm obstacle or a 80% slope. Also very limited is the armament: apart from the 7.5 mm Châtellerault MAC31 machine gun, the standard short L/21 37 mm SA 18 gun is fitted with very poor anti-armour capacity.

Operational History

As very few FMCM 36s were to be produced, only a limited number of units would be equipped with the type. However these would happen to participate in the key event of 1940 during the Battle of France: the crossing of the Meuse river, by XIX Army Corps of Heinz Guderian on 14 May 1940.

In March and April 1939 two battalions were created. Unique among those battalions equipped with light infantry tanks, these units would be called "Bataillon de Chars Légèrs" or BCLs: the "4e" and "7e BCL", that each received 45 FCM 36's. They had an organic strength of 39 (three companies of thirteen), a materiel company of six and used five tanks for driver's training. Of the other ten tanks, eight were used for driver training, one was destroyed testing the efficiency of the German Teller mine, and one remained with the factory to serve as a test bed. On 25 August 1939, upon mobilisation, the BCLs were renamed "Bataillons de Chars de Combat" The 7e BCC was incorporated into the "503e Régiment de Chars de Combat", the 4e BCC into the 502e RCC.

After war was declared against Germany in September 1939, both FCM 36 battalions were combined, together with 3e BCC, a R 35 unit, into the "503e Groupement de Bataillons de Chars", the armour reserve of the Second Army. When German infantry on 13 May 1940 established a bridgehead over the Meuse at Sedan, the FCM 36 battalions were late in the afternoon ordered to counterattack and reduce it, cooperating with an infantry regiment, as they themselves had no organic infantry component. Due to the rout of the last French defence line at Bulson during the night and the ensuing confusion, the approach march could only begin early in the morning of the 14th, when the first German tanks started to cross the river on pontoon bridges. The German armoured vanguard and 7e BCC collided near Bulson. The French tanks destroyed some lighter German armoured fighting vehicles, but their weak guns were insufficient to deal with the Panzerkampfwagen III, armoured with 30 mm plate, though the latter had likewise trouble in penetrating the FCM 36 armour, as the tungsten core APCR round was not yet made available. Both sides slugged it out, often engaging at the shortest possible distance. In the end the applique armour of the FCM 36 failed and the welds, being weaker points between the plates, were penetrated. The 7e BCC had to withdraw, leaving 26 of the 36 employed tanks behind.

When 7e BCC had failed, the attack by 4e BCC was halted. The battalion attacked and defended Stonne on 15 May, but was driven from this key position with some losses. Until 23 May it would be attached to 3 DIM.

Both battalions were now kept in reserve to rebuild their numbers from the matériel and training units. During Fall Rot they executed successful counterattacks on 9 and 10 June on the Aisne position, against German infantry units. Later they tried to cover the retreat of the French Army, losing most of their combined strength of 45 in fights with German tanks.

German use

The Germans captured 37 FCM 36s, using the administrative designation "Panzerkampfwagen 737 FCM (f)" for them. After some improvised use by units in May and June 1940, they were not as such employed by them. In 1943 ten were rebuilt as Marder I tank destroyers, which were employed by 21 "Panzerdivision" in the Battle of Normandy in 1944. Twelve were in 1942 rebuilt as self-propelled artillery, the "10.5cm leFH 16/18(Sf) auf Geschuetzwagen FCM (f)".

One FCM 36 survives at the Musée des Blindés at Saumur.

Further reading

* Leland Ness (2002) "Jane's World War II Tanks and Fighting Vehicles: The Complete Guide", Harper Collins, London and New York, ISBN 0-00-711228-9
*Pascal Danjou, 2007, "FCM 36", Editions du Barbotin, Ballainvilliers

External links

* [http://www.chars-francais.net/archives/fcm36.htm Chars-francais.net]