Cylinder bank

Cylinder bank
Napier Lion W or broad arrow layout with three banks
A Zvezda M503 radial engine with inline banks

Internal combustion piston engines (those with more than one cylinder) are usually arranged so that the cylinders are in lines parallel to the crankshaft. Where they are in a single line, this is referred to as an inline or straight engine.

Where engines have a large number of cylinders, the cylinders are commonly arranged in two lines, placed at an angle to each other as a vee engine. Each line is referred to as a cylinder bank. The angle between cylinder banks is described as the bank angle.

Engines with six cylinders are equally common as either straight or vee engine. With more cylinders than this, the vee configuration is more common. Fewer cylinders are more usually arranged as an inline engine. There are exceptions to this: straight-8 engines were found on some pre-war luxury cars with the bonnet length to house them. A few V4 engines have also been produced, usually where an extra-compact engine was required, including some outboard motors with a vertical crankshaft. Although twin cylinder engines are now rare for cars, they are still commonly used for motorcycles and the vee-twin and inline twin are both widely used.

An obvious advantage to a multi-bank engine is that it can be shorter in length. This allows a torsionally stiffer construction for both the crankshaft and crankcase. The most important advantage though is less obvious: a multi-plane engine can be arranged to have better balance and less vibration. This depends on the layout of the crankshaft more than the cylinder banks alone: the planes on which the pistons are arranged, thus their timing and vibration, depend on both the cylinder bank and the crankshaft angles.

Unusual arrangements

The W or broad arrow arrangement uses three cylinder banks, usually a W-12 with three banks of four cylinders.

Narrow-angle vee engines, such as the Lancia V4 and the Volkswagen VR6, have such a narrow bank angle that their cylinders are combined into a single cylinder block. These are still described as vee engines, although they may be described as having either two (as for other engines) or (more commonly in these cases) one cylinder bank.

Radial engines

In a radial engine, cylinders are arranged radially in a circle. Simple radials use one row (i.e. one circle) of cylinders. Larger radials use two rows, or even four. Most radials are air-cooled with separate cylinders and so there are no banks as such. Most radials also have odd numbers of cylinders in each row and stagger these between successive rows, for better cooling.

A few rare radial engines, such as the Armstrong Siddeley Deerhound[1] and the Zvezda M503 (illustrated) have arranged their multiple rows so as to align their cylinders into banks.

References

  1. ^ Gunston, Bill. World Encyclopedia of Aero Engines. Cambridge, England. Patrick Stephens Limited, 1989. ISBN 1-85260-163-9

Wikimedia Foundation. 2010.

Игры ⚽ Поможем сделать НИР

Look at other dictionaries:

  • cylinder bank — One half of a V 6, V 8, V 12, and V 16 engines along one side …   Dictionary of automotive terms

  • Cylinder block — A modern passenger car engine block, integrating the crankcase and all cylinders. The cylinder head bolts to the deck surface at top. Many ribs and bosses can be seen on the side of the casting. This block is for a straight six engine …   Wikipedia

  • Cylinder head — A 302/5.0L Ford cylinder head In an internal combustion engine, the cylinder head (often informally abbreviated to just head) sits above the cylinders on top of the cylinder block. It closes in the top of the cylinder, forming the combustion… …   Wikipedia

  • Bank (disambiguation) — A bank is a financial institution.Bank may also refer to:In natural geography: * Bank (sea floor), a shallow area in a body of water **Georges Bank, near the US state of Massachusetts **Grand Banks, off the coast of Newfoundland **Great Chagos… …   Wikipedia

  • bank — See cylinder bank …   Dictionary of automotive terms

  • cylinder numbering — In aircraft reciprocating engines, except rotary engines, the propeller shaft end of the engine is always the front end, and the accessory end is the rear end, irrespective of how the engine is mounted. An engine is referred to as right or left… …   Aviation dictionary

  • Cylinder (engine) — Illustration of an engine cylinder with a cross section view of the piston, connecting rod, valves and spark plug. A cylinder is the central working part of a reciprocating engine or pump, the space in which a piston travels. Multiple cylinders… …   Wikipedia

  • cylinder block — The main casing of a bank of cylinders in an in line internal combustion engine. It is a single unit enclosing a row of liquid cooled in line cylinders and other internal parts …   Aviation dictionary

  • Variable Cylinder Management — (VCM) is Honda s term for a variable displacement technology. It uses the i VTEC system to disable one bank of cylinders during specific driving conditions (for example, highway driving) to save fuel. The 2008 Accord takes this a step further… …   Wikipedia

  • Active Cylinder Control — Daimler AG s Active Cylinder Control (ACC) is a variable displacement technology. It debuted in 2001 on the 5.8 L V12 in the CL600 and S600. Like Chrysler s later Multi Displacement System, General Motors Active Fuel Management and Honda s… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”