Design for manufacturability (IC)

For a general explanation outside the integrated circuit topic, see Design for manufacturability (disambiguation).

Achieving high-yielding designs in the state of the art, VLSI technology has become an extremely challenging task due to the miniaturization as well as the complexity of leading-edge products. The design methodology called design for manufacturability (DFM) includes a set of techniques to modify the design of integrated circuits (IC) in order to make them more manufacturable, i.e., to improve their functional yield, parametric yield, or their reliability.

History

Traditionally, in the prenanometer era, DFM consisted of a set of different methodologies trying to enforce some soft (recommended) design rules regarding the shapes and polygons of the physical layout of an integrated circuit. These DFM methodologies worked primarily at the full chip level. Additionally, worst-case simulations at different levels of abstraction were applied to minimize the impact of process variations on performance and other types of parametric yield loss. All these different types of worst-case simulations were essentially based on a base set of worst-case (or corner) SPICE device parameter files that were intended to represent the variability of transistor performance over the full range of variation in a fabrication process.

Taxonomy of yield loss mechanisms

The most important yield loss models (YLMs) for VLSI ICs can be classified into several categories based on their nature.

• Functional yield loss is still the dominant factor and is caused by mechanisms such as misprocessing (e.g., equipment-related problems), systematic effects such as printability or planarization problems, and purely random defects.
• High-performance products may exhibit parametric design marginalities caused by either process fluctuations or environmental factors (such as supply voltage or temperature).
• The test-related yield losses, which are caused by incorrect testing, can also play a significant role.

Design for manufacturability

After understanding the causes of yield loss, the next step is to make the design as resistant as possible. Techniques used for this include:

• Substituting higher yield cells where permitted by timing, power, and routability.
• Changing the spacing and width of the interconnect wires, where possible
• Optimizing the amount of redundancy in internal memories.
• Substituting fault tolerant (redundant) vias in a design where possible

All of these require a detailed understanding of yield loss mechanisms, since these changes trade off against one another. For example, introducing redundant vias will reduce the chance of via problems, but increase the chance of unwanted shorts. Whether this is good idea, therefore, depends on the details of the yield loss models and the characteristics of the particular design.

See also

• Electronic design automation
• Critical area
• Reliability engineering
• Six Sigma
• Statistical process control
• ISQED

References

• Electronic Design Automation For Integrated Circuits Handbook, by Lavagno, Martin, and Scheffer, ISBN 0-8493-3096-3 A survey of the field of EDA. The above summary was derived, with permission, from Volume II, Chapter 19, Design for Manufacturability in the Nanometer Era, by Nicola Dragone, Carlo Guardiani, and Andrzej J. Strojwas.
• Design for Manufacturability And Statistical Design: A Constructive Approach, by Michael Orshansky, Sani Nassif, Duane Boning ISBN 0387309284
• Estimating Space ASICs Using SEER-IC/H, by Robert Cisneros, Tecolote Research, Inc. (2008) Complete Presentation