Go/no go

In general go/no go testing refers to a pass/fail test (or check) principle utilizing two boundary conditions.The test is passed only when both the "Go" condition is be met and the "No go" condition fails.

The test gives no information as to the degree of conformance to, or deviation from the boundary conditions.This means the test isn't useful in statistical process control.

In engineering the test is traditionally used only to check noncritical parameters where the manufacturing process is believed to be stable and well-controlled, and the tolerances are wide compared to the distribution of the parameter.For example, the preceding checks before a space shuttle liftoff have the flight controller performing a go/no go check on each of the vehicle's critical systems.

In psychology Go/No-go tests are used to measure a participants capacity for sustained attention and response control.For example, a go/no-go test that requires a participant to perform an action given certain stimuli (e.g., press a button - Go) and inhibit that action under a different set of stimuli (e.g., not press that same button - No-Go).

Go/no go gauges

Go/no go gauges are encountered in all types of manufacturing. They may measure a physical dimension, e.g. (50 ±0.01mm), or a value such as the value of a resistor (100Ω (ohms) ±1%).A typical example is a plug gauge.

A typical gauge used when making tennis balls would have two holes, one slightly larger than the other. A manufactured object passes the go/no go test if it goes through the large hole but does not go through the smaller hole; the object fails if it passes through the smaller hole, or does not pass through the large hole.

Sometimes a go/no go gauge is male and the object being tested is female.